悬浮液

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

They can be used for separating the suspension with solid phase particle size of more than 0.1mm and with the concentration of 30-80%, especially suitable for chemical industry and light industry, such as the processing of mirabilite, salt and polassium fertilizer.

适合分离含固相物(结晶状、无定形或短纤维状)粒度大于0.1mm，浓度范围为30-80%的悬浮液。适用于轻工、化工等行业，如芒硝、食盐、钾肥等产品加工。

The dilute hydrochloric acid concentration, Ti/clay ratio, H/Ti ratio, the pillaring reaction temperature, the aging time of pillaring agent and the initial concentration of clay greatly affect the formation of Ti-PILC.

结果表明，盐酸的浓度、Ti／土比、H／Ti比、交联温度、交联剂老化时间和粘土悬浮液浓度等制备条件对钛交联蒙脱石的物化性能有较大的影响。

Settleable solids can be quantified for a suspension using an Imhoff tank or cone.

悬浮液中的沉淀性固体可用双层沉淀池或锥形沉淀池定量测定。

The comparison test of this new methodwith spray inoculation method was conducted. The results showed the former method could increase the incidence ofdisease and uniformity than the latter one. Used cotyledon-brushing with conidial suspension and fungicide foliarspraying method, the EC 50 values of hexaconazole, myclobutanil, triadimefon, thiophanate-methyl and chlorotha lonil to Sphaerotheca fuliginea treated in different time after inoculation were determined; the results showed that 96 h was better time for disease severity evaluating.

比较了白粉病菌分生孢子悬浮液涂抹法和喷雾法接种黄瓜幼苗子叶的效果，结果表明，涂抹法发病率高，均匀度更好；测定了接菌后不同时间施药，白粉病菌对己唑醇、腈菌唑、三唑酮、甲基硫菌灵和百菌清等 5 种杀菌剂的敏感性，结果表明，接菌后 96h 施药较为敏感，测得的 EC 50 较小。

A colloidally stable suspension of nanoparticles was incubated on sheep synovial cells in vitro for 3, 24, 72, and 120 hours.

将纳米颗粒胶质的稳定悬浮液与羊滑膜细胞体外培养3、24、72和120小时。

The synthesis of terephthalic acid by indirect electro-oxidation was studied and the optimum conditions were examined.

研究用UV/TiO2悬浮液光催化氧化和间接电氧化相结合的方法降解一种模型有机污染物———碱性品红。

Through bulk copolymerization of octamethylcyclotetra siloxane and aminosilan monomer named N-β-aminoethyl-γ-aminopropyl methyl dymethoxysilane, an amino silicon oil was prepared.The comparison of effect of KOH and tetramethyl ammonium hydroxide as catalyst of the reaction with different status filled in was carried through.

本文首先进行了氢氧化钾和四甲基氢氧化铵催化性能和催化剂加入方法的研究，证实氢氧化钾作为催化剂其催化性能受到实际分散程度的显著影响，因此制备催化剂悬浮液是必须的；而KOH本身易于吸收水分和空气中的二氧化碳，同时反应对水分敏感，氢氧化钾实际表现出的催化性能不理想。

The results indicate that the deviation of viscosity concentration is still not acceptable for most of the pigments, although the solid content of pigment slurry is well linear with the reciprocal of the square root of viscosity. Furthermore, the slight fluctuation of solid content which is close to the viscosity concentration can cause significant variation of the low shear viscosity according to the calculation, and result in the uncredible test value of viscosity concentration.

结果表明，尽管颜料悬浮液固含量与黏度平方根倒数的线性关系相当好，但对于相当一部分颜料，由此得到的黏浓度数据偏差仍然不可接受；而且根据测算，在黏浓度点附近，固含量的微小波动会造成低剪切黏度很大的变化，导致黏浓度的测定结果不可靠。

Suspensions of field samples suspected to contain FMD virus should be clarified and inoculated into cell cultures or unweaned mice.

将可疑含FMD病毒的田间样品酊悬浮液经澄清后接种于细胞培养物或未断奶乳鼠。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。