指令地址

The information given in c and c, we obtained the absolute address of the current instruction.

这样通过两者结合，我们可以得到当前指令的绝对地址。

The assembler must defer translating this instruction until the address of done has been determined.

汇编必须推迟翻译这一指令，直到done的地址被确定出来。

When using R15 as the base register you must remember it contains an address 8 bytes on from the address of the current instruction.

当使用为基础R15 登记你必须记住，它包含了从当前指令的地址地址8个字节。

In the first step, the CPU fetches the instruction byte from memory. To do this, it copies the value of the ip register to the address bus and reads the byte at that address. This will take one clock cycle.

第一步里，CPU从内存取得字节指令，为了做这些，它拷贝IP的值到地址总线并读取在那个地址的字节，这将花费一个时钟周期。

Direct Correspondence of Display Data RAM to LCD Pixel Display Data RAM2,500 bits LCD Drivers25-common and 100-segment Selectable Duty and Bias Ratio ; 1/25 Duty 1/6 Bias or 1/15 Duty 1/5 Bias Direct connection to 8-bit Microprocessor interface for both of 68 and 80 type MPU Serial Interface (SI, SCL, A0, CS) Useful instruction set Display ON/OFF, Display Start Line Set, Page Address Set, Column Address Set, Status Read, Write Display Data, Read Display Data, Normal or Inverse ON/OFF Set, Static Drive ON/Normal Display, EVR Register Set, Read Modify Write, End, Reset, Internal Power Supply ON/OFF, Driver Output ON/OFF, Power Save and ADC select.

直接显示数据RAM的对应像素液晶显示数据RAM2，500位液晶Drivers25，共同和100段可选择的职务和偏差率； 1 / 25的责任1 / 6的偏见或1 / 15的责任1 / 5偏见的直接连接至8位微处理器的接口为68和80型微控制器的串行接口（司，沙田至中环线时，A0，CS）的相关指令集显示开/关，显示开始行设置，页面地址设置，列地址设置，状态读取，写入显示数据，读取数据显示，正常或逆开/关设置，静态驱动器/正常显示，腔内注册设置，读取修改写入，完，复位，内部电源开/关，开/关，节能和ADC选择驱动器输出。

This instruction contains an address specified by a 16-bit offset; it loads a 48-bit far pointer from that (16-bit segment and 32-bit offset), and calls that address.

这条指令包含一个16位偏移地址，从它载入了一个48位的远指针(16位段和32位段偏移)，然后调用这个地址。

A Read Data from Memory instruction loads the address of the first byte or word to be read in an internal address register.

从存储器指令加载的第一个字节或字地址读取数据被读在内部地址寄存器。

There are several types of registers ,Including an instruction register , which holds the instruction being executed ,an address register, which holds the addresses of data to be processed ;a program register , which holds status information ; and an accumulator , which holds the results of the ALU's

寄存器有几种类型，包括指令寄存器，它含有将要被执行的指示，地址寄存器，它包含被处理的数据地址；程序寄存器，它包含程序的状态信息；还有累加器，它包含算术\逻辑运算单元的操作结果。

The first 2 bytes are occupied by the call instruction itself, and 4 bytes that follow are occupied by the operand - they hold the address of the variable that contains the address of ProxyEpilog.

前2个字节占用调用指令本身，后面4个字节被占领的操作-它们掌握的变量，它包含ProxyEpilog地址地址。

Uniprocessor designs have built-in bottlenecks.the address and data buses restrict data transfers to a one-at-a-time flow of traffic.the program counter forces instructions to be run in strict sequence.even if improvements in performance are achieved by means of faster processors and more instruction parallelism,operations are still run in strict sequence.however,in a uniprocessor,an increase in processor speed is not the total answer because other factors,such as the system bus and memory,come into play.

单处理器设计有内置的一些瓶颈。地址和数据总线限制数据传输的同时同地址的数据冲突情况。即使是通过更快的处理器和更多的并行指令，当然也包括维护，这些方式来提高的性能，程序的运行仍然被限制在严格的程式规则中。然而，在一个单处理器里，处理器速度的提高时不能完全解决这个问题的，这是因为像系统总线和存储器等其他因素同样在起作用。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。