英语人>网络例句>弹簧阀 相关的搜索结果
网络例句

弹簧阀

与 弹簧阀 相关的网络例句 [注:此内容来源于网络,仅供参考]

Valve seat plate and the sealing surface for the oblique cone structure, in the oblique conical surface of valve plate welding temperature, corrosion resistant alloy material; fixed loop in the regulation of the spring between the plate and the plate with the adjustment bolt assembly structure.

阀板与阀座的密封面为斜圆锥结构,在阀板斜圆锥表面堆焊耐温、耐蚀合金材料;固定在调节环压板之间的弹簧与压板上调节螺栓装配一起的结构。

The experimental resolution verifies the data of the valve's sturcture and spring' s elastic coefficient that is optimized by model' s solution.

在两阀内部,利用计算出来的解析解对阀内部结构尺寸参数和弹簧弹性系数进行优化设置,最后通过实验,检验了计算结果的正确性。

This was mainly spring bending stem, install the valve malposition or stuck valve caused.

这主要是弹簧弯曲阀杆、阀瓣安装位置不正或被卡住造成的。

We can't ignore that energy sources wasting and environment pollution has already become the necessitous problem in the developing of automobiles as unsuited enactment of the valve and aging of the spring.

我们不可忽视,由于蒸汽阀开启压力值设置的不恰当及蒸汽阀弹簧的老化,过多的汽油箱内汽油蒸汽的排出而造成的能源浪费和环境污染,已成为汽车工业发展中急需关注的问题。

With more isthe piston - spring type energy storer, this energy storer is locatedbetween the solenoid valve and the dump pump, comes by the wheelcylinder 液压油 to enter the energy storer, then the compressionspring causes the energy storer hydraulic pressure cavity volume tochange in a big way, to temporarily stores up the brake fluid.

用得较多的为活塞-弹簧式储能器,该储能器位于电磁阀与回油泵之间,由轮缸来的液压油进入储能器,进而压缩弹簧使储能器液压腔容积变大,以暂时储存制动液。

When the flow through the balance of the piston damping the flow of holes increases, the balance of the piston, the next increase in pressure on both sides of a balanced increase in the distance the piston increases, and vice versa reduced; and also because the spring stiffness is very small, so that shift the balance of the piston pressure required very few changes, so the flow through the Poppet head is not much change, so the first opening Poppet very few changes, to mention the pressure of moving the first opening can be said to remain unchanged, that is, when the pilot valve spring after a set, Poppet Head was opened, the balance piston chamber pressure remained basically unchanged.

当流经平衡活塞上阻尼孔的流量增加时,平衡活塞上、下两侧的压差增加,平衡活塞上升距离增加,反之则减小;又因为弹簧的刚度很小,使平衡活塞上移所需压差变化很小,所以通过提动头的流量变化也不大,因此提动头的开口变化很小,提动头开启的压力可以说是不变的,亦即当先导阀的弹簧一经设定后,提动头被打开时的平衡活塞上腔的压力基本保持不变。

The air spring suspension system consists of air spring,guided framework,electro-magnetic valve ,damper,sensor,gas storage and so on.

空气弹簧悬架系统主要由空气弹簧、导向机构、电磁阀、减振器、传感器、储气筒等机械元件和电气元件组成。

Direct-action is through direct manipulation of the spring force; Pilot is a good pre-adjust the air pressure regulator instead of direct-action spring to surge, and the general flow characteristics of pilot-valve direct-acting type than good.

直动式是借助弹簧力直接操纵的;先导式是用预先调整好的气压来代替直动式调压弹簧进行调压的,一般先导式减压阀的流量特性比直动式的好。

"Hydraulic safety valve" is widely used in hydraulic power systems and hydraulic equipment of safety devices, pressure devices can be limited, is a special valve, which is different from the conventional valve, the traditional use of mechanical valves metal spring as a driving force, can only be limited to low pressure, encountered more BALANCING VALVES than 10Mpa pressure limit pressure can do to increase the volume of pressurized design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置,也可以作限压装置,是一种特殊的阀门,它不同于传统的阀门,传统阀门用机械金属弹簧为动力,只能限中低压力,遇到超过10Mpa以上的压力限压,闸阀只能做加大体积的增压设计,因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重,结构复杂,制造难度大,产品成本高;在使用过程中金属弹簧的疲劳变化大使限压参数波动大,要经常调整才能保证正常使用。

The simulation results show that the spring stiffness and initial force have important effect on the poppet valve's opening displacement, the delay-closing time and the closing velocity, and there must be an optimal matching between those two spring factors.

仿真结果表明,在同时保证阀芯有较大的开启度和较短的滞后关闭时间时,弹簧刚度和预紧力因素之间存在着最佳组合:k=10 N/cm,f=15N;同等地改变预紧力比改变弹簧刚度,对阀门的运动影响更大。

第6/16页 首页 < ... 2 3 4 5 6 7 8 9 10 ... > 尾页
推荐网络例句

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。

There is no differences of cell proliferation vitality between labeled and unlabeled NSCs.

双标记神经干细胞的增殖、分化活力与未标记神经干细胞相比无改变。