微膜

The ciliature microtubular organelles in the ventral cortex of Urostyla grandis were visualized by direct fluorescent labeling of FLUTAX .The organelles consist of adoral zone of membranelles, undulating membranes,frontal-midventral-transverse cirri,left and right marginal cirriand the base-associated microtubules,etc.

应用荧光紫杉醇直接荧光标记显示，腹毛目纤毛虫大尾柱虫 Urostyla grandis 腹皮层纤毛器微管胞器由口围带、波动膜、额腹横棘毛和左、右缘棘毛等纤毛器微管、纤毛器基部附属微管等组成。

Microcells were produced by centrifugation of micronucleated A9 (neo12) cells in Percoll density gradient containing 20 mg/L Cytochalasin B at 39 000 g. The resulting mixture of microcells, whole cells, karyoplasts and cytoplast fragments was filtered through 8 μm and 5 μm size membrane pores sequentially to obtain pure preparation of microcells.

微核化的细胞在含有20 mg/L细胞松弛B的Percoll密度梯度介质中，经39 000g高速离心后，包含微细胞、完整细胞、细胞核和细胞碎片的混合液，依次通过8 μm和5μm孔径的滤膜过滤后可获得纯化的微细胞溶液。

Microcells were produced by centrifugation of micronucleated A9 (neol2) cells in Percoll density gradient containing 20mg/L Cytochalasin B at 39 000g. The resulting mixture of microcells, whole cells, karyoplasts and cytoplast fragments was filtered through 8 pm and 5 pm size membrane pores sequentially to obtain pure preparation of microcells.

微核化的细胞在含有20mg/L细胞松弛B的Percoll密度梯度介质中，经39000g高速离心后，包含微细胞、完整细胞、细胞核和细胞碎片的混合液，依次通过8μm和5μm孔径的滤膜过滤后可获得纯化的微细胞溶液。

Some new organizational patterns of microtubules (that have not been described before) were observed during microsporogenesis, including the existence of a broad band of perinuclear microtubules at the diakinesis stage of development.

主要包括：(1)在细线期，从核膜向胞质衍射的微管呈螺旋状，显示核具旋转功能；(2 )在偶线期，微管的分布呈极性分布现象；(3)在终变期，核被一组微管形成的宽带围绕着。

Meanwhile, heating power of the rear face heater was also one of the main factors that affected bubbles incipience and diameters.

结果表明，微通道内不稳定性流动沸腾的振动流态，是铂膜上形成各种泡并以不同方式脱离铂膜的原因；背面加热膜的功率大小也是影响铂膜长泡以及汽泡大小的主要因素之一。

In resting cysts, the microtubules under the pellicle, cortical ciliatures, conjunctions between cilia basal bodies, supporting structure of basal bodies and other microtubule structures are absorbed in different extent; microtubule-like assemble bodies appear at the center of the remained cilia basal bodies; the granules of chromatin and nucleolus in macronucleus become smaller whereas nucleus pores of the micronucleus become bigger; the inner membrane of some nucleus pores are attached with chromatin.

结果表明：纤毛虫形成包囊过程中，皮层细胞质中产生具有自噬泡消化特征的细胞器，将部分纤毛结构等逐步消化；休眠包囊中，表膜下微管、皮层纤毛器和纤毛基体间连接、基体托架及其他微管结构不同程度地被吸收、在残剩纤毛基体的中央形成微管形结构聚合体，大核染色质和核仁颗粒变小，核孔增大，并发生染色质附着于核孔内膜的现象；细胞脱包囊期间，皮层细胞骨架、线粒体等经历了在残剩结构基础上的再分化。

The electropolymerization of Cobalt tetraaminophthalocyanine on gold electrode has been studied by cyclic voltammetry and electrochemical quartz crystal microbalance.

采用循环伏安法和石英晶体微天平技术对四氨基钴酞菁在金电极上的聚合成膜过程进行了研究，考察了扫描速度、溶剂、支持电解质及单体浓度对其成膜过程的影响，同时初步探讨了聚合膜分别在非水溶液和水溶液中的氧化还原行为及稳定性，其中借助EQCM重点讨论了在这些过程中溶液中离子在膜中传输的机理。

In previous studies, only spherulitic structures of PVDF membranes prepared by PVDF/single diluent systems via solid-liquid phase separation were obtained. The PVDF membranes with spherulitic structures always present poor mechanical properties, dense skin layers and wide pore size distribution.

在以往的研究中，PVDF微孔膜大多数选用的是单一稀释剂，通过发生固—液相分离制备的，所得到的膜结构都是球晶状结构，具备这种结构的膜往往存在膜的力学强度差、皮层致密和孔径分布宽等缺点。

The interface between oxide film and substrate is distinctive, but there is no obvious interface between electrolytic coloring film and oxide film, which indicates that coloring metal is deposited in micropores.

图纹处氧化膜较厚，无图纹部分较薄，氧化膜与基体界面分明，而电解着色膜与氧化膜无明显的分界面，说明着色金属是沉积在多孔层微孔内。

EDAX and talysurf. There were four wear regimes for KRF/GCI, during the starting friction period abrasion was dominant, when the process of the formation and break of transfer layers was balanced the main wear mechanisms were adhesion and fatigue, mild melt wear was found at higher temperature. For KRF/MMC, the dominant wear mechanisms were ploughing and microcuting during the running-in, when transfer layer formed, the film-film adhesion at the interface became dominant and mild melt wear occurred also at high temperature.

对于KRF/GCI，在摩擦的起始阶段主要是二体磨粒磨损，当表面转移膜的形成与破坏形成动态平衡时，粘着磨损和疲劳磨损是主要磨损机理，摩擦表面温度较高时，产生严重的粘着磨损和轻微的熔融磨损；而KRF/MMC在跑合过程中，SiCp对较软材料的犁削、微切削是主要摩擦磨损机理，转移膜形成后，表面的膜—膜粘着则为主要摩擦磨损机理，高温下也会发生轻微的熔融。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。