悬浮

The method comprises conducting surface treatment forCNTs to make it hydrophilism: mixing it with dispersant and deionized water and getting the CNTs-water slurry; modifying the pH value to 9~12; mixing with natural latex and getting the natural rubber liquid latex added with CNTs.

制备方法为首先对CNTs进行表面处理，使其具有亲水性：然后将其与分散剂、去离子水混合，得到CNTs-水悬浮液；调节该悬浮液的pH值到9～12；最后与天然胶乳均匀混合，得到添加CNTs的天然橡胶液体浆料。

It is noted that there exits a relationship between the levitation capability and the levitator geometry.

本文注意到，声悬浮能力和悬浮器几何参数之间存在着一定关系。

Single-axis acoustic levitation was investigated by a BEM model corresponding to our levitator and the levitation characteristics were revealed.

采用边界元方法对单轴式声悬浮过程中的入射声场计算，揭示了样品在声悬浮过程中的受力特性。

For a gas medium, the levitation force is determined not only by the ratio of its density to sound speed, but also by the ratios of its wavelength to the geometric parameters of the levitator.

发现不同媒质中产生的最大悬浮力不仅取决于媒质密度与声速之比，还取决于该媒质的波长与悬浮器几何参数的相对大小。

And the conditions in cell suspension culture of Mikania micrantha were studied. The results showed that sucrose was the compatible carbon sucrose, and 30g/L sucrose concentration can satisfy the growth of Mikania micrantha cell; ammonium was absorbed under different sucrose concentration that haven't demonstrated significant specificity, and was completely absorbed on the lag phase and the early logarithmic phase; while nitrate was mainly absorbed on logarithmic phase. The density-dependent of Mikania micrantha cell starting to grow and density-inhibited of cell growth were proposed, the fittest inoculating quantity of Mikania micrantha in cell suspension culture was 40g/L.

并对微甘菊细胞悬浮培养条件进行研究，结果表明，微甘菊细胞生长适宜的碳源是蔗糖，并且较合适的蔗糖浓度为30g／L；在不同蔗糖浓度下氨基氮的吸收差别不大，氨基氮在迟滞期和对数期前期已基本消耗完毕，对数期生长主要利用硝基氮，因而提出，在微甘菊细胞液体悬浮培养中，氮源可以采用初始低氨基氮浓度，对数期中间维持高硝基氮，而且对数期中逐步流加少量的氨基氮；微甘菊细胞迟滞期分裂启动存在密度依赖现象，对数期生长存在密度抑制现象，最适接种量为40g／L。

Our results showed that the cultures with 5 days of preculture in liquid suspension produced the highest chondrocyte representative matrix of sulfated glycosaminoglycan compared to those with I or 3 days in suspension.

我们的实验结果显示，先经过5天悬浮培养之细胞相较於1天或3天悬浮培养之细胞，能产生最高量软骨基质之代表成分&具硫酸基之聚葡萄糖胺&。

It presents test results of performance for three structural types of cement stabilized macadam including suspend-dense structure framework-dense structure and framework-pore structure, for two structural types of lime fly-ash macadam including suspend-dense structure and framework-dense structure, and for cement stabilized soil. By the probability analysis of Weibull on the results of fatigue test, the paper has a serial of fatigue prefigurative models. What's more, amends these models linking to the factual pavement performance.

在对三种结构的水泥稳定碎石(悬浮密实结构、骨架密实结构、骨架空隙结构)、两种结构的二灰稳定碎石(悬浮密实结构、骨架密实结构)、均匀密实结构的水泥稳定细料土进行室内三分点加载疲劳试验的基础上，采用威布尔分布理论对疲劳数据进行处理，得到各自的室内疲劳预估模型，并结合实际路面的情况对室内疲劳预估模型进行修正。

The resuspension rate of the two kinds sediment shows different relationship for the excess shear stress. Thus, the paper adopts the different formulas to solve them.

两种形态的泥沙再悬浮率与净底床切应力显示出的不同关系，因而对不同形态的床沙采用不同的再悬浮率计算公式。

The high average temperature aerosol track throwout lever type tunnel kiln (PCS textile fiber preoxidized tunnel kiln), uses 15 microcomputer minute 15 area high accuracy procedure to control warm, the different vacuum seal air blower, various areas different stainless steel air flue, passes through aerosol

高均温悬浮轨道推杆式隧道窑（PCS纤维预氧化隧道窑），采用十五台微电脑分十五区高精度程序控温，不同真空密封风机，各区不同不锈钢风道，经过悬浮轨道和不锈钢网状料盘进行完整的热风循环。

The second part was to test the appearance, ingredient analysis, surface potential, thermal conduction properties, and magnetism of the nano composite fluid prepared from the parameters. The experiment found that unoxidized particles, Ag, Cu, Fe, and Ni appeared round. If combined with oxygen in water as oxides, the nano particles would grow toward certain directions. In copper/iron nano composite fluid, FeO appeared cubic, Cu2O appeared coniferous. In silver/iron nano composite fluid, FeO was polygonal. In dielectric potential detection, the nano composite fluid was likely to aggregate and deposit, except for silver/iron set. In other sets, the pH of silver/cobalt nano composite fluid was 7, surface potential was 21.21mV; the pH for silver/nickel nano composite fluid was 6.5, surface potential was 21.04mV; the pH for copper/iron nano composite fluid was 7, surface potential was -30mV. The fluid particles of the three sets could all maintain suspension of 2 weeks or more. For thermal conduction, the silver/nickel, nano composite fluid showed the best thermal conduction. Under temperature of 30℃ fluid weight conduction of 0.4%, the thermal conduction increase was 26%. For magnetic detection, except for silver/iron nano composite fluid, the nano particles of other three sets were paramagnetic, and all four sets were soft magnetic nano composite materials.

第二部分。将由较佳制备参数所产出的奈米复合流体，进行形貌外观、成分分析、表面电位及热传导性质实验与磁性检测；在奈米颗粒的形貌部分，经实验发现Ag、Cu、Fe、Ni等未氧化的颗粒皆呈现近似圆形，而若与水中的氧结合形成氧化物，奈米颗粒则会朝特定方向成长，在铜/铁奈米复合流体中FeO为四方体结构、Cu2O的颗粒是针叶状，在银/铁奈米复合流体中FeO则为多边形结构；而介面电位检测方面，结果显示经本制程所产出的奈米复合流体除银/铁奈米复合流体这一组较容易聚集沉淀外，其他三组中银/钴奈米复合流体的pH值为7，表面电位为21.21mV，银/镍奈米复合流体的pH值6.5表面电位为21.04mV而铜/铁奈米复合流体的pH值为7时表面电位约在-30mV，且此三组流体颗粒皆能维持悬浮性2周以上，悬浮性较佳；热传导实验部分，四组奈米复合流体中以银/镍奈米复合流体在增进热传上效果最佳，在温度30℃及流体重量浓度0.4﹪条件下热传导系数增进达26﹪；磁检测方面，除了银/铁奈米复合流体外，其他三组奈米颗粒皆属顺磁性，且这四组奈米复合材料都是属软磁性。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。