惯性系统

This new type seperator gives a beutiful future for the solving of the problem. Besides of this, the seperation function and structive ameliorations of uniflow square seperator and finned tubes seperator were studied systemly, and with the contrast with other type of separtors, have higher seperation efficiency. The uniflow square seperator can reach a much ligh seperation efficiency when it was ameliorated.

并对新型下排气方形分离器和鳍片管束惯性分离器的分离性能和结构优化进行了系统的研究，在对其它几种分离器研究的同时进行了对比，指出方形下排气分离器在结构优化后可达相当高的分离效率，与常规圆形分离器相当，能承担高倍率循环床的物料循环，结构布置得到极大的简化。

We modeled it by means of centralizing the distributed system parameters and establishing it with dynamic modeling.

目前在研究飞机操纵系统时，一般是将从舵机到操纵舵面的机械传动部分处理成一阶惯性环节。

The effect of the heat storage tank on defrosting by the air source heat pump was tested.

由于蓄热水箱的存在，中间环路的热惯性较大，空气源热泵机组结、化霜对系统的影响与室温的稳定性几乎无关。

In this paper,the generalized equations of variable mass for high-order nonholonomic mechanical system in noninertial frame are de- rived by the universal D Alembert s principle and an example is given to illustrate the application of these equations.

本文由万有D'Alembert 原理导出变质量高阶非完整系统相对于非惯性系的广义方程，并举例说明其应用。

Another concrete example is the inertia-activated chain brake which greatly reduces the risk of injury in the event of uncontrolled kickback.

另一个有力例证是惯性触发链条制动系统的设计极大降低了意外反弹出现时引起的伤害。

As long as the valve moved to the middle of the motor to stop functioning, but because of inertia, motors exported to the valve will vary between the back pressure which increases the motor to stop functioning, it is possible to return to the pipeline route or valves destruction, must therefore be shown in Figure 5-23 shown in the system Zhongzhuang a brake relief valve.

只要将换向阀移到中间位置，马达就停止运转，但由于惯性，马达出口到换向阀之间的背压将因马达的停止运转而增大，这有可能将回油管路或阀件破坏，因此必须在如图5-23所示的系统中装一刹车溢流阀。

Ball mill coal pulverized system is a complex multivariate object with strong coupling and great inertia.The primary variables being controlled are temperature at the output,negative pressure at the input,differential pressure,and mill load,etc.

中储式钢球磨制粉系统是一个多变量、强耦合、大惯性的被控对象，其主要被控量是球磨机出口温度、入口负压、入出口差压、磨煤机载煤量等。

A geometric correction model of tri2CCD line sensor imaging is established by use of outer orientation elements synchronously recorded by IMU and inner orientation elements cali2 brated in the lab. At last geometric distortions and geometric corrections are simulated on the computer.

利用由惯性导航系统同步记录的CCD 线阵传感器的外方位元素和在实验室标定的CCD 像元的内方位元素建立3 条CCD 线阵传感器成像的几何校正模型，通过仿真实现了遥感成像的几何畸变及几何校正。

With the development of the ICF technology,the demand of the temporary fill rate of terminal pulse is higher and higher.

随着惯性约束聚变技术的不断发展，对终端脉冲的时间填充因子的要求越来越高，直接导致了对前端系统时间脉冲整形技术的要求也越来越高。

It can be seen from the model that the two valve controlled motors would be coupled with each other if the characteristic of variable displacement pump is taken into account.

探讨了由变量泵为液压源、2个阀控马达为执行元件以及惯性负载组成的液压控制系统的数学描述，并给出了其线性化模型。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。