悬臂

Last, Nano Indenter XP was used to measure the mechanical properties of the fabricated probe structures, the results show that the spring constants of cantilever type and simply supported beam type probe structures were 2556 Nm-1 and 26280 Nm-1 respectively, which were close to the designed values of 2838 Nm-1 and 23935 Nm-1 with the error of 9.94% and 8.92%. DC probes and HP 4194A Impedance/Gain-phase Analyzer were adopted to measure the electrical properties of the simply supported beam probe card. The contact resistance from the probe tip to the end of stripline was 0.6Ω. In the frequency range of 5 to 40 MHz, the characterized impedance between two probes was larger than 20 kΩ, and the capacitance was from 0.17 pF to 0.27 pF.

采用Nano Indenter XP纳米压痕仪对制备后的探卡结构进行力学性能测试，测得悬臂梁和简支梁的弹簧常数分别为2556 Nm-1和26280 Nm-1，与2838Nm-1和23935 Nm-1的理论设计值相差9.94%和8.92%；采用直流探针和HP 4194A阻抗分析仪对简支梁型探卡结构进行了电学性能测试，从简支梁探针到引线末端的直流接触电阻为0.6Ω，在5-40 MHz范围内，探针间特征阻抗大于20 kΩ，电容在0.17 pF至0.27 pF之间，测试结果表明探针的接触电阻小、射频隔离性能好。2。

Aiming at the existing situation that it is high difficulty of using cradle casting construction of continue box beam bridge,it introduces the laying out methods of deform detection point and pressure detection point in the construction of the project,and analyses the detection effect.

针对连续箱梁桥采用挂篮现浇悬臂施工难度大的现状，介绍了其工程施工中变形测点和应力测点的布置方法，并分析了其监控结果，通过现场施工，证明了该桥的施工控制达到了设计要求。

Chain electric hoist used to load and movements along the cantilever moving to Change the purpose.

环链电动葫芦用来升降载荷并沿悬臂移动达到变幅的目的。

This paper presents several kinds of IC Wafer testing probe card for Semiconductor Packaging and chip test.There are epoxy ring probe、vertical probe card micro spring probe card,and MEMS probe card.

本文简单介绍半导体产业集成电路芯片测试用探针卡，分为以悬臂梁方式的环氧探针、垂直探针和微弹簧丝探针，以及基于微机电系统的MEMS probe card。

In the end, contrasting to measurement value and theoretical value of the deflection and roll angle for the equivalent intensity cantilever beam, it's proved that this measurement system works at a high accuracy.

最后通过对等强度悬臂梁的挠度和转角测量，并与理论结果进行比较，证实本实验测试系统和分析方法具有较高的精度。

Moreover,according to this method,the deflection curve equation of other kinds of variable section beam will be also carried out.

本文利用积分法求出了变截面悬臂梁在各种不同载荷作用下的挠曲线方程，而对于其它类型的变截面梁，都可以按照这种方法去求解。

But the deformation curve of large deformation satisfy more boundary conditions

变形模型沿用了王汝樑方法的远端弹性地基梁及近端悬臂梁模型，但大变形段的变形曲线满足了更多的边界条件

The cantilever erection method with derrick crane provides a new way for design and construction of long-span suspension bridge with steel stiffening truss girder in the western area of China.

桥面吊机悬臂拼装方案为我国西部地区大跨钢桁加劲梁悬索桥的设计和施工提供了1种新的方法。

"Derrick:a machine for hoist ing and moving heavy objects, consisting of a movable boom equipped with cables and pulleys and connected to the base of an upright stationary beam."

悬臂起重机：提升和移动重物的机器，它由一个带有缆绳和滑轮的可移动的、并与一根由向上静止横梁的底座连接的起重杆组成。

Of bridge could be improved Truss lifting tool adopts for derrick mast hoist that had been made by our unit, readymade member will be lifted and positioned. It is of the feature of simple construction equipment and quick construction progress and a potential of popularization.

桁架部分采用自制的人字扒杆吊机作为吊具，将预制的构件吊起进行悬臂拼装就位，施工设备简单，进度快，具有一定的推广潜力。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。