强度
- 与 强度 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This theory makes direct use of the electric and magnetic field as unknowns, thus yielding uniquely defined vectors in combination with a suitable grid definition.
该理论直接以电场强度和磁感应强度为未知量,采用两套互相正交的网格,将场矢量离散为不同网格点上的一系列分量,将矢量积分方程转化为一组线性方程组。
-
An unit initial stress method to calculate stress intensity factor is introduced, which uses the degradation of the 1/4 node singular unit, calculates the stress through the crack tip close to the best stress point, and gets the stress intensity factor.
提出一种计算应力强度因子的单元初始应力法,该法采用退化的1/4节点奇异单元,通过近裂尖最佳应力点应力进行求解,进而求得应力强度因子。
-
The influence of the electric field on the properties of the bound magnetopolaron in an infinite-depth GaAs semiconductor quantum well is investigated using the linear-combination operator and the unitary transformation method. The relationships between the polaron's ground state energy and the Coulomb bound potential, electric field, magnetic field, and well-width are derived and discussed.
研究了在外加电场作用下无限深GaAs半导体量子阱中束缚磁极化子的性质,采用线性组合算符及幺正变换方法导出了量子阱中弱耦合束缚磁极化子的基态能量与阱宽、电场强度、磁感应强度、库仑束缚势的变化关系,同时讨论了振动频率和库仑束缚势、外场之间的变化关系。
-
Slipper type universal coupling"s fork joint and palm end are the weak parts of the main transmission system. In this article, the two parts" intensity values are obtained through finite element analysis . After making three-dimensional computer simulation analysis by ANSYS, the results show that the middle arc of the fork joint in loaded side and the intersection of fork bore and the arc are the danger location, where the stress is largest and stress concentration is serious.
本文对轧机主传动系统机械部分的薄弱部件进行强度计算,即对滑块式万向联轴器的主要零部件的强度进行有限元分析,通过ANSYS有限元分析软件进行三维计算机仿真,由计算结果可知,在叉头受载侧过渡圆弧段中部、叉头镗孔与过渡圆弧交接处这两个部位的应力最大且存在严重的应力集中,考虑到单元总数限制及计算时间等因素,整体模型的网格划分较疏,不能反映倒圆角等细节。
-
Distribution region of EDZ and mechanical behaviors of rock mass are further evaluated by using damage model, and the result shows that damage variable is 0.6-0.8 for damaged zone, 0.4-0.6 for affected zone and 0.2-0.4 for slight affected zone. Finally, the slope excavation softening factor is introduced to Hoek-Brown empirical strength criterion, based on the deficiencies of using Geological Strength Index to estimate the rock mass mechanical parameter of EDZ.
对应实测开挖扰动区的分布范围和形状,可以近似确定开挖损伤区岩体的损伤值约在0.6~0.8以内,卸荷影响区岩体的损伤值约在0.4~0.6以内,轻微扰动区岩体的损伤值约在0.2~0.4以内;由此基于Hoek-Brown经验强度准则,引入开挖弱化因子,结合地质强度指标GSI,进行开挖扰动区岩体力学参数研究。
-
RESULTS The SOD activity had linear correlation with pH in the range of pH 2.2-8.0 when SOD concentration was fixed. The varication of activity after ultrosonication had linear correlcation with fluoresent intensity at 340 nm. With increase of uhtrosonic frequency, the microenviroment of tyrosine and tryptophan inside the SOD molecule was changed, then the balance of hydrophokicity and hydrophilicity inside the molecule was broken, this induced the blue shift of synchronous spectrum band and decrease of SOD activity.
结果 SOD浓度一定、pH2.2~8.0时,活性与其线性相关,超声后活性差值与340 nm荧光强度差值的线性相关;随着超声次数的增加,蛋白质SOD分子内部的酪氨酸、色氨酸所处的微环境被扰动,打破了分子内部的疏水和亲水平衡,使蛋白质的活性降低,在荧光检测中观察到普通荧光谱带蓝移,同步荧光的荧光峰位总体呈现峰位蓝移和强度下降。
-
It is necessary to be one-sided, since this facilitates the vehemence that is considered a proof of strength.
有偏见是很有必要的,这样有利于表现感情的强度,而感情的强度往往被视为有力。
-
In order to design a high performance laser Doppler velocimeter, the relationship between the signal intensity of laser Doppler and the diameter of spot was analyzed using the speckle theory, and the calculation formulas of the Doppler current was given based on functional theory. The polarization characteristic of scattered light and its intensity distribution were investigated.
为了设计高性能的激光多普勒测速仪,运用散斑理论详细分析了激光多普勒信号的强度与散射光斑大小的关系,结合泛函理论给出了计算多普勒电流的散斑表达式,并通过实验的方法研究了回波信号的偏振特性及其强度分布。
-
The results show that the turbulence intensity, fouling cleaning intensity and pressure drop increase with the increase of flow velocity, particle size and the volume fraction. The effect of liquid-solid fluidzed-bed cleaning fouling depends on the reasonable combination of flow velocity, particle size and the volume fraction. Through an integral consideration of water saving and energy saving and uniformity of fouling cleaning, the optimum flow velocity of flow, particle size and volume fraction are 2.0 m/s~2.5 m/s, 3 mm~4 mm and of 5%~8 vol%, respectively.
结果表明:流体的湍流强度、壁面污垢清洗强度和压力降均随流速、颗粒粒径和体积分数的增加而增加;液固流态化清洗防垢除垢效果取决于流速、液固颗粒粒径和体积分数的合理组合;综合考虑节水节能及污垢清洗的均匀性,高炉冷却壁的最佳流速为2.0~2.5 m/s,固相颗粒粒径为3~4 mm,体积分数为5%~8%。
-
Can improve vulcanizate tensile strength, tear strength, abrasion resistance and flex resistance to flexion and rubber processing easier, a small contraction
能提高硫化胶的拉伸强度、撕裂强度、耐磨性及耐屈挠性能,并使胶料加工容易,收缩小。
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。