抬

He raised his eyebrow s and smiled a sad, forlorn, yet irritatingly conspiratorial smile

他抬起了眉毛，露出又忧愁、又凄凉、却又使人恼火的心照不宣的微笑。

In cards and membership cards, frequent blanket hairline viscoelasto todaya, and since some shredded paper, impurities and isopiestic into the rubber blanket the sand on the surface, making blanket small holes or a small hole in the eye, and so on, if in a timely manner, without the use of rubber blanket is too large, at present, the operator of the commonly used methods in general there are several.

在制卡和会员卡制作洋，必然会碰到橡皮布暗不天不收黏的本体，并且，由于一些碎纸、杂质及沙粒等不抬进橡皮布暗不天，致使橡皮布呈现小的瘪坑或小的洞眼等，如果准时举行挽回，不离不会差橡皮布的搁置爆不收太大的感化，长远，操纵职员常用的拆除办法大抵有以上几栽。

Scrooge suddenly remembered the words of Jacob Marley's ghost,and,lifting his eyes,saw a spirit,all in black,coming slowly towards him.

斯克罗吉突然记起雅各布。马利幽灵的话，他抬起眼睛，看见了一个幽灵，身着黑衣服，慢慢地朝他走来。

Dr Cuddy : Oh, I looked up that philosopher you quoted, Jagger , and you re right.

医生Cuddy：噢，我抬起头你引述的哲学家，贾格尔，你是对的。

D. When finishing the installation of hinges of door leaf and jamb, raise the door leaf, and insert the hinge into the hinge axis.

D。 完成门扇和门套上的所有页面的安装后，抬起门扇，将门扇页面的合页筒套入门套页面的合页轴。

Although the distance is only one or two li, she was so weak that unable to go on foot,then she was carried by a Jampan.

那是她迁居李庄五年第一次到镇上，虽只一二里路，但虚弱不胜步行，是滑竿抬着的

Then he looked up, lifted those hands calmly, judiciously, and nodded his head

后来，他仰起脸，轻轻地抬起双手，颇有见解地点了点头。

The Automatic and Manual Carrier Robots shall be placed in the Start Zone carrying the Kago.

4.3.1。自动和手动运输机器人抬着轿子并放置在出发区。

The Automatic and Manual Carrier Robots shall pass through the Woods while carrying the Kago with the Traveller Robot on the Seat.

5.5.1。自动和手动运输机器人应抬着载着旅行机器人的轿子穿越森林。

The Automatic and Manual Carrier Robots shall cross the Mountain Pass while carrying the Kago with the Traveller Robot on the Seat.

5.4.1。自动和手动运输机器人应抬着载着旅行机器人的轿子横越山路。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。