拼梁

For the steel truss girder with abroad \\\"bridge crane bar assembled Law,\\\" the level of technology and equipment as a result of the limited duration of its long, far from being able to meet China\\\s bridge construction project as requested in the analysis of large-span suspension bridge mountain girder erection difficulties under the premise that after the election raised more than Aizhai Bridge \\\"self-cross-cable crane swing shift\\\" program to set up the main truss, which is mountainous suspension bridge girder erecting another major innovation.

对于钢桁梁，用国外的"桥面吊机杆件拼装法"，由于工艺和设备水平所限其工期长，远不能满足中国桥梁建设工期的要求，在分析山区大跨悬索桥主梁架设困难的前提下，经过多方案比选提出矮寨大桥"自行式跨缆吊机荡移"架设主桁方案，这是山区悬索桥主梁架设的又一个重大的创新。

Suspensorily joined structure has the virtue that the construction progress is normally fast and does not hinder the traffic underbridge because Travelling Carriage is not used,but requiring comparatively large construction plant, high complexity in seam assembling, lower structural integrity compared to the suspensorilyplaced are its faults.

预应力混凝土T型刚构加挂梁结构是公路桥梁常用的一种桥梁结构型式，这种桥型根据施工方法的不同可分为悬浇和悬拼，悬浇结构需采用挂篮施工，优点是结构无干接缝，整体性好，刚度大，施工占用场地少，缺点是施工期间挂篮将影响桥下的通航通车，施工周期长；悬拼结构的优点是无需采用挂篮施工施工进度快，对桥下的通航通车影响较小，缺点是需占用较大的施工预制场地，拼装接缝处理难度大，结构整体性较悬浇差。

It is important for us to make the theoretical calculation of precamber and deflection and obtain manufacture elevation and construction elevation of each girder segment, according to design drawings, construction management plan and prefabricating geometry, at the same time, in the light of different kinds of calculating parameters.

所以对采用悬臂拼装的连续梁桥来讲，在预制梁段阶段对台座的标高进行精确的测量，正确计算桥梁线形高程，根据设计图、施工组织设计以及预制线形，按照各种计算参数，进行预拱度及挠度的理论计算，得到各节梁段制造与施工安装高程非常重要。

In this paper, Shenyang Fumin Bridge main girder to carry out innovative design of the traveling carriage, Based on the similar design of traveling carriage , adopted under the former anchor beam arc settings to resolve the fate of the plane rotation problem , makes the main truss rod assembly by universal application of the cradle of the space cable plane cable-stayed bridge girder construction.

摘 要：本文对沈阳市富民桥主梁的施工挂篮进行创新设计，参考同类挂篮的成功设计思路的基础上，通过将前锚梁下缘设置弧形来解决索的平面转动问题，使得主桁由万能杆件拼装的挂篮应用于空间索面的斜拉桥主梁施工中。

For the steel truss girder with abroad \\\"bridge crane bar assembled Law,\\\" the level of technology and equipment as a result of the limited duration of its long, far from being able to meet China\\\s bridge construction project as requested in the analysis of large-span suspension bridge mountain girder erection difficulties under the premise that after the election raised more than Aizhai Bridge \\\"self-cross-cable crane swing shift\\\" program to set up the main truss, which is mountainous suspension bridge girder erecting another major innovation.

对于钢桁梁，用国外的&桥面吊机杆件拼装法&，由于工艺和设备水平所限其工期长，远不能满足中国桥梁建设工期的要求，在分析山区大跨悬索桥主梁架设困难的前提下，经过多方案比选提出矮寨大桥&自行式跨缆吊机荡移&架设主桁方案，这是山区悬索桥主梁架设的又一个重大的创新。

For beams employed in any span between supports there shall be no splice in the middle one-fourth of the span nor in the one-eighth of the span nearest any support, nor closer than 1200 mm to the edge of any support/joint, as applicable.

在任何支撑点的跨距内使用的梁，在跨距中间的四分之一位置上，不得有拼接口，在靠近支撑的八分之一跨距位置上，不得有拼接口。在应用上，接口与支撑/接头边缘的距离不得小于

The overpass at You'ai Road in Nanning is located at the traffic junction of the city, congested as it is and the prestressed concrete continuous box girder of the main bridge with in-situ scaffold construction can not meet the traffic needs The adoption of box girder in-situ scaffold combined with Bailey truss and universal rod, which is of long span, large rigidity and little deformation, meets the traffic needs Meanwhile the rapid combination of scaffold overcomes the shortcomings of high scaffold and ...

根据南宁市友爱路立交桥位于城市交通咽喉，车辆拥挤，主桥预应力砼连续箱梁现浇支架施工难以解决交通需求的矛盾，采用了贝雷桁架与万能杆件组合拼装箱梁现浇支架，该支架跨度大、刚度大、变形少，不仅解决了交通需要，而且支架拼装速度快，同时也解决了支架高、稳定性差的缺点。这一施工技术可在日益发展的城市立交桥施工中得到广泛使用。

The development of travelling trestle bridge fabrication machine in China was reviewed. Bridge fabrication machines were classified according to PC box girder's position in travelling trestle. A comparison was made between two construction methods: precast girder assembly method and cast\|in\|situ method.

我国移动支架造桥技术的进展预应力混凝土梁的施工有架桥机架设、顶推架设、悬臂灌筑、悬臂拼装、造桥机造梁等几种方法，各有其适用范围，而采用造桥机架梁系墩顶原位造梁，跨度、墩高适用范围广，不影响桥下交通，梁施工时的状态与运营工况一致，且省工省料，建造速度快，梁既可工厂化分节预制，也可在模架上整孔现浇。

Combined with practical work,from technological process,erection of consolidation platform and incremental launching platform ,fabrication and installation of slide rail,field assembly of steel box beam and other aspects incremental launching construction technology of steel box beam is introduced in order to provide references for similar works.

结合工程概况，从顶推施工工艺流程、钢箱梁拼装平台及顶推平台搭设、滑道制作安装、钢箱梁现场拼装、钢梁顶推及落梁等方面介绍了主桥钢箱梁的顶推施工技术，以供类似工程参考借鉴。

With the increasing of long span prestressed concrete bridge adopting cantilever erection construction method, more and more attention are paid to the correlative geometry control theory and practice of long span continuous box girder.

随着采用悬臂拼装施工的大跨度预应力混凝土梁桥的不断增多，与其相关的大跨度连续箱梁悬臂拼装施工线形控制理论和实践日益受到关注。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。