拉杆

Thus to realize the work-piece clamping (when using, do not need to clamping too tight), then to make sure that when at working, the web is always in the middle of position of master transmission wheel.

前后浮动辊道采用液压油缸，由液压油缸带动连接架、拉杆、使升降臂回转使其上的滚筒同步升起，在主动滚轮升起后，使浮动辊道同步升起，保证工作在矫正过程中行走平稳。

From a more formal point of view, the slightly waved roof unifies the curved course of the underlying tribunes that offer a nice view over the pylons and its steel tie-beams.

从一个较正式的角度来看，稍微挥舞屋顶统一的讲坛上弯曲的基本课程，提供比塔和钢拉杆的美景尽收眼底梁。

Wind the wire rope from the two guiding block of the pillar, pass through the fall block, fix on the pillar or on the pulling shaft axle of weight limit appliance

4.4.4将卷扬机上钢丝绳从顶梁的两只导向滑轮上绕过，穿过吊笼上的动滑轮，固定在顶梁上（或顶梁上悬挂的重量限制器的拉杆轴上）。

The tie-bar s and platens of a plastic injection machine are important parts of carrying load.

注塑机拉杆和模板是重要的承载零件，易因设计不良而发生早期断裂或出现裂纹的现象。

Toggles, tie bars and platens are subjected to more mechanical abuse than is necessary.

注塑机的肘杆，拉杆以及模板承受了超出额定的机械力。

Toggles, tie bars and platens are subjected to more mechanical abusethan is necessary.

注塑机的肘杆，拉杆以及模板承受了超出额定的机械力。

Company main products: various models of cars Stabilizer steering knuckle torque rod control arm rocker arm rod ball wheel drive shaft, such as a series of automotive chassis components.

公司主要产品：各种型号轿车的扭力杆稳定杆转向节臂控制臂摇臂拉杆球头传动轴轮毂等一系列的汽车底盘零部件。

Has happened in two parts: First, a hole on valve cover; and one on rod and valve cover thread root junction.

发生部位有两处：一是上阀罩出油孔处；一是拉杆与上阀罩连接处螺纹根部。

Has happened in two parts: First, a hole on valve cover; and one on rod and valve cover thread root junction.

发生部位有两处：一是上阀罩出油孔处；一是拉杆与上阀罩连接处罗纹根部。

The analysis on traverse displacement and load state of the bolt and pull rod in a truss is made based on the theory of beams on elastic foundations, and a simplified calculation model for trusses is proposed.

应用弹性地基梁理论对锚拉支架中锚杆和拉杆的横向位移、受力状态等进行了分析，提出了一种简化计算模型。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。