形成边缘

These rocks are known as the Cathedral Formation, and probably represent the escarpment of a large submarine slump like those observed off the edge of carbonate platforms in areas like the Bahamas and Honduras today.

这些岩石被称为大教堂的形成，并可能代表绝壁一个大的潜艇衰退一样观察了边缘的碳酸盐平台等领域的巴哈马和洪都拉斯今天。

About 12,300 years ago, the water plunged over the edge of the Niagara Escarpment, a cliff at what is now Lewiston, New York. The force of the water wore away the rock layers, eventually reaching its present location.

大约在1.23万年以前，大量的水涌入到尼亚加拉悬崖的边缘地区，这座悬崖就座落于现在的纽约州刘易斯顿市，水流的强大力量冲蚀着岩石层，最终形成了今天的形状。

Date palms and reeds form a lush fringe along a finger of Umm al Maa Lake in the Ubari Sand Sea.

枣椰树和芦苇沿着奥巴里沙海里的Umm al Maa湖边缘形成茂盛的圈。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

As a result of this rotation, other pieces of ice and flotsam wear relatively evenly at the edges of the ice until it slowly forms into an essentially ideal circle.

由于这一轮换，其他件冰和废料磨损比较均匀边缘的冰，直到它慢慢形成一个理想基本上循环。

During the Late Triassic to Early Jurassic, a sequence of continental margin sediments and flysch were highly deformed and thrust eastward onto the rocks of the Yangtze craton while the Sichuan Basin was accumulating clastic sediments as a foredeep basin.

边缘沉淀顺序和复理层高度不成形，并向东插入到长江克拉通的岩石之上；与此同时，四川盆地不断地沉淀可分解的沉积物而形成了前渊盆地。

Many dendritic projections appeared at the adherent cells gradually observed by light microscope; By scaning electron microscope, typical"veiled"DC appeared with abundance of gauffer and the edge of the veil made of graded dendritic projections; all kinds of DC conjected and composed of cluster by the projections. 2. The percentages of CD markers were CD123/54. 5, CD11c/88. 99, CD40/56. 65, CD1a/69. 36, CD86/92. 57, CD80/70.79, CD83/85. 91. 3. The numbers of T cells expressing CD69 has been increased strikly (CD4+CD69+/19. 05%; CD8+CD69+/21. 93%). 4. The augment of percentages of CD3+, CD25+, CD45RO+/CD45RA+, CD4+/CD28and CD8+/CD28- and the decrease of CD28+ and CD45RO-/CD45RA+ in both the CD4+ and the CD8+ T cells could be exemed.

光镜下见贴壁细胞在培养过程中（7天）逐渐长出长短不一树突状突起，细胞形态不一；电镜观察到DC表面呈多层"面纱"覆盖，有大量皱褶，"面纱"边缘有长短不一的不规则的树突状突起，每个突起有多级分枝；AFM见DC细胞的"面纱"状结构是由多级树突状突起相互缠绕形成的，各个DC细胞之间的突起相互连接，构成集落； 2。

Tooth decay begins when teeth are not cleaned properly after eating.In just one hour,plaque bacteria will start converting sugar and starch particles into harmful acids that attack the tooth enamel.Within 24hours,plaque can harden to form tartar,which can only be removed by aprofessional.Help prevent tooth decay and gum disease by cleaning away plaque at the gum line each day using Glister Multi-Action Fluoride Toothpaste and rinsing with Glister Concentrated Mouthwash.

A：进食后没有适当清洁牙齿，是蛀牙的导火线短短一小时，已足够让牙垢膜细菌把糖份及淀粉质转化为有害的酸性物质，侵蚀珐琅质24小时内，牙垢膜便会硬化，形成牙石，必需由牙医清除要预防蛀牙及牙周病，建议你每天使用丽齿健氟素牙膏，清除积聚于牙龈边缘的牙垢中国化妆品代理网膜，再以丽齿健浓缩漱口水漱口

At last it points out problems in the process of development in rural-urban fringe of Huhhot.

在加快城市化进程和实现城乡统筹的大背景下，研究呼和浩特市城乡边缘区的形成、问题及对策，对于破除城乡二元结构、解决"三农问题"、实现城乡之间协调发展等方面有着十分重要的理论和现实意义。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。