径间的

There exists a close relation between growth characteristics and wood properties of the provenance. The height and breast height diameter growth of the provenance had a positive correlation with tracheid diameter and annual ring width, and a negative correlation with tracheid wall thickness and wood density.

种源生长与材质性状间存在一定的相关关系，如种源的高径生长与管胞直径和年轮宽之间存在正相关，而与管胞壁厚和木材密度之间却存在一定程度的负相关。

Little quantity of sulphur occur in forms of enclave and anhedraal,subhedral,euhedral crystal. The crystal size ranges from0.01mm to1. 00mm and little of size around 1μm.

少量呈包体形式产出，它形～半自形～自形晶，粒径在0.01mm～1mm间，极少量的在1μm这些硫化物中的硫，含量略低于其相应矿物的硫的含量。

It can be used to design and calculate the oil proof sump with tilted plate.

对于斜板隔油池，考虑到板间液流的速度分布和油滴的粒径分布，提出一个油滴脱除率的计算方法，可用于斜板隔油池的设计计算

The onset temperature (T0), peak temperature, conclusion temperature and gelatinization enthalpy in DSC thermogram of rice starch were higher for the samples of high temperature regime than for the samples of optimum temperature.

不同品种类型间虽然存在着一定的差异，但变化规律基本一致；灌浆结实期温度明显影响淀粉粒的粒径大小，表现为高温处理下，直径大于7协m的大淀粉粒明显增多，而直径小于4林m的小淀粉粒明显减少。

150HP-300HP screw air compressor rotor is the German GHH-RAND joint shaft type unit,adopts the third generation asymmetrical dentate 5:6 rotors,The major axis is more reasonable than the choice, the tangent speed of rotors is only 30-36m/s, is far lower than that———60m/s of common air compressors, it keeps 0.003INCH between rotors that will not abrase forever, the space between teeth dropping variance is small, so the backflow loses is slight, Enhances10-12% kf the efficiency compared to the 4:6 dentate, save power 20%, adopts the Swden SKF bearing.

150HP-300HP）螺杆机转子为德国GHH-RAND联轴式机组，采用第三代非对称齿型为5：6的转子，长径比选择合理，其转子的切线速度仅为30'36m/s，远低于一般空压机60m/s 的切线速度，转子之间保持0.003INCH间隙永不磨损，齿间落差小，故回流损失小，比4：6齿型提高效率10-12%，省电20%，采用瑞典SKF轴承，极大延长了主机的寿命。

Br/br/Adopts the GHH-RAND remarkable mainfrane br/(150HP-300HP) screw air compressor rotor is the German GHH-RAND joint shaft type unit,adopts the third generation asymmetrical dentate 5:6 rotors,The major axis is more reasonable than the choice, the tangent speed of rotors is only 30-36m/s, is far lower than that60m/s of common air compressors, it keeps 0.003INCH between rotors that will not abrase forever, the space between teeth dropping variance is small, so the backflow loses is slight, Enhances10-12 kf the efficiency compared to the 4:6 dentate, save power 20, adopts the Swden SKF bearing.

采用GHH-RAND卓越主机br/（150HP-300HP）螺杆机转子为德国GHH-RAND联轴式机组，采用第三代非对称齿型为5：6的转子，长径比选择合理，其转子的切线速度仅为3036m/s，远低于一般空压机60m/s 的切线速度，转子之间保持0.003INCH间隙永不磨损，齿间落差小，故回流损失小，比4：6齿型提高效率10-12，省电20，采用瑞典SKF轴承，极大延长了主机的寿命。

With high carrier frequency in future communication systems and long OFDM symbol caused by and large subcarrier number, high mobile velocity that will result in fast-fading channels, will make the OFDM system suffered by the intercarrier interference.

随着未来系统的高移动速度，高载频和大子载波数所导致的长OFDM符号都将使系统的性能正越来越深地受到快速时变多径信道所带来子载波间干扰的影响。

There was enrichment of the heavier isotope of mesoplankton with increasing grain size, showing carbon isotope enrichment along trophic levels.

中型浮游动物随粒径的增大，其δ13C值增大，显示出营养层次的碳同位素富集作用，但不同粒级组分相互间δ13C值也存在着相当程度的重叠，实际上这也是其生物组分有重叠的反映。

Results: The incidence that T2-T5 ganglions located at the corresponding intercostal space was 92.7%, 85.5%, 40.0% and 36.4% respectively.

结果：星状神经节及T2～T5神经节的长径依次是（21.5 3.2）、（10.6 2.8）、（8.5 3.1）、（8.2 2.7）和（7.1 1.8）mm.T2～T5神经节出现在相应肋间水平的发生率依次是92.7%、85.5%、40.0%、36.4%。

The isospin effects on the momentum dissipation induced by the Coulomb interaction in the process of heavy-ion collissions

在改变透镜光阑口径而维持靶室离子流强度不变的测量模式中，证实了离子间库仑相互作用增大束径的效

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。