拉伸断裂

The changes of their tension strength and breaking elongation are developed by Mechanics Performance Testing.

通过力学性能测试分析拉伸强度和断裂伸长率的变化。

The tensile strength and breaking elongation of the membranes in dry state decreased with increasing wKGM.

拉伸强度和断裂伸长率的膜，在干燥状态随wkgm 。

To this end butt joint tensile test in almost all the joints are broken from the base metal part of the joint strength of close to 100

为此在进行对接接头拉伸试验时，几乎所有的接头都是从母材部分断裂，接头强度接近100 %。

Moreover, The melting point of the copolyesters PBEST is much higher than that of the poly (butylene succinate –co-ethylene succinate).

PBEST综合了PET具有高的拉伸强度及PBES具有高的断裂伸长率的特点，因而具有优异的机械性能。

This experiment has prepared the compound material of fiber reinforced caoutchouc by using the dry compounding process with short glass fiber and C fiber,studied the impacts on tensile strength,elongation at break, tearing strength,Shaoshi strength due to the different fiber type and the addition,as well as compared the property of two kinds of fiber reinforced compound material.

采用了短玻璃纤维及C纤维干法混炼工艺制备了纤维增强天然橡胶复合材料，研究了纤维种类及添加量对其拉伸强度、断裂伸长率、撕裂强度、邵氏硬度的影响，并且就两种纤维增强的复合材料性能进行了对比

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The blend has following properties with 10 parts compatibilizer. The tensile intensity and elongation at break reach 35.66MPa and 23.58%, respectively, improving by 26.6% and 65.7% respectively compared with 0 part compatibilizer; The characteristic absorption peak of carbonyl at 1725～1800cm-1 disappear and the characteristic absorption peak of hydroxide at 3438～3440cm-1 increase induce the formation of hydrogen bond; The decalescence peak of blend increase by 2℃compared with the blend containing 0 part compatibilizer near 100℃; Lignin can be dispersed homogeneously to avoid reuniting of lignin particle.

2当共混材料中增容剂含量为10份时，共混材料表现出如下特性：拉伸强度和断裂伸长率分别达到35.66MPa及23.58%，较未加增容剂分别提高了26.6%和65.7%；从1725～1800cm-1范围内羰基特征吸收峰接近消失以及3438～3440cm-1范围内的羟基波数的增加暗示了共混材料中氢键缔合的发生；共混物在100℃附近的吸热峰较未加增容剂时降低了近2℃，相容性得到了提高；木质素在基体中进一步分散，结晶度增加，从而阻止木质素的团聚，增加了两相的相容性。

The WPU we prepared has 20% solid content, about 80nm minimal particle diametre, pH value 7-8.5. It can be stored for 6 months under room temperature.

试验所制备的水性聚氨酯乳液固含量20%左右，pH7-8.5，最小粒径达到80 nm，室温乳液贮存稳定性大于6个月，涂膜断裂伸长率和拉伸强度等均达到或者超过皮革涂饰对水性聚氨酯的要求。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。