成核

At the temperature as low as that at which the monomer cannot diffuse in large scale,adatom nucleation and island formation depends on the increase of adatom density.With the increase of temperature,the film growth mode depends on the competition between in-plane diffusion and inter-layer diffusion of monomers.

当薄膜生长温度低于单原子的扩散温度时，表面原子的成核和表面岛的生长主要是由沉积原子的空间随机性和表面原子密度增加而决定的，随着薄膜生长温度的提高，薄膜的生长模式则取决于单原子的层内扩散和层间扩散的竞争。

Theelectropolymerizaitons in the present study was followed by in situ UV-visspectrometry,which showed the rate of elecctropolymerization decreased as theconcerntration of anthranilic acid in reaction solution.

本文涉及的电化学聚合均用在线紫外—可见光谱进行跟踪，结果表明电化学共聚随着反应体系中邻氨基苯甲酸的浓度的增加而变慢；同时，在电化学聚合过程中的电流—时间瞬时响应曲线表明聚邻甲基苯胺和共聚物均可能是以三维累积成核的方式沉积在ITO导电玻璃电极上。

For double jet method, effects of used solvent, shape of stirrer, adding reactant position, reaction temperature, excessive silver ion concentration in reaction solution and adding rate on the nucleus formation, and growth of silver behenate crystal were systematically studied.

本文分别采用单注沉淀法和双注沉淀法制备了山嵛酸银晶体，通过对两种制备方法的对比及优选，最后确定双注沉淀法更适合制备细粒径的山嵛酸银，通过采用SEM、TEM等对山嵛酸银晶体形貌的表征发现，制备山嵛酸银所使用的溶剂、搅拌方式、加料的位置、反应温度、反应初始液中银离子浓度及加料速度等，均对山嵛酸银的晶体成核与生长有一定的影响。

Di(3,4-dimethyl)benzylidene xylitol as synthesized in the lab from 3,4-dimethyl benzaldehyde and xylitol, and a series of polypropylene samples were prepared based on the amount of the nucleating agent, DMDBX used.

以3，4-二甲基苯甲醛和木糖醇为原料合成1，3-2，4-二（3，4-二甲基）亚苄基木糖醇，将DMDBX作为成核剂使用溶液沉淀法制备DMDBX质量分数分别为0、0.1%、0.3%、0.5%、0.7%、0.9%的聚丙烯样品，采用红外光谱仪、差示扫描量热仪、X射线衍射仪和偏光显微镜等方法，研究了DMDBX对PP结晶结构和结晶性能的影响。

It is regarded that the defect structure with jumbo size and high density in the crystal lattice is generated by the complex coaction of incident irradiation field and external electric field.

提出了物理机理的理论分析，认为外电场和激光辐照场的共同作用在晶体内部产生高浓度、大尺寸的缺陷结构，缺陷一定程度上降低畴体成核和畴壁运动所需要克服的退极化能和畴壁能，实现激光诱导畴反转。

The experimental investigation and analysis are presented for exploring the intrinsic link betweencompressive deformational response and crack behavior of the mortar specimens.

1引言 微裂纹的萌生、演化和成核而引起受损固体的非线性力学响应对材料和工程的变形和破坏非常重要，对于以水泥为基材的脆性固体材料，裂纹常常是材料的非弹性变形和破坏的决定性因素，因而它已经成为一项重要的研究课题[1]。

Template-confined growth is a very powerful method for obtaining aligned 1D nanomaterials with adjustable diameter, length and morphology. Porous anodic aluminum oxide templates with different channel structures have been synthesized in our lab, with which the aligned CNT arrays, Y-branching and novel dendriform CNTs have been obtained. Based on the structural characterization of the products, a space-limited and self-catalytic growth mechanism has been proposed accordingly. Roughly speaking, the catalyst particles at the bottom of template channels initiate the nucleation of carbon species, which acts as the seed for subsequent CNT growth.

本文采用近年发展起来的模板控制生长法，以多孔氧化铝模板控制CVD生长的方法调控了碳纳米管有序阵列、γ-分叉及树枝状分叉结构，在对产物进行详尽结构表征和分析的基础上阐述了氧化铝模板控制生长碳纳米管的生长机制：孔道内催化剂仅在生长初始阶段催化碳物种的成核，起&种子&作用，随后模板孔道自身的催化及限域作用使碳纳米管紧贴着孔道内壁生长。

First, some critical problems in crystal growth like crystal seeding, Zn dephlegmation, geometrical selection and temperature fields are discussed in theory, and the possible kinds of defects appeared in crystal growth progress and the reasons are carefully researched. To control the concentration of Cd vacancies, a new method by which the Cd vacancies were compensated with excess Cd in the Cd rich starting materials has been developed, and a new kind of two-area tube furnace with good linear temperature distribution was designed.

首先，本文从理论上对坩埚下降法生长碲锌镉单晶体中的成核、Zn分凝、几何淘汰生长与温场等关键性问题进行了讨论，对在生长过程中可能出现的各种缺陷类型和形成原因进行了详细分析，提出了碲锌镉单晶体生长过程中Cd空位缺陷控制原理及方法，并针对坩埚下降法生长特点自行设计了两区域独立加热管式生长炉，获得具有较好线性分布的温场。

This article studies mainly the phenomenon of nucleation and growth of calcium sulfate dihydrate crystal,the mechanism of scale fomation is also discussed.The study on this part is helpfoul for developing or selecting more economic and effective scale treatment agents.

本文主要研究了过饱和溶液中二水硫酸钙晶体成核及生长现象，同时对垢的形成机理进行了探讨，针对这方面的研究有助于开发或选择更经济有效的垢处理剂。

The above-mentioned T8 glass-ceramic showed only 25 % decrease in IR transmittance, 17 % increase in hardness, 61 increase in dilatometric softening point, and 19 % increase in Young s modulus.

上述试片之IR穿透率与T8起始玻璃比较，仅下降了25 %，但硬度上升了17%；与未添加成核剂的玻璃比较，膨胀仪软化点上升约61℃，杨氏系数上升约19 %。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。