悬臂

An early kind of cantilever construction was the corbel; it had its origin in the late Stone Age and can be found in the form of corbelled domes built in Sardinia about

早期的悬臂结构就是枕梁；它起源于石器时代晚期，被发现与公元前2500年的撒丁岛，以一种承材支撑的圆屋顶形式。

Ansys-finite element analysis is used to figure out the capability of steel corbel reinforcing the negative bending moment part of continuous beam or cantilever beam in reducing stress peak.

本文采用有限元计算手段分析了在悬臂粱或连续梁负弯矩梁底粘锚钢支托牛腿加固对应力峰值的削减作用，并予以实例证

Sometimes cantilevered walls are buttressed on the front, or include a counterfort on the back, to improve stability against high loads.

有时悬臂墙的前面需要加强，或者在墙背设置要塞，以提高抗高负荷稳定性。

The basic structure of the gyroscope is a cantilever beam mass structure. The cross section of the beam is rectangular.

陀螺的基本振动结构为悬臂梁-质量块结构，梁的截面为接近于正方形的矩形。

Therefore, for the continuous beam bridges which adopt the cantilever erection method, the marked elevation of dado must be measured accurately in the stage of prefabricating beams, and the elevation of the geometry of bridge must be calculated correctly.

如果桥梁施工线形控制不严，桥梁的线形就会不顺，合拢段就会出现不允许的高差，将会影响到预应力钢束的穿束工作，增大钢束张拉阻力；悬臂拼装施工方法还有线形可调性小等缺点。

A new method of controlled piezoelectric damping is proposed, and its effectiveness is verified by a case study.

文中给出一种新型的半主动分支电路的可控压电阻尼技术，并以一个悬臂梁为例，对该方法的有效性进行验证。

Our products mainly include all kinds of electric and hydraulic windlass and capstan used in oceanographic ship,all kinds of electric,hydraulic and pneumatic crane,crooked arm crane,telescopic crane,oil davit,wave compensate crane,electric hoist cantilever crane and so on,and steering gear,block,boat landing equipment,elevator for kitchen,pulling equipment for oil tanker in an emergency and other deck.

本公司的主要产品有各种船用、平台用电动、液压、气动起重机、折臂吊、伸缩吊、输油管吊、波浪补偿吊、电动葫芦悬臂吊、各种船用电动、液压起锚机、绞盘、系泊绞车，以及起艇机、艇架、艇筏降落装置、厨房升降机、油船应急拖带装置等船舶甲板设备。

During construction, typical sections are selected to carry out the temperature field test and the elevation of girder of T structure is measured synchronously. The changing character of temperature gradient and its 2 key parameters are generalized and the deflexion of"T"structure is analyzed in view of temperature field.

在施工过程中，选取典型断面进行了温度场试验，并对最大悬臂状态的T构主梁的线形进行了同步观测，总结了温度梯度及其两个主要参数的变化规律，将三维温度场问题简化为一维温度梯度问题。

Firstly, the relationship of Atomic force and distance is studied. The scan type of samples and the working mode of probe is confirmed, then PZT is chosen as actuator for micro scan displacement, and optical deflexion method is used to detect the deflexion value of cantilever. After all these work, the system light path design is finished, and its mathematical model is completed.

首先，分析了原子力探针系统的中原子力–距离的关系，并确定探针系统的探针的工作模式和样品的扫描模式，从而选择压电陶瓷作为扫描微位移驱动器；采用光学偏转法检测微悬臂偏转量，并选用了PSD作为传感元件，并在此基础上进行了系统光路设计及其数学模型的建立。

Comparison of inflection between the using of linear and nonlinear function to simulate the defluxion of the cantilever was made in this paper.

并比较了分别用线性、非线性函数模拟悬臂梁偏转对系统动力学行为的不同影响，发现了分岔图出现跳跃这一光滑系统常见的现象。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。