打印头

According to the point of view of mechatronics, the modeling of the dot-matrix needle printer head has been completed by the method of electromechanics.

本文从机电一体化的观点出发，运用机电动力学方法，完成了计算机的点阵针式打印头的建模，并进行了数值模拟分析，且推导出"L"形打印头的磁路、电路和动力学方程，给出了相应的初始条件和边界条件。

When the nozzle fully repaid after pass, remove the print head, dry cleaning fluid extra careful with hair dryer to dry the print head.

当喷头完全清通之后，取出打印头，晾干多余的清洗液或用电吹风小心地吹干打印头。

Print Head and inkjet container are separated of this kind of inkjet cartridge, it is possible that former usage will affect print quality and even make it unprintable.

因此类墨盒是分体墨盒打印头与墨水仓是分离的，之前墨盒墨水已用尽导致打印机内打印头内已干和墨道里面进空气等诸多原因造成的打印效果差甚至不出墨的现象。

The best ink in the off-time after opening the packaging end use, not to open the ink on the outside when not in use Add to carton packaging, the cartridge so as to avoid talking about the dust falling into the hands of the next use of the dust caused by plugging into the nozzle first, the head following a reset state of ink wash sponge pad, open the front cover, press the Print Paper knife, move out, the hair can not suction clean cloth towel or sponge the ink pad, a large amount of about 10 days, then wash first, because each sponge pad is printer ink wash drawing of fatigue, if the dust and fatigue more ink will be solidified with the protection of Garra and print images will be the first flush, if the plug was found, and if the use of cleaning 3 seconds is not normal use, we must enter the printer maintenance menu kk2 or use kk1 cleaning, large format printers and a small printer operation principle is similar, if the correct maintenance and use, it will increase the service life, which Like is like a car, but also for us to maintain and are familiar with it

墨水最好在拆开包装后断时间内使用完，不要把打开的墨水放在外面，不用时包装好放入纸盒内，以免墨盒嘴上落入灰尘，下次使用时灰尘进入喷头造成堵头情况，喷头复位状态下面有一个洗墨海绵垫，打开前盖，按下打印切纸刀，往外移，用不起毛的纸巾或布吸干净海绵垫的墨水，用量大的话大约在10天清洗一次，因为海绵垫是打印机每次冲洗时吸取疲墨水的，如果灰尘多就会和疲墨水凝固在一起，对墨头的保护和打印头冲洗会有影像，如果发现堵头情况，如果使用清洗3秒还不能正常使用，我们要进入打印机的维护菜单用kk2或kk1清洗，大幅面打印机和小打印机的操作原理是差不多的，如果正确的维护和使用，它的使用寿命就会增长，这也好比一辆轿车一样，还要我们去维护和熟悉它

The image forming apparatus includes a print head having the plurality of nozzles arranged in a widthwise direction of the print medium, a displacement unit to cause a change in relative position between the print medium and a print head, and a controller to control the displacement unit to reduce deviation in use frequency of the respective nozzles.

成像装置包括：打印头，其具有多个布置在打印介质宽度方向上的喷嘴；移位单元，其使得打印介质和打印头之间的相对位置改变；以及控制器，其控制移位单元以降低各个喷嘴的使用频率偏差。

The carrier belt sends the sheet to a printing position opposing the printing head, and sends the printed sheet from the printing position.

输送皮带把纸张送到与打印头相对的打印位置，并且输送皮带从打印位置输送走打印完毕的纸张。

A increase in the speed of printis achieved because of linear arrangement of large stationary printheads - inks are distributed throughout the entire width of paper at the moment of passage of sheet under the printing heads.

阿增加的速度实现打印，因为线性安排的大型固定打印头-油墨分布在整个宽度的纸张目前通行的资产负债表下的打印头。

The 9040 continuous ink jet printer can be used with single-jet and bi-jet printheads, three different printhead resolutions, several umbilical lengths, enhanced connectivity, and a selection of inks.

连续的9040喷墨打印机可用于单喷和双喷打印头，打印头三个不同的决议，几个脐长度，增强连接，以及可供选择的墨水。

Remove each printhead from its package, and then remove the

去除每个打印头的包装材料，然后去除打印头上的保护

Print ribbon is installed, we need to print frame first uninstall it from the printer, uninstalling the device must be near the print head from the location you pull up hard, in order to easily print aircraft had come from the printer ; the following, we also need to open the print frame, taking into account different models of printers that it installed on the structure of the printing frame is not exactly the same, so the installation of ribbon winding method is not exactly the same, we have to uninstall it before the original band, we a good look around the ribbon before the correct method, or else do not print the right way to install the ribbon will not be able to function properly, but also may lead to the printer not work correctly.

在安装打印色带之前，我们需要先将打印架从打印机中卸载下来，在卸载该设备时，必须先从靠近打印头的位置处用力向上拉一下，才能把打印架轻松地从打印机中拿下来；下面，我们还需要将打印架打开，考虑到型号不同的打印机它的打印架安装结构并不完全相同，因此色带的安装缠绕方法也不完全相同，我们在将原色带卸载下来之前，一定要好好地观察一下色带以前的正确绕法，否则不按正确方法安装的打印色带不但不能正常发挥作用，相反还有可能导致打印机无法正常工作。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。