悬臂

The vibration signals from a free vibrated cantilever beam are carried on Fast Fourier Transformation and spectrum analysis.

采集悬臂梁自由振动下的声发射信号，并对信号进行快速傅里叶变换和频谱分析。

Secondly, the cantilever beam and the center pole each part of finite elements modeling, examined each part of intensities and the rigidity, made the further revision design to the unreasonable design, got up to the overall frame analysis uniformity.

其次，本文对堆取料机的悬臂梁和中心柱各部分有限元建模，校核各部分的强度与刚度，对不合理的设计作了进一步的修改设计，起到了整体框架的分析一致性。

The blades are modeled as cantilever beams fixed on the disk. The equations of motion of the system are derived. The eigenvectors are obtained by solving the eigenvalues of the system and the localized modes of vibration in mistuned systems are further gotten.

采用固定在轮盘上的悬臂梁模型来模拟叶片，推导了结构系统的运动方程表达式，求解特征值问题获得了结构系统的特征向量，进而得到了失谐结构的局部化的振动模态。

LQRY series hot oil pump is the second generation developed on the basis of the oil pumps abroad, basically structured as single stage single entry overhung foot supported. Pump inlet is axial suction, and outlet has its center vertically upward, which are mounted, together with the motor, at the bottom.

LQRY系列热油泵是本单位消化吸收国外油泵的基础上研制的第二代产品，基本结构形式为单级单吸悬臂式脚支撑结构，泵的进口为轴向吸入，出口为中心垂直向上，和电机同装于底座上。

QCRY series hot oil pump is the second generation developed on the basis of the oil pumps abroad, basically structured as single stage single entry overhung foot supported. Pump inlet is axial suction, and outlet has its center vertically upward, which are mounted, together with the motor, at the bottom.

QCRY系列热油泵是本单位消化吸收国外油泵的基础上研制的第二代产品，基本结构形式为单级单吸悬臂式脚支撑结构，泵的进口为轴向吸入，出口为中心垂直向上，和电机同装于底座上。

In liquid, the low quality factor of the microcantilever in tapping mode limits the force sensitivity and imaging resolution of atomic force microscopy.

液体中轻敲模式下微悬臂梁的低品质因数会限制原子力显微镜的力灵敏度和成像分辨率，品质因数调控技术可以提高品质因数。

Then,according to the characteristics of LER measurement and characterization method,the influence factors of LER measurements using AFM,including the nonideal properties of the sizes and shapes of probe tips,the signal noises of AFM images,scan sampling intervals,the driving precision of piezoelectricity,cantilever oscillation and the free parameters of edge detection algorithm and so on,are analyzed theoretically and experimentally,and the methods for restraining and amending the measuring errors are respectively proposed.

然后，根据线边缘粗糙度测量与表征的特点，对各种影响因素，包括探针针尖尺寸与形状的非理想性、AFM扫描图像的噪声、扫描采样间隔、压电晶体驱动精度、悬臂梁振动以及线边缘检测算法中的自由参数等进行了理论和实验分析，并分别提出了抑制及修正的方法。

The series solution of lateral free vibration of variable cross--section cantilever beam, when shear flexibility is taken into account, is given in the dissertation.

对上述截面变化规律的弯曲悬臂杆，当考虑剪切变形时，其自由振动微分方程为变系数的四阶微分方程。

In the FWT test, not the interfacial debonding, but the interlaminar delamination was observed. So the test results show that the interfacial peel strength is higher than the interlaminar peel strength. From the results of DCB experiment, a different fracture mode, namely IKP (initiation of interlaminar delamination, kinking into facesheet and propagation of interlaminar delamination), was found.

在平面拉伸试验中，发现的破坏模式不是预期的面芯界面脱胶破坏而是面板层间分层破坏；在双悬臂梁试验中，发现了一种与以往文献报导中不同的破坏模式(面板层间分层，预制裂纹偏转和面板分层扩展依次出现)。

The purpose of this research is to investigate the stability influence of side slope from the environment before/after road development in mountain area. Suitable side slope protection practices were chosen at that time according to the damage of the collapse. These practices are box gabion, net-paved plant, pilling and railing, and mortar bond, cantilever retaining wall, gravity retaining wall, etc. The ecosystem environment can be protected and maintained continuously by these practices.

本研究之目的在探讨山区道路开辟前、后环境对边坡稳定影响，并依据崩塌损坏情况，以现场环境条件选择适当边坡保护工法，本区以箱型蛇笼、铺网植生、打桩编栅、浆砌块石等各工法成效，以维护动植物生长环境与维持原生物种栖息环境之生态工法，及依据实地现况因地制宜配合，以悬臂式挡土墙、重力式挡土墙等工法确切保护边坡，维护道路通行安全与顺畅。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。