扫描

The influence of MgO-CaO, MgO-Al2O3 and Al2O3-MgO refractories on inclusion content and composition of 82B steel was studied. The change in inclusion type and size in the samples taken after holding molten steel in refractory crucible of induction furnace at 1450°C for 80 mm was investigated by means of SOLIM worker, image analysis, SEM and EDAX.

利用大样电解、图像分析、扫描电镜和能谱分析等检测手段研究了82B钢种选用Al203-MgO、MaO-Al2O3和Mg-CaO炉衬在1450℃保持80min后生成的夹杂物种类和变化。

Scanning technique of CO2 laser imaging radar has become one of the key techniques used in cruise guide and control guide.

激光扫描技术是在巡航导弹制导中应用的CO2激光成像雷达的关键技术之一。

By using SEM and contact angle analyzer, the surface properties were investigated. The blood-compatibilities were estimated by blood platelet adhesion and dynamic cruor time test.

运用扫描电子显微镜，接触角测量仪对其表面形貌和亲疏水性进行了表征，采用血小板粘附试验和动态凝血试验对涂层的血液相容性进行了评价。

The electrolysis corrosion rates in the cryolite molten salt under different current densities were measured and the corrosion mechanism was preliminarily discussed.

用X射线衍射和扫描电子显微镜对材料的组成和微观结构进行了研究，测量了样品在冰晶石熔盐中不同电流密度下的电解腐蚀速率，并对其腐蚀机理作了初步探讨。

The effect of δ-doping in n-type layers on crystal performance of GaN epitaxial films on Si substrates was studied by ω-scan of different crystal planes with X-ray diffraction method.

用X射线衍射方法通过不同晶面的ω扫描测试，分析了Si衬底GaN蓝光LED外延膜中n-型层δ掺杂Si处理对外延膜结晶性能的影响。

The surface morphology and crystallinity of the specimens were characterized by means of scanning electron microscopy and X-ray diffraction.

利用扫描电子显微镜和X射线衍射分别对样品形貌及其晶型进行了表征。

Carboxymethyl starch was prepared from cornstarch by using a dry method,and the molecular structure,granule configuration and crystallizability of the carboxymethyl starches with different substitution degree were investigated by using ultrared spectrograph,electro scanning microscope and x-ray crystallograph.

以玉米淀粉为原料，干法制备羧甲基淀粉，并利用红外光谱仪、扫描电子显微镜和X-射线衍射仪对不同取代度的羧甲基淀粉的分子结构、颗粒形貌及结晶性进行了研究。

The nucleation effect of nucleating agent HC (mainly containing salt of high molecular carboxylic acid) on polyoxymethylene was studied, and the effects of the nucleating agent on the crystalline morphology, crystallizability and crystallization rate of POM were also studied by means of DSC, PLM and isothermal crystallization kinetics analysis.

研究了高摩尔质量羧酸盐类成核剂HC对聚甲醛的结晶成核作用，采用示差扫描量热分析、偏光显微镜观察及等温结晶动力学分析等方法研究了该类成核剂对POM结晶形态、结晶度、结晶速率等的影响，并考察了其力学性能。

Carboxymethyl starch was prepared from cornstarch by using a dry method,and the molecular structure,granule configuration and crystallizability of the carboxymethyl starch es with different substitution degree were investigated by using ultrared spectrograph,electro scanning microscope and x-ray crystallograph.

以玉米淀粉为原料，干法制备羧甲基淀粉，并利用红外光谱仪、扫描电子显微镜和X-射线衍射仪对不同取代度的羧甲基淀粉的分子结构、颗粒形貌及结晶性进行了研究。

X-ray diffraction, scanning electron microscopy and energy disperse spectrometry were used to characterize the crystalloid structure, topography and component of non-coated and coated glass microspheres.

采用X射线衍射仪、扫描电镜和能谱仪对化学镀前后玻璃微球的结构、表面形貌以及成分进行了分析。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。