折皱

Under these conditions, the crease recovery angle was increased by 30%~45%, and the breaking strength retention kept as high as 88%~95%.

在此最优工艺条件下，整理后棉织物的折皱回复角提高率为30%~45%，断裂强力保持率为88%~95%。

Along with the papers crimped uncomfortably in the waistband of his breeches, it was the last gift the doctor had given him.

还有很不舒服地塞在他裤子腰带里的折皱的羊皮纸，这羊皮纸是大夫给他的最后一个礼物。

Film or paper surface dirty, and wrapped it into the dust or clear plastic mulch films after the crease or relaxation phenomena, film hemming switched to a new membrane drying temperature is too high, adhesive surface crust adjust oven temperature, clear crusts partⅱ thermotolerance cohesion and not enough use better glue wrinkle of polymer-coated film transfer after the roll is not the proper balance of films at both ends are inconsistent or wave; adjustment layer of polymer-coated machine too thick, solvent evaporation incomplete, viscosity, pressure drum extrusion, paper (Business card printing and membership card making products) and films between slide to adjust the film covering technology electrothermic roll and rubber roller ends is not plain, pressure is inconsistent, ranging from the adjustment of the linear speed of the machine after the temperature inside the plastic mulch film covering the subject in yellow glue resin particularly resin or additives not resistant to ageing, in the light, heat, under the influence of ultraviolet radiation, chemical change, build the pigments should be switched to a new glue

薄膜或纸张表面不干净，裹入灰尘或杂质清除后再行覆膜薄膜有折皱或松驰现象，薄膜卷边换用新膜干燥温度过高，粘合剂表面结皮调整烘道温度，清除结皮胶的粘接力和耐热性不够换用更好的胶水覆膜后起皱薄膜传送辊是否不平衡；薄膜两端松紧不一致或波浪边；调整覆膜机器胶层过厚，溶剂蒸发不彻底，影响了粘度，受压力滚筒挤压，纸张与薄膜之间产生滑动调整覆膜工艺电热辊与橡胶辊两端不平、压力不一致、线速度不等调整覆膜机器覆膜后易变黄胶水中的主体树脂特别是一些增粘树脂或助剂不耐老化，在光、热、紫外线的影响下，发生化学变化，生成有色物质应换用新胶水

The three dimension reticular cell counting method is adopted to calculate the fractal dimension characterizing skew degree of gray level surface. With the two-dimension reticular cell counting method, the fractal dimension characterizing wrinkle shadow block distribution is obtained. By means of distribution function, the fractal dimension for the size distribution of wrinkle shadow block can be achieved.

提出以尺度变化的立体网格计算灰度曲面的分维数，表示灰度曲面的起伏程度；以尺度变化的平面网格计算织物折皱阴影块分布的分维数，表示阴影块的离散程度；以当量直径为尺度，计算分布函数的分维数，表示织物折皱阴影块尺寸的分布。

When you pack a suitcase - no matter how good you are at it - clothes get wrinkled.

当你折一个手提箱再好，你在它的衣物得到折皱。

When you are feazed by the familiar problems of the product becoming damp or mildewy etc and expect to solve urgently, when you are perplexed by the phenomena of the product packing becoming wrinkly, cracked, frosted, fogged or breakable and leaky etc or when you look for the hot wrapper of low temperature and hope to buy into the superior quality warpper, Zhongan plastics industry limited company will provides exhaustive solution for you with its advanced technique, appropriative material and good equipment.

当您为产品受潮、霉变等常见难题困扰而迫切期待解决时，当您为产品包装的折皱、折裂、结霜、雾化、蒸煮时易破易漏等现象而困惑时，当您寻求低温热封包材时，当您希望购进最优质包装材料的时候，中安塑业运用先进的技术、专用的材料、优良的设备给您提供彻底的解决方案。

If the cellulose is crosslinked in the highly swollen wet state, it will have good crease recovery in the wet state but little or no crease recovery properties in the dry or collapse d condition, because the crosslinks are not taut in this condition.

如果织物是在湿态高膨胀状态下交联的，织物则在湿态下具有较好的折皱回复性，而在干态下折皱回复性较小或没有，这是因为在这种情况下，交键并不处于拉紧状态。

If the cellulose is crosslinked in the highly swollen wet state, it will have good crease recovery in the wet state but little or no crease recovery properties in the dry or collapsed condition, because the crosslinks are not taut in this condition.

如果织物是在湿态高膨胀状态下交联的，织物则在湿态下具有较好的折皱回复性，而在干态下折皱回复性较小或没有，这是因为在这种情况下，交键并不处于拉紧状态。

He demonstrated the art. He folded, unfolded and refolded.

他向人们示范着这门艺术--折好，拆开，再折好，并向人们解释复杂的细节以及必须把折皱处弄得平滑光洁、有棱有角。

He demonstrated the art, and he folded, unfolded and refolded, and he explained the intricate details, the need for sharp creases

他向人们示范着这门艺术--折好，拆开，再折好，并向人们解释复杂的细节以及必须把折皱处弄得平滑光洁、有棱有角。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。