挤压

The results indicated that the resistant starch formed during extrusion resulted in the problems of iodine reactions of worts containing extruded rice.

提出挤压膨化时形成的抗消化淀粉，应是造成挤压膨化大米啤酒辅料糖化醪的碘反应出现问题的原因。

The enterprise wons two advanced WHYH-1000WF oxidize porcelain and ceramics equipments production line, 1 the series hot mold extruding production line(one ton main frequeney induetion furnace is a set of ,one ton middle induction furnace 2 sets of, 800 ton extruder one set of ) and perfect kits analyze, examinaton equipments ect.

企业拥有先进的WHYH—100WF氧化陶瓷设备生产线2条，连铸热塑挤压生产线1条（1吨工频电炉1套、1吨中频电炉2套，800吨挤压机1套）以及完善配套的化验、检测设备等。

Of the five stages deformation, the exact ages of the (2) and (3) were determined by 40Ar/39Ar method as 290 and 259 Ma respectively.2. New results on the metamorphic belts and associated metamorphism of the Xiaopu metamorphic rocksBased on detailed microtextural observations and occurrence of typical metamorphic minerals, five metamorphic belts in the Xiaopu metamorphic rocks are identified. From the north to the south, they are biotite belt, garnet belt, staurolite belt, andalusite belt, and sillimanite belt. I suggested that the metamorphic belts occurred in the Xiaopu area belongs to the high temperature/low pressure series, may have resulted from the later Permian crust extension at ca. 290 Ma.3. I suggest that there may have been a Carboniferous backarc basin along the southern slope of the Harlik Mountain.Detrital Zircon SHRIMP U-Pb dating indicated that the sedimentary age of the Julideneng formation lithic sandstone must be later than late Devonian, most likely is Carboniferous rather than previously thought Precambrian. Analyses on its geologic setting, location of provenance, and sedimentary environment suggest the Carboniferous strata may form in a lagged backarc basin bounded by backarc uplifts.5. Reconstruction of the post-Paleozoic tectonic evolution history of the Harlik MountainThe tectonic evolution of Harlik mountains since the Paleozoic were reconstructed as followings:(1) arc-affinity magmative activities occurred during the middle-Ordovician to early-Silurian;(2) the middle-Silurian to late-Devonian was a back-arc uplift stage;(3) back-arc extension featured the Carboniferous period;(4) post-collisional extension and/then compression during Permian;(5) at the Mesozoic, differential uplift developed; and (6) the late Cenozoic is the intra-continental re-orogen stage.6. Primary estimation of the crust shortening is madeThe folded pre-Mesozoic strata were used to estimate crust shortening along the Harliknanshankou-Koumenzi, Shichengzi-Baishitou, and Qincheng-Xiaopu sections. Their shortening ratios are 16.2%, 19.8%, and 20.1% respectively corresponding crust shortening are 4.3, 9, and 11.3 km.

根据Ar-Ar热年代学研究，精确测定了早二叠世伸展变形和晚二叠世挤压变形的峰期时代分别为290Ma和259Ma.2、提出了关于哈尔里克山南麓小铺一带变质带和变质作用的新认识根据显微观察资料和特征变质矿物的出现，把小铺一带的变质岩由SW向NE方向依次划分为黑云母带、石榴石带、十字石带、红柱石带和矽线石带等变质带；初步确定该区的变质作用属于中温-低压型，变质作用发生的时代为290Ma左右，是该区早二叠世地壳伸展的产物。3、首次提出哈尔里克山南麓在石炭纪可能发育弧后盆地的新观点根据哈尔里克山南麓原&居里得能组&岩屑砂岩的碎屑锆石SHRIMP U-Pb定年，确认这套地层的沉积不早于晚泥盆世，很可能是石炭纪，而不是前人所说的前寒武纪；结合对其区域地质背景、源区位置和沉积环境分析，推测该区石炭纪可能为滞后弧后盆地和弧后隆起区构造背景。4、进一步证明哈尔里克山不发育与岛弧演化相关的泥盆纪岩浆活动根据对代表性闪长岩和花岗岩的锆石SHRIMP年代学研究获得的新资料，结合该区已有相关资料的综合研究，确定哈尔里克山岩浆岩分别形成于奥陶纪-志留纪和石炭纪晚期-二叠纪，不存在泥盆纪的岩浆岩，进而认为该区泥盆纪不属于岛弧环境。5、重建了哈尔里克山古生代以来的地质演化过程根据区域资料以及本次研究所获得的资料，把哈尔里克山古生代以来的构造演化划分中奥陶世-早志留世为岛弧、中志留世-晚泥盆世为弧后区、石炭纪弧后伸展、二叠纪为后碰撞伸展与挤压、中生代差异隆升和晚新生代陆内再造山过程等构造阶段。6、初步估算了哈尔里克山地壳缩短率和缩短量根据前中生代地层褶皱估算的哈尔里克山南山口-口门子、石城子-白石头和沁城-小铺三条剖面的地壳缩短率分别为16.2%、19.8%和20.1%，相应的地壳缩短量分别为4.3km、9km和11.3km。

From factorial experiments, it was observed that in conventional extrusion treatment, defatted soy flour, aqueous acidic leached soy protein concentrate and soy protein isolate was able to be texturized, whereas SPC was not.

通过挤压实验可知，在常规的挤压条件下，低温粕、酸法SPC和大豆分离蛋白均可实现组织化，而醇法SPC无法实现有效的组织化。

These develop from the gentle flexural undulations of earlier stages, which start to be visibly amplified by 3km shortening, and form quite strong peripheral anticlines and synclines by 8km shortening, decaying away from the fault.

这些褶皱是从早期轻微的挠曲起伏演化而来的，到挤压位移3km时，它们开始明显增强，到挤压位移8km时，已经形成非常大的背斜和向斜，其幅度从断层向两侧逐渐减小。

A Design of PMD emulator made of polarization controller using fiber squeezers is proposed in this thesis, which consists of two polarization controllers using fiber squeezers and two segments of high birefringence fibers, and is controlled by a micro-controller unit.

本文提出了一种利用光纤挤压式偏振控制器构成的 PMD 模拟器的设计方案，它由两个光纤挤压式偏振控制器和两段高双折射光纤组成，通过单片机进行控制。

The polarization controller using fiber squeezers is improved under prevenient groundworks. Restoration units are cancelled, so that the squeezers are decreased from five to three. Half-wave voltage reaches 15V.

论文在前期研究工作的基础上对光纤挤压式偏振控制器进行了改进，取消了复位单元，使挤压器从五个减为三个，半波电压达到 15V。

With the extruder moved away from the threaded substrate coating line, the extrusion condition are lined out and the die lip adjustments made to give a uniform melt at the desired output rate, die lip opening and melt temperature.

随着挤压机移离螺纹基片涂装生产线，就能达到挤压条件，模具口的调整能在理想产出率的上提供一个统一的熔体，即模具口开放和熔体温度。

In compressed uplifting phase, basin uplifted beacuse of compression,and norrnal fault became overthrust one, with weak folding.

吐哈盆地HYS构造从晚中生代至新生代经历了拉张伸展期、挤压抬升期、伸展拗陷期和强烈挤压褶皱期等演化阶段。

In this paper, W-Cu alloys with different percentage composition of Cu have been obtained by hot extrusion.

通过对不同铜含量（Cu质量分数20%~50%）的W-Cu混合粉末进行热挤压，获得了具有不同成分配比的W-Cu合金，并研究了铜含量对热挤压坯料组织和性能的影响。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。