拉杆

The spindle accepts 8 mm collets and a hollow drawbar is present.

主轴接受8毫米collets和空心拉杆是目前。

Terry Allen burning off bolts on drawbar center casting.

特里艾伦烧制螺栓在拉杆上中心铸造。

And plumb line to locate drawbar pin hole.

电车线和铅垂线去定位拉杆销孔。

Rocker arm is an important part of loader attachment. It is directly linked to the tilt cylinder and tilts the bucket through a drawbar.

摇臂是装载机工作装置的重要组成部分，直接与翻斗液压缸铰接，通过拉杆带动铲斗翻转。

Farm tractors are commonly equipped with a power take off, but on a farm tractor, the PTO is built-in to the tractor's main transmission and extends behind the final drive housing just above the drawbar.

农用拖拉机普遍配备了功率起飞，但在一个农场拖拉机，动力输出轴是内置的拖拉机的主要传输和扩展背后的最终驱动住房略高于拉杆。

Its main products: travel case, pulling case, suitcase, dressing case, and EVA cloth case, and etc.

主要产品有：旅行箱、拉杆箱、公文箱、化妆箱以及"EVA"布箱等。

Use: Disassembly carriage wheel fore-end control arm ball section and knuckle, the upper arm ball section and knuckle, undertake the pressing down on of arm ball section and knuckle, transverse direction lower arm ball section and knuckle, get lost horizontal stroke pull rod end ball section and knuckle, carriage wheel fore-end control arm ball section and knuckle come off come untied.

用途：拆卸车轮前端控制臂球节与转向节、上臂球节与转向节、承压下臂球节与转向节、横向下臂球节与转向节、转向横拉杆端球节与转向节、车轮前端控制臂球节与转向节的脱开。

Producing and selling what we already have( bearing, pointer, thrust washer, water pump, piston, sleeve, crankshaft, fan blade, ball joint, tie rod, fuel pump and so on), LUKIA also manufactures products according to the samples or OE No.

生产和销售什么，我们已经有（轴承，指针，推力垫圈，水泵，活塞，套，曲轴，风扇叶片，球窝接头，拉杆，燃油泵等）， lukia还制造的产品，根据样本或光电号您所提供的。

Polyphenylene Sulfide as a heat-resistant, corrosion resistance, high rigidity material, and instrumentation can be the production of gears, axle sleeve; in the electrical industry, for the skeleton, bearing, terminal, etc.; in the chemical equipment, shell can be made pump, impeller, valves, etc.; in the automotive industry, for axial transverse rod bushing, fuel system components.

聚苯硫醚作为耐热、耐蚀、高刚性材料，在仪器仪表中，可制作齿轮、轴套；在电器工业中，作骨架、支座、接线柱等；在化工设备方面，可制作泵壳、叶轮、阀门等；在汽车工业，作轴向横拉杆衬套、燃料油系统部件等。

The easiest way is to change the configuration of ground-based equipment, such as moving beam bar to change the ground and the pump stroke length;, followed by replacing the pump motor pulley to control the number of red.

最简单的做法是改变地面设备的配置，如移动游梁拉杆来改变地面和泵的冲程长度；其次是换掉马达皮带轮来控制泵的冲数。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。