形槽的

Pcs of type slot lugs for protecting the accommodation ladder upper turning platform from being disconnected with the fixed platform were fitted at the joint place of the said two platforms, among which, 2 pcs, made of aluminum alloy, were found normal and another 2 pcs, made of iron, were corroded seriously and were only 3-4mm in thickness each, and one of them warped at its edge, thus, the turning platform could not be installed properly on the fixed platform.

设置在舷梯上转动平台与固定平台相连接处的防止脱落的四块形槽角铁，其中两块是铝合金的情况正常，另两块是铁质的，由于严重腐蚀厚度仅只 3-4 毫米，且其中一块在边缘处已卷曲，故转动平台已不能可靠地安置在固定平台上。

The dropping-down of the said 38-step std side aluminum accommodation ladder was due to the defects of the type slot lugs on the turning platform, causing the said upper turning platform departed from the fixed platform under the minor influence of the external force.

该 38 级右舷铝质舷梯发生松脱跌落的原因是由于上转动平台的形槽角铁存在缺陷，在稍受外力的影响下造成转动平台从固定平台处脱开而跌落。

An array of permalloy core solenoids is micromachined as microactuators on (100) silicon wafer. Then anisotropic etching of silicon in KOH solution forms the U-grooves beside the microactuators. The micromachining difficulties from the coexistence of 3-D MEMS devices and deep grooves on chip are overcome successfully. Then two fibers and permalloy piece are assembled onto the wafer together with the microstructures finishing the prototype of the new type MEMS VOA. Third, the inductance, resistance and Q value of the microfabricated solenoids are measured in the frequency range of 1-40 MHz.

第二，新开发了使用SU-85的正胶、负胶复合微加工工艺，在（100）硅片上加工了新型可变光衰减器的铁芯MEMS螺线管型电磁微执行器阵列；用KOH水溶液对（100）硅片进行湿法刻蚀，在电磁微执行器旁边微加工了V形槽结构组合，开发了单片集成三维MEMS器件和深槽的微加工关键技术；然后经过微装配制作出了电磁驱动的光纤偏移型MEMS可变光衰减器的样机。

These appearances including V-style rabbet, advent of bounded weak echo region, stronger wind vertical shear and phenomenon of airflow convergence in radar precipitation echoes were all typical characteristics of strong convective weather echoes.

雷达回波上的"V"形槽口、有界弱回波的出现、较强的垂直风切变以及气流辐合现象，均为强对流天气回波的典型特征。

Of a firearm; having rifling or internal spiral grooves inside the barrel.

一种火器；有膛线炮的或在来复枪内有内螺旋形槽线的。

In the first section of the tutorial, you use a predefined skeletal model, consisting of unconsumed sketches, to determine the placement and extent of frame components, such as square tubing and c-channel, and then fit those components together with miters and cuts.

在自学课程的第一节，您将使用由未消耗的草图构成的预先定义的骨架模型，来确定框架元件(如方形细配管和 C 形凹槽)的置放和实际范围，然后使这些元件与斜接和切割配合在一起。

Anthers confluent to corolla, uniformly pale and glossy with long margin and dorsal groove, apex retuse, appendages sharply delimited, ovate, scarious except for narrow midrib, covering stigma head; pollinia 2 per pollinarium, oblong, pendulous.

对花冠汇合的花药，均匀浅和和背侧具凹槽的有光泽具长边缘，先端微凹，锐的附属物限定，除了狭窄的中脉卵形，干膜质，花粉块2 每pollinarium，长方形，下垂。

The nonlinear is incarnated when the ball is rolling respectively on three concaves. The track driven by motor is in simple harmonic vibration, and the frequency and amplitude of simple harmonic vibration of the track can be considered as adjusting parameters.

以滚球在3个凹形槽上的受力体现作用的非线性，导轨由电机推动作简谐振动，滚球在导轨上作受迫振动，可以把导轨作简谐振动的频率或振幅作为调整参量。

At the same time ,it analyses the possible interference phenomenon that can be occurred in the course of machining drill bit flute by the grinding wheel cross-sectional profile solved.

同时分析了在用所求得的砂轮截形加工钻头螺旋槽的过程中可能产生的干涉现象。

As Francis describes it, the Milky Way and other spiral galaxies operate like a giant, spiral-grooved funnel into which billions of marbles are pouring.

根据弗朗西斯的描述，银河系和其他漩涡星系运行起来就象一个巨大的、带有螺旋形凹槽的漏斗，漏斗中正在注入几十亿个弹子。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。