抛物线

Ritz variation method was used to find the numerical relation between the energy near the ground-state of the hydrogen molecular ion H 2 + and the changes of the variation parameter and the bond length,the computation formula of bond length and ground-state energy for H 2 + was also obtained by means of the method of parabolic interpolation .

用Ritz变分法求出了氢分子离子H2 +基态能量附近的能量随变分参数和分子键长变化的数值关系，并用抛物线插值法获得了H2 +键长和基态能量的值及其计算公式，比文献 [1，2 ]更接近于实验值。

Typical methods of the first class consist of predictive deconvolution, normal moveout interconversion stacking, f-k transformation, tau-p transformation, parabola Radon transformation and beamforming. They can be called as seismography method based on the geometry. The second class methods, mainly bases on elasticity undulatory theory, through simulation or reversal development method forecast multiple, and then match it with the original data.

比较典型的方法有预测反褶积、正常时差变换叠加、f-k变换、τ-p变换、抛物线 Radon 变换和聚束滤波等，它们可以简称为基于几何地震学方法或"几何滤波类方法"；第二类主要是基于弹性波动理论的方法，通过模拟或反演方法来预测原始数据中多次波，继而从原始数据中匹配减去所预测的多次波。

The results show that the silicide coating is formed by reactive diffusion and the silicification process obeys parabolic relation. The coating is composed of composite structures including MoSi2 outer layer, two-phase transient zone with major NbSi2 and minor Nb5Si3, and Nb5Si3 diffusion inner layer. The coating possesses good high-temperature oxidation resistance and spalling resistance.

研究结果表明：包渗法制备硅化物涂层是通过反应扩散形成的，硅化过程服从抛物线规律；该涂层为复合结构：MoSi2相为主体层；以NbSi2相为主、并含少量Nb5Si3相的两相为过渡区；Nb5Si3相为扩散层。

The standard parabolic equation method was obtained by the decompocition of the scalar wave equation and the expansion of the pseudo-differential operator.

通过对传统波动方程的分解和伪微分算子的近似展开，获得了标准抛物线方程。

The article puts forward a design method of surface of revolution according to buffer structure of a hydraulic cylinder .

文章针对油缸端部缓冲结构提出了一种抛物线回转面的设计方法，经过仿真分析，其缓冲效果合理且在结构上具备很好的工艺性。

The residual stress in the adherend is center symmetric, and the polynomial fitting of the S is obtained as parabola distribution.

被粘物中的残余应力呈中心对称，等效应力经多项式拟合后呈抛物线分布。

The findings indicate that, on the whole, the pattern of load transfer curves of adfreezing stress on a steel pipe pile stem and that of resistance stress on the pile tip are parabola and straight line, respectively; Due to the rheology effect, to different extent, adfreezing stress on the pile stem and resistance stress on the pile tip vary with time and relative displacement of pile-soil, respectively, and the settlement of pile tip varies with time tempestuously within 5 hours of loading, and then approximates to stability.

结果表明：模型钢管桩桩侧冻结力荷载传递函数曲线及桩端阻力荷载传递函数曲线其线状大致分别程抛物线及直线；由于流变效应的影响，桩侧冻结应力及端阻应力随时间有不同程度的变化；桩土相对位移和桩端下沉量开始5h内随时间变化较大，但加载5h后逐渐向稳定方向发展。

Besides,the trapezoidal method and parabolic method is used to make approximate calcalation and error estimate of the integral.

同时 ，用梯形法和抛物线法对此积分作了近似计算和误差估

Parabolic relation between the etching rate of AlGaAsSb materials and their Al content was found, unselective etching could be performed for GaSb and AlGaAsSb material with certain Al content.

实验中发现该腐蚀液对AlGaAsSb的腐蚀速率与其Al组份呈抛物线关系，在合适的Al组份下可对AlGaAsSb和GaSb两种材料进行非选择性的刻蚀。

The oxidation kinetics of depleted uranium was studied in pure oxygen pressure of 5 kPa at below 100°C by using spectroscopic ellipsometry. The relationship of the thickness of uranium oxide with time is measured. The results indicate that below 100°C in the initial period, the relationship between oxidation layer thickness and time is parabolic. The oxidation mechanism of depleted uranium is discussed and the active energy of depleted uranium at given experimental conditions is 87.165kJ/mol from calculation.

采用椭偏技术研究了45~95℃和5kPa纯氧气氛中金属铀的氧化，通过不同温度下金属铀表面氧化层厚度随时间的变化规律，得到贫铀在初始氧化阶段的表面氧化层厚度与时间的关系均呈现抛物线规律；绘制出了在不同温度下金属铀表面的氧化动力学曲线，由此得到在低于100℃，5kPa的纯氧气氛下贫铀表面形成氧化物的反应活化能为87.165kJ/mol。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。