强度

It is embodied concretely:(1) With the adoption of grouting bolts, the cranny in wall rocks can be blocked up, the air can be isolated, the wall rocks can be prevented to be weatherized and make water, the strength of wall rocks can also be avoided to be lowered;(2) The lax broken wall rocks are commentated to a whole by liquid after they were grouted and the rock"s strength is increased, so the wall rocks become a part of the support structure by using itself and become a whole with the original rock, and the roadway is made to keep stable but not easy to be broken;(3) The spray layer wall are filled with liquid after grouting, the stress is avoided to be concentrated because the load could be evenly acted on the spray layer and the support;(4) The pressure acted on the plank can be delivered to the two sidepieces and then to the bottom by reinforcing the sidepiece; At the same time, the concentration degree of loads acted on the motherboard can be weaken because of the enlargement of the combination arch"s thickness, as result, the rock"s stress is lowered and the heaving is alleviated;(5) The common bolt is made to be fixed the whole length after grouting, the layers are connected to a integral whole and bear the weight of loads, so the support structure"s unity is increased.

具体体现在：(1)采用注浆锚杆注浆，可以利用浆液封堵围岩裂隙，隔绝空气，防止围岩风化，且能防止淋水和渗水，避免围岩被水浸湿而降低围岩的本身强度及造成的巷道变形。(2)注浆后浆液将松散破碎的围岩胶结成整体，提高了岩体强度，实现利用围岩本身作为支护结构的一部分，且与原岩形成一个整体，使巷道保持稳定而不易产生破坏；(3)注浆后使得喷层壁后充填密实，保证荷载能均匀地作用在喷层和支护上，避免出现应力集中点而首先破坏；(4)注浆后使作用在顶板上的压力能有效地传递到两帮，通过对帮的加固，又能把荷载传递到底板；同时由于组合拱厚度的加大，这样又能减小作用在底板上的荷载集中度，从而减小底板岩石中的应力，减轻底臌；(5)注浆加固后能使普通端锚锚杆实现全长锚固，它们共同将多层组合拱连成一体，共同承载，提高了支护结构的整体性。

The effects of cooling rate from both sidewall and bottom on the behavior of fluid flow have been sutdied.

分两种情形考察冷却强度的作用。侧壁及底部受不同冷却强度作用时对流动行为的影响。

The conditions to produce PP-g-PVOH with the highest SP 60% were: ethyl alcohol/butyl alcohol=30/70, NaOH%=0.5%, refluxing at 90℃ for 16hr.FTIR confirmed graft and saponification reactions, and it was identified that graft reaction influence porosity and morphology very little, but microparticles in PP granule were sightly swelled. There was a peak relationship between melt flowing index and GP and the flowing property was decreased with sponification reactions.

红外光谱证实了接枝和醇解反应的发生；孔隙率和PP粒子内部形貌观察的结果表明，接枝反应对粒子孔隙率的影响不大，但其内部微粒有所溶胀；接枝率增大，熔融指数呈现先上升后下降的趋势，对材料力学性能的研究表明，随PP-g-PVAc接枝率的增加，材料的断裂伸长率和拉伸强度先增加后降低，拉伸模量逐渐增加，材料的缺口冲击强度降低。

The basic physical properties indices of 10 kinds of silty sand are measured to know their particle distribution.

通过应力路径修正的方法，建立了南京砂峰值强度和残余强度间的关系：2。

This paper studies the change pattern of soil strength in the different water content as an example of silty clay soil in Beijing area. The results have shown that the changes of water content in the scope of 10-20% have greatly influences on soil strength.

结果表明：随着含水量的增大，土的强度降低，但降低的幅度不一样，当土的含水量在10～20％之间变化时，含水量的变化对土的强度影响极为明显。

Based on the analysis of absorption characteristic of desensitizing dye the free photoelectron decay curves of desensitized silver chloride emulsion exposed by 532nm are measured by microwave absorption and dielectric spectrum detection technology.

在对减感染料的吸收特性进行分析的基础之上，利用微波吸收介电谱检测技术测量了减感后氯化银乳剂在532nm波长曝光下的光电子衰减曲线，通过分析减感染料对光电子强度和衰减的影响，发现在光谱增感波段减感染料通过与增感染料相互竞争的吸(来源：A17B7464C论文网www.abclunwen.com)收光而影响光谱增感乳剂的光电子强度，并且减感染料通过俘获光电子使光谱增感乳剂的光电子的衰减变快。

Under the condition of axial compression, simple bending and compression-bending, the effects of parameters to CFTs mechanical performance are studied. The parameters taken in account are concrete compression strength, steel ratio, steel strength.

在轴压、纯弯和压弯情况下分析钢管混凝土柱力学性能受混凝土强度、含钢率和钢材屈服强度等参数的影响规律及其破坏机理。

Chapter four studies the chaotic responses in a system consisting of simple pendulum and harmonic oscillator under bounded noise excitation. Firstly, the Melnikov function of the two-degree-of-freedom system under Hamiltonian perturbation is derived. The essential condition of the autonomous system for the probable onset of chaos is obtained, the Poincare maps of the system under small Hamiltonian perturbation and the effect of increasing perturbation on the Poincare maps are studies. Then for the non-autonomous system under damping and harmonic or bounded noise excitation, the largest Lyapunov exponent and Poincare maps are calculated. From the analysis of the largest Lyapunov exponent, the critical criterion for the onset of chaos, and the conclusion that the threshold of bounded noise amplitude for the onset of chaos in the system increases as the intensity parameter of Wiener process increases are obtained. The result from the analysis of Poincare maps is in agreement with that obtained from the Largest Lyapunov exponent. The effect of varying damping coefficient and intensity parameter of Wiener process is also analyzed.

第四章研究了有界噪声激励下的两自由度单摆—谐振子系统的混沌运动，首先推导了该两自由度系统仅在Hamilton扰动下的Melnikov函数，得到该自治系统可能产生混沌的必要条件；研究了该系统在小的Hamilton扰动和增大摄动情形下的Poincare截面；然后对有阻尼、谐和或有界噪声激励下的非自治系统数值计算了其最大Lyapunov指数和Poincare截面；从Lyapunov指数分析得到了这个两自由度系统产生混沌运动的临界条件及产生混沌的临界激励幅值随Wiener过程强度参数值的增大而增大的结论，Poincare截面分析的结果亦符合Lyapunov指数分析的结论；研究了Wiener过程强度参数、阻尼系数变化对Poincare截面的影响。

The stress intensity factors of pipes containing an elliptical arc of crack have been evaluated by collapsed singular element with the more detailed mesh on crack front and their respective adjacent areas.

中文摘要本论文对含内、外裂椭圆形裂缝之圆管应力强度因子计算，计算在椭圆形裂缝尖端部位附近，使用溃点奇异元素，建立有限元素的网格化自动产生模型，并利用ANSYS程式计算裂缝尖端的应力强度因子。

Stress intensity factor is obtained by solving singular integral equation. Numerical examples are given to show the effects of material properties, interlayer thickness, and especially the distribution parameter k on the stress intensity factor.

通过处理奇异积分方程得到了应力强度因子，数值结果给出了材料特性、界面层厚度、尤其是分布特征参数k对应力强度因子的影响。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。