强度

Producing sound of high volume and intensity .

高频率高强度比低频率高强度对灵敏度高的精密测量设备的破坏性大得多。

According to the curve,the spall strength,the thickness of spall scab and the tensile strain rate under different condition were obtained.

根据所得曲线波形计算出相应条件下的层裂强度、层裂片厚度以及各自的应变率，最后得到层裂强度随拉伸应变率变化的关系曲线。

First, the radiation intensity and spectral distribution of a target in the detection waveband are analyzed and simulated.

首先对目标在探测波段内的辐射强度的组成和光谱分布特点进行了分析，并对目标的辐射强度、光谱分布和运动等特征量进行了模拟。

Shakedown analysis of a thick spherical shell of material with different strength in tension and compression was carried out.

对拉压强度不同材料厚壁球壳进行了安定分析，得出了球壳加载应力场、残余应力场及安定极限的解析解，所得的解能反映材料拉压强度差效应。

The average diameter and volume fraction of the spheroidal phase approximately equal to 18μm and 30% respectively.

室温压缩时，S1的屈服强度和断裂塑性应变分别达到1325 MPa和12.0 %，极限断裂强度达到了1800 MPa。

The cyclic creep tests at room temperature on MTS material testing system for automobile spring steel and bolt steel under different heat treatments and different stress conditions have been conducted to investigate the micro plasticity behavior of the steels.

为研究汽车用弹簧钢与高强度螺栓钢的微塑性服役行为，在MTS材料试验系统上进行了不同钢种在不同强度水平和不同循环应力条件下的室温蠕变试验。

Heat flux increases remarkably in spring, so layering comes into being gradually and concentrates on the central BS where tidal mixing is weak; whether the range or intensity culminates during the Summer Solstice; stratification is weakened in accompany with the decrease of heat flux in the fall, and is still apparent in BS strait; the gale enhances vertical stirring of sea water, so no obvious stratification exists in winter.

春天海表热通量显著增强，层化结构也开始形成，主要分布在潮汐混合较弱的中央水域；夏至时节层化结构无论是发生范围还是层化强度都达到极致；进入秋季，层化强度伴随着海表热通量的减少而削弱，分布区域也逐步向渤海海峡转移；冬季大风进一步增强了海水的垂向混合，此时渤海不再有垂向分层。

The reasons why quarter-sawn board of Larch had smaller wet compressing shear strength than flat-sawn board of Larch for repeatedly boiling samples were as follows: first of all, antiswelling efficiency between springwood and summerwood of Larch was different; secondly, pits of Larch had great effect on this aspect.

造成桦木反复煮沸压缩剪切强度径切板的比弦切板的要大的主要原因是在弦切面木射线是被横断的，因此，在弦面上留下射线管胞的孔隙，在反复煮沸时这些孔隙成为了水分的通道，因而使桦木反复煮沸压缩剪切强度径切板的比弦切板的要大。

Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with

通过对Wisterch参数，钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸，并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同，导致钢丝进出模具的温度差别对钢丝机械性能的影响，在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验，得出结论，工作锥角越大则钢丝与模具接触长度越短，钢丝变形越剧烈，在模具中发热量就越高，导致钢丝出模温度高，使钢丝强度、硬度升高，弯曲、扭转次数降低，并且降低模具使用寿命。在其它条件相同的情况下，定径带越长则钢丝与定径带简壁磨擦增大，使钢丝发热量加大，从而使钢丝强度、硬度略升高，弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。

Canton transfer of industry to develop industrial park "industrial transfer of industrial park land for scientific and rational approach", in the procedures for land area, the principle of land, construction progress has made strict rules, at the same time to raise the admission standards of corporate investment in fixed assets intensity, fixed-asset investment enterprises to join in intensity from 60 yuan / mu adjusted to 100 yuan / mu or more.

广州产业转移工业园制定"产业转移工业园科学合理用地办法"，在供地程序、用地面积、用地原则、建设进度等方面作出了严格的规定，同时调升了入园企业固定资产投资强度标准，入园企业固定资产投资强度从60万元/亩调升至100万元/亩以上。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。