情况好

This method firstly determines whether a closed loop exists in the graph, and utilizes DOF reduction analysis and disturbing method to identify if the closed-loop constraints can be broken from a certain edge.

该方法能够较好的简化CAD软件中用户添加的装配约束，避免了因闭环约束造成的求解复杂度增加的情况，同时可以更好的表达实际装配的过程。

The thesis can be divided into five parts as follows: First, the structural characteristics of finned-pipe evaporator are analyzed. After selecting suitable microelement controller, the heat-transfer and mass-transfer processes are analyzed for every microelement under the conditions of dryness, wetness and frostiness. Based on previous equations, some parameters of frostiness are confirmed and the frost-growing model is set up under frost condition. Some hypotheses are postulated and with the help of the equation of mass-conservation, energy-conservation and momentum-conservation, the evaporation model which fits in the dynamic simulation is built, which set a solid foundation for system simulation. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. Third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet-parameter on evaporator. Fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio-parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping.

本文的主要内容如下：1对翅片管蒸发器结构特点进行分析，选取适当的微元控制体，就干、湿和霜工况下对每个微元分别进行传热传质分析，基于经验关系式确定霜的有关参数，对于霜工况下的霜生长建立模型，经适当假设，运用质量守恒、能量守恒和动量守恒方程建立适合动态仿真的蒸发器数学模型，为系统仿真奠定基础； 2对蒸发在大扰动下的开、停机过程，运用动态集中参数模型进行分析和计算，为更好地描述制冷系统运行的全过程奠定基础，同时也为制冷系统实现自动控制提供一定的理论基础； 3对蒸发器正常运行过程，运用动态分布参数和参数间定量耦合的观点来分析和计算，为更好地了解稳态工况下各点参数的变化情况及各入口参数对蒸发器动态特性的影响即蒸发器性能对各参数变化的敏感性； 4编写翅片管蒸发器动态特性仿真计算程序，可以计算不同边界条件和初始条件下的制冷剂热力参数、空气温湿度和霜厚度分布场，实现对翅片管蒸发器在干、湿和霜工况下的动态仿真。

The results indicated that good wavelength stabilization could be obtained when a collimating cylindrical lens with diameter of 0.4 mm was used.

研究表明，在相同的工作电流、热汇温度下，当准直柱透镜直径为0.4 mm时的波长稳定效果较好；在此情况下，当热汇温度控制在30 ℃，工作电流从0.5 A增加到1.5 A的测量范围内，以及当工作电流固定在1.5 A，热汇温度从20 ℃增加到35 ℃时，测得的光谱特性表明，半导体激光器的工作波长可以很好地稳定在体布拉格光栅的布拉格波长处。

It solves the problem that the unitary contour presentation can not correctly extract face contour in a face image which suffers from scale, rotation etc. The definition of the internal and external energy function is provided. At the same time, the global matching algorithm and local matching algorithm is given. The experiment shows that this presentation and the accompanying matching algorithm can be used to extract the face contour very well. So the image segmentation can be implemented by using it.②By analyzing the recognition principle of PCA method, we can conclude that the face images coming from different surrounding consist of different face image space. This is the essential reason that makes the generality of PCA method worse. Also, we give a measurement means to measure the distance from different face image space, so we can analyze face image space more conveniently.③We also construct various scale models and rotation pose models to detect the scale and rotating angle of face image to be recognized. The experiment results show that the detecting precision is very high. So it is good for face image feature extraction and face image representation.④Similarly, we construct local feature models of face image and utilize them to detect the local feature of face image. At the same time, we put forward a novel face image local feature detection algorithm, locating step by step. The experiment results show that this method can accurately detect the location of local face feature in a image.⑤A novel face image presentation model, dual attribute graph , is put forward. Firstly, it utilizes attribute graph to present the face image, then exact the local principal component coefficient and Gabor transform coefficient of thc pixels which corresponds to the nodes of the graph as the attribute of the nodes. This representation fully makes use of the statistical characteristic of the local face feature and utilizes Gabor transform to present the topographical structure of face image. So DAG has more general property.⑥Based on the DAG presentation, we give a DAG matching function and matching algorithm. During the design of the function and algorithm, the noise factor, e. g., lighting, scale and rotation pose are considered and tried to be eliminated. So the algorithm can give more general property.⑦A general face image recognition system is implemented. The experiment show the system can get better recognition performance under the noise surrounding of lighting, scale and rotation pose.

本文在上述研究的基础上，取得了如下主要研究成果：①构造了一个通用的人脸轮廓模型表示，解决了由于人脸图象尺度、旋转等因素而使得仅用单一轮廓表示无法正确提取人脸轮廓的问题，并给出了模型内、外能函数的定义，同时给出了模型的全局与局部匹配算法，实验表明，使用这种表示形式以及匹配算法，能够较好地提取人脸图象的轮廓，可实际用于人脸图象的分割；②深入分析了PCA方法的识别机制，得出不同成象条件下的人脸图象构成不同的人脸图象空间的结论，同时指出这也是造成PCA方法通用性较差的本质原因，并给出了不同人脸空间距离的一种度量方法，使用该度量方法能够直观地对人脸图象空间进行分析；③构造了各种尺度模板、旋转姿势模板以用于探测待识人脸图象的尺度、旋转角度，实验结果表明，探测精确度很高，从而有利于人脸图象特征提取，以及图象的有效表示；④构造了人脸图象的各局部特征模板，用于人脸图象局部特征的探测；同时提出了一种新的人脸图象局部特征探测法---逐步求精定位法，实验结果表明，使用这种方法能够精确地得到人脸图象各局部特征的位置；⑤提出了一种新的人脸图象表示法---双属性图表示法；利用属性图来表示人脸图象，并提取图节点对应图象位置的局部主成分特征系数以及Gabor变换系数作为图节点的属性，这种表示方法充分利用了人脸图象的局部特征的统计特性，并且使用Gabor变换来反映人脸图象的拓扑结构，从而使得双属性图表示法具有较强的通用性；⑥在双属性图表示的基础上，给出双属性图匹配函数及匹配算法，在函数及算法设计过程中，考虑并解决了光照、尺度、旋转姿势变化等因素对人脸图象识别的影响，使得匹配算法具有较强的通用性；⑦设计并实现了一个通用的人脸图象识别系统，实验结果表明，该系统在图象光照、尺度、旋转姿势情况下，得到了较好的识别效果。

Comparing with the observation results, the biggest average error of four observation well is 0.14 m in the simulation, the positive and negative error is relatively equal, and the stability of system is better, which means the simulation model accords with the reality of the studying region.

模拟结果与观测结果比较，4个观测孔的平均水位误差最大值为0.14m，正负误差比较均衡，系统稳定性较好，表明所构建的数学模型与研究区域实际情况吻合较好。

With the investigation of the domestic and foreign literature systematically, the bases on the domestic and foreign present research and the comprehensive utilizations of the various knowledge of fluid mechanics in porous medium, reservoir engineering, mathematical physics, perforation completion, numerical simulation and so on, this article takes numerical simulation of gas reservoir of water solubility as the research aim which has completed following research works and obtained the corresponding research results: it analyzes the nature of the Water-soluble gas and formation water as well as the influent factors of the solubility through the study of massive materials; It establishes mathematical models three-dimension, the dual medium, the gas-water phase through the way of finite difference in the migration of water-soluble gas, which describes the entire process of release, migration and production in formation, where it considered the problems of variable bubble point; According to the numerical models of gas reservoir of water solubility it provides solution procedure that based on black oil model; It discovers that there will obtain the good effects in the lowly speed of development through simulation; the reinjection of formation water may largely enhance the produce degree of water-soluble gas when we consider reinjection in simulator; It considered the influence of perforated completion on development so as to increase the simulator"s versatility, It discovers that the simulator may reflect the conditions of development when we exanimate he simulator"s reliability with the empirical datum.

本文以水溶性气藏数值模拟研究为研究目标，在系统调研国内外文献、深入分析国内外研究现状的基础上，综合利用渗流力学、油气藏工程、数学物理方法、射孔完井以及数值模拟理论等多方面的知识，完成了以下研究工作并取得相应的研究成果；①通过对大量的资料调研，分析了水溶气、地层水性质、储层地质性质以及影响气体在水中溶解度的因素。②考虑到由于高压产生的大量水力裂缝，采用有限差分方法建立水溶气运移的三维、双重介质、气-水两相全隐式数学模型，该模型描述了水溶气在地层中的释放、运移和采出的整个过程。③在原有黑油模型的基础上，根据水溶性气藏数值模型编制了该数值模型的求解程序，该程序可以求解单重、双重介质两种情况。④通过模拟不同开采速度对水溶气开发效果的影响，发现开采速度较慢的时候可以取得较好的开采效果。⑤在模拟器中考虑了注水对水溶性气藏开发的影响，地层水回注可以大幅度提高水溶气的采出程度。⑥为增加模拟器的通用性，在模拟器中考虑了射孔完井方式对开采的影响。⑦检验模拟器计算的可靠性，发现在使用实验数据对水溶性气藏进行模拟时，模拟器可以很好的反映气藏开发的状态。

If the kiln should stop to Overhaul, work should be down, and make a heavy economic loss. As a part of kiln measure, the kiln"s ovality measure can reflect the status of kiln"s firebrick and shell.

作为水泥回转窑检测的一部分，椭圆度的测量，可以很好的反映出水泥回转窑的衬砖和筒体状况，从而对回转窑的运转情况，提供一个很好的指导数据。

Hopefully I'm more used to it now and I want to get off to a good start in the coming season.

希望我能更好的习惯这种情况，并且我想在即将到来的新赛季有个好的开始。

You please to consider him—has no sense of good and right, and prays from the heartvictim, Hippolytus, but the son has such a sense?

但若这位父亲，年老的或年轻的，你喜欢怎么说都行，不知道什么是好的和对的，只是依照自身的欲望进行祈求，就好像忒修斯与他那不幸的牺牲品希波吕忒，但这位儿子却知道什么是好的和对的，在这种情况下又会怎么样？

In order to analyze the availability of mobile ad-hoc networks, a homogeneous continuous time Markov chain model was constructed and the probability of steady state was solved well through the model in normal condition, that is, the steady state is of availability.

为了能更好地分析移动自组网的可用性，构造了一个齐次的连续时间Markov链模型，并且通过该模型能够很好地求解系统在正常情况下稳态的概率，即稳态的可用性。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。