形成边状

Therefore, the early use of low-permeability reservoir development Diamond Anti-9:00 Well, diamond crack parallel to the main diagonal directions along the crack edge wells to increase water efficiency by the degree of widening further suppress the injection wells, well away from the row Kadoi premature flooded, and the overall benefit of fracturing; in the latter part of the diamond-shaped anti-9:00 Well Well turn the corner to form staggered rows like water injection means, thereby maintaining a high production rate and phase out the extent of mining.

因此，低渗透油藏开发初期使用菱形反九点井网，菱形主对角线平行裂缝方向，沿裂缝注水增加边井受效程度，拉大的井距又可抑制注水井排的角井过早水淹，且利于整体压裂改造；中后期将菱形反九点井网的角井转注形成交错排状注水方式，从而保持较高的采油速度和阶段采出程度。

The investigation in surface lineal defect of rod are carried on by means of metallograph,grinding test as well as deformation test during roughing roll.

通过对试样进行金相分析，对铸坯表面修磨试验结果分析及对连铸坯在高线粗轧第1道和第2道轧制的受力和变形的分析，发现盘条表面的一种特殊的线状缺陷形成的原因是连铸坯存在边内裂和皮下气泡，粗轧机组(特别是第1和第2架)孔型设计不合理，也促进这种线状缺陷的形成。

The foundation of arch dam usually is layer rock base, and the depths of the layer are small, it is common that several layer rock base contact with one layer element grid. According to the geometry relation and the property of shape function, a new element kind that includes 24 nodes has been proposed to dissect the dam and foundation effectively, whose shape function are independent. In fact the element can be looked as a hexahedron divided into five small hexahedrons. It can be simulate all kind of the condition of the base and the dam.

拱坝的地基一般是层状岩石地基，有的层厚度很小，这样就有多个岩层和坝体某层单元接触，本文根据岩基与坝体接触的几何关系，利用形函数的性质，提出24节点六面体层单元，这种单元实际上是将一个厚的六面体单元分成5个更薄的六面体单元而形成的，其形函数采用可以拆分的形式表达，因此可以方便地解决坝体单元的一、二、三、四个面与错动带接触的情况，可以模拟一、二、三、四个棱边与错动带接触的情况，还可以退化为12节点的四边形面单元，以及五面体层单元。

Using maximum flooding surface and local explosure erosion surface as the correlation framework surface in the 4-th hierarchical base-level cycles, sand-body in the 3-th hierarchical base-level cycles formed in the 4-th hierarchical base-level cycles may be correlated layer by layer. The law of the sand-body and the characters of reservoir heterogeneity formed in the 4-th hierarchical base-level cycles are discussed. The study shows:①During early period of the 4-th hierarchical base-level cycle rising, subaqueous distributary channel formed, continuously stacked vertically, and migrated in limit range laterally, and channel sand-body stretches farther longitudinally, and lacks interbeds of mud rock and siltsand in sand rock, reservoir heterogeneity is relatively weak.②During mid-period of the 4-th hierarchical base-level cycle rising, subsaqueous distributary channel migrated actively, channel divided and converged strongly to form netted sand-body and sand sheet mainly, but interbeds of mud rock and siltsand increases gradually in sand-body, reservoir heterogeneity increased.③During later period of the 4-th hierarchical base-level rising and early period of the 4-th hierarchical base-level falling, reservoir sand-body was poor, and only form thin sand-body of subsaqueous distributary channel, subsaqeuous creveas and distal mouth bar, sand-bodys are surrounded by mud and silt rock.

进一步采用以第4层次基准面旋回中相当最大湖泛面的相转换面和具有区域性暴露侵蚀作用的层序边界面为等时地层对比框架的边界，对发育于MSC2—MSC4三个第4层次基准面旋回的第3层次基准面旋回内砂体进行了逐层等时对比，探讨第4层次等时地层对比格架内储集砂体发育分布规律，及储集砂体的非均质性特点，研究发现：①第4层次基准面上升初期发育的水下分流河道，砂体呈连续叠置、侧向迁移受限，纵向上呈长距离延伸的带状产出，砂体间泥、粉砂岩夹层少，储层非均质性相对较弱；②在第4层次基准面上升中期发育的水下分流河道侧向迁移活跃，纵向延伸过程中分流汇合作用强烈，以形成网状或席状连片砂体为主，但砂体间泥、粉砂岩夹层逐渐增多，储层非均质性增强；③第4层次基准面上升晚期和下降早期，不利于储集砂体发育，仅出现少量薄的水下分流河道、水下决口扇、远—河口砂坝砂体。

It shows a novel type of layered structure, where dimers of distorted {CuO4} planes are connected by {CPO3} tetrahedra, forming an inorganic layer containing 4-, 8- and 14-member rings.

该化合物具有新型层状结构，由扭曲平面结构的{CuO4}共边形成的二核单元通过{CPO3}四面体连接起来，形成一个含有4-，8-，和14-元环的无机层。

Dolomite rock occurrence, fabric, dolomite "bright margin" and "fog core" and the geochemical characteristic indicate that a number of Hongyan type pyrite deposits was correlated with the fluids formed by the compacting process of the sediments in basin.

白云岩产状和组构、白云石&亮边&和&雾心&特征及地球化学特征表明，红岩型诸矿床的成因与盆地沉积物压实过程形成的流体有关。

It is suggested that this defect is originated from the internal crack and the subcutaneous bubble s of billet,as well as unreasonable pass design of roughing mill.

通过对试样进行金相分析，对铸坯表面修磨试验结果分析及对连铸坯在高线粗轧第1道和第2道轧制的受力和变形的分析，发现盘条表面的一种特殊的线状缺陷形成的原因是连铸坯存在边内裂和皮下气泡，粗轧机组(特别是第1和第2架)孔型设计不合理，也促进这种线状缺陷的形成。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了