拧

Multi-Axial Crosslink Plate, the midline screw is tightened using SW5.5 Wrench (11302017)after the

如果使用活动横联装置，拧紧两边的横连顶丝后再用SW5.5扳手

After the gauge has been inserted and adjusted, the thumb screw is tightened and the tool removed for measurement of mismatch.

插入该测量仪并进行调整，拧紧翼形螺钉，然后取出该工具以测量偏移率。

Unscrew the adjustment screw ring, stretching from the exposed screw people like a thin tool bar, you can toggle adjustment ring on the teeth, so that adjustment ring turning left.

拧下调节圈固定螺钉，从露出的螺孔伸人一根细铁棍之类的工具，即可拨动调节圈上的轮齿，使调节圈左右转动。

Use hexagonal spanner to screw the screw off, and take out the used and scrap cutting knife.

用六角扳手拧开螺丝，取出废旧裁切刀。

Torque spanner used to screw big high-tension hexagonal bolt and testing should be receive torque adjusting before and after application.

高强度大六角头螺栓施拧采用扭矩扳手和检查采用的扭矩扳手在班前和班后均应进行扭矩校正。

I think the fun has also followed her mother into the kitchen to help his mother screw shrimp shell.

我觉得好玩也跟着妈妈走进厨房帮妈妈拧虾壳。

Mother to get into the kitchen to prepare shrimp, shrimp shell screw.

妈妈把虾拿进厨房准备拧虾壳。

Pumps installed in the rolling bearing for the motor, bearings should be removed outside the cover, and then release the fastening screw cover and base shell and cover the seams to do a good job marking (both before and after the end of tag should not be covered the same), will cover the unloading of the fastening screw screwed into the expertise of the Motor Cover Screw in the two settings will be the top cover.

水泵中对于装有滚动轴承的电机，应先拆下轴承外盖，再松开端盖的紧固螺钉，并在端盖与机座外壳的接缝处做好标记（前后两个端盖的标记不应相同），将卸下的紧固端盖的螺钉拧入电机端盖上专门设置的两个螺孔中，将端盖顶出。

Screw plug opening. Can see the form of 12 pin.

拧开插头。可看到为12针形式。

Screw out the oil plug while filling, and screw down as finished.

注油时，将油塞旋下，注油毕，再将油塞旋上拧紧。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失