折起
- 与 折起 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
He fumbled in his pocket,re-membering the piece of crumpled paper the man had handed to him
他记起刚才在黑暗的途中,那弟兄给他一团折皱的硬纸,说是那男的手
-
Pegasus needle, pedal normally take some time as the time after the step is tangent , and presser foot lift, but the workers said yesterday that the bottom line is easy when the needle off the tangent , tangent brandished a knife and I wanted to transfer about the time, but not know how to get in,...
飞马双针,踏板一般走一段时间像后踩的时候是切线,然后压脚抬起,可是昨天工人说双针切线的时候底线容易折,我就想调一下切线挥刀的时间,可是不知道怎么弄的,。。。
-
Pegasus needle, pedal normally take some time as the time after the step is tangent , and presser foot lift, but the workers said yesterday that the bottom line is easy when the needle off tangent , I wanted something fast time tangent brandished a knife, but not know how to get in,...
飞马双针,踏板一般走一段时间像后踩的时候是切线,然后压脚抬起,可是昨天工人说双针切线的时候底线容易折,我就想调一下切线挥刀的时间,可是不知道怎么弄的,。。。
-
Now he made little planes out of the silver paper that came in the packets of cigarettes that were too expensive for his people to smoke.
现在他用香烟盒里的银纸折飞机。这种香烟对他们这类人来说太贵了,抽不起。
-
At this time, loosen the connection screw of standard section with spanner, hang the shaft of hand crane on the upper angle bar, sway the shaft of hand crane upward, separate this standard section from the next section, and lay it in the suspension coop, dismantle the other standard section for the same method, and turn the shaft to another direction, draw the lifting wire rope tightly, the operation staff leave the suspension coop, open the lock stopping instrument, fall the suspension coop to next position and lock the brake instrument, the operation staff return to the top of suspension coop, continually dismantle note: forbid the staff leave on the top of suspension coop or in the coop when the suspension coop is running
8.1折除时,首先将吊笼用停层装置停靠在待拆除的标准节的下两节上,操作人员上到吊笼顶,卷扬机松绳,用小吊杆将顶梁略向上提起,拔出顶梁横销,使顶梁值得徐徐降下,降到拆除节下一节中间框架角处,并重新穿上横销,这时用板手将标准节连接螺栓松开,将手摇起重机小吊杆钩挂在待拆节上框架用钢土,到吊笼内,用同样的方法拆下另一节标准节,然后将吊杆转向不影响升降机运行的方向,收紧起升钢丝绳,操作人员离开吊笼,打开锁止机构,使吊笼下降到下一个拆除位置,并将锁止机构锁死,人员重返笼顶,进行下一拆除循环注意:在吊笼运行时绝不允许有人员留在吊笼顶部或吊笼内
-
When dismantle the machine, firstly, stop the suspension coop on the lower 2 sections of the standard sections, the operation staff go on the suspension coop top, the hoisting machine loosen rope, lift the pillar with small shaft, pull out the horizontal pin of pillar, let the pillar fall slowly to thedismantled section's middle angle bar, insert the horizontal pin again. At this time, loosen the connection screw of standard section with spanner, hang the shaft of hand crane on the upper angle bar, sway the shaft of hand crane upward, separate this standard section from the next section, and lay itin the suspension coop, dismantle the other standard section for the same method, and turn the shaft to another direction, draw the lifting wire rope tightly, the operation staff leave the suspension coop, open the lock stopping instrument, fall the suspension coop to next position and lock the brakeinstrument, the operation staff return to the top of suspension coop, continually dismantle note: forbid the staff leave on the top of suspension coop or in the coop when the suspension coop is running
8.1折除时,首先将吊笼用停层装置停靠在待拆除的标准节的下两节上,操作人员上到吊笼顶,卷扬机松绳,用小吊杆将顶梁略向上提起,拔出顶梁横销,使顶梁值得徐徐降下,降到拆除节下一节中间框架角处,并重新穿上横销,这时用板手将标准节连接螺栓松开,将手摇起重机小吊杆钩挂在待拆节上框架用钢土,到吊笼内,用同样的方法拆下另一节标准节,然后将吊杆转向不影响升降机运行的方向,收紧起升钢丝绳,操作人员离开吊笼,打开锁止机构,使吊笼下降到下一个拆除位置,并将锁止机构锁死,人员重返笼顶,进行下一拆除循环(注意:在吊笼运行时绝不允许有人员留在吊笼顶部或吊笼内
-
Close up the dart that is not required by creasing the line from the shoulder to the bust point and then folding the creased line in the arrowed direction.
收拢不需要的省道,使肩到胸点这条线起皱痕,然后朝箭头标出的方向折这条痕迹线。
-
The self-pulsation behavior of the phase-conjugated light is studied experimentally in a semilinear self-pumped phase conjugator, which contains two BaTiO3 crystals (one of them operates in total-internal-reflection self-pumped phase conjugator and is used as retro-reflector in this semilinear self-pumped phase conjugator).
在由两块光折变BaTiO3晶体(其中一块晶体为全内反射式自抽运相位共轭镜工作方式,起外反射镜作用)构成的半线性自抽运相位共轭器中观察到了相位共轭光的自脉动现象。
-
There are five types of deformational structure in the front zone of the Tang-Lun nappe, Ningzhen Mountain:great rotating of beds and imbricated system;reversed structure;transverse and oblique faults with the character of tear faults;warping of recumbent folds and kink band with advantageous shearing direction.
发育在宁镇山脉的汤―仑推覆体前锋带上的变形构造存在五种型式:岩层的大幅度旋转与密集的叠瓦系;反冲构造;具捩断层性质的横向及斜向断层;平卧褶曲的翘起和具优选剪切方位的膝折构造。
-
If there is joint on the back, in the lower right or fill a 20% discount after it has been causing wrinkles without distortion; vacuum packaging vacuum after the contents of the packin mouldedround radiofrequent nonanatomical tridimension on the surface, shape, surface roughness, would create a bar code reading of deformation cannot, therefore, be appropriate for the vacuum packing inner bag direct business card printing and membership card to make a bar code, you can increase the packin business card printing outside and membership card to make a bar code, and other graphics and text.
如背面中央有接缝,则印在右下方或印在填充后不起皱折、不变形处;真空包装抽真空后包装袋紧贴在内容物表面,呈不规则立体形状,表面不平整,会造成条形码变形不能识读,因此真空包装内袋不宜直接制卡和会员卡制作条形码,可增加一个外包装袋制卡和会员卡制作条形码及其他图文。
- 推荐网络例句
-
It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.
从鲍尔点的形成原理出发,分析对称连杆曲线上鲍尔点的产生条件,提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。
-
The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.
集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品,年生产总值3000万美元,产品价廉物美、选料上乘、质量保证,深受国内外客户的青睐
-
The eˉtiology of hemospermia is complicate,but almost of hemospermia are benign.
血精的原因很,以良性病变为主。