弹簧阀

The check valve shall utilize single torsion spring design to minimize pressure drop through the assembly.

止回阀应该采用单个扭力弹簧结构以减少通过总成的压降。

As shown in figure 2, Spring role in unloading valve at its big-flow position left.

如图2所示，弹簧作用使卸载阀处于其大流量位置。

This will disengage the disc assembly, spring and seat cover into individual components.

这将把阀瓣总成、弹簧和阀座盖分解成独立的部件。

In this case a proportional solenoid is used to push a poppet against a seat via a spring.

在此比例电磁铁被用来推动一个锥阀芯通过一个弹簧压缩阀座。

A spring seat member of the discharge valve is accommodated inside a discharge passage defined by the discharge section.

排出阀的弹簧座件可以装在排出部分形成的排出通道内。

The seat, spring cage, spring and disc assembly are now individual components.

此时，阀座，止回笼，弹簧和阀瓣总成就分解成都里的部件。

Normally, large self-respect Pressure Reducing and Sustaining Control Valves and the upper valve plate pressed under the pressure of the spring pressed in the seat, so that the valve is turned off.

平时，大阀板在自重和上部压紧弹簧的压力下压紧在阀座上，使阀门处于关闭状态。

Or wafer-style with stainless steel spring bronze disc plates rubber seat body of cast iron ASTM A 126 Class B or A 48 for use with Class 125/150 flanges.

也可以采用平板式结构，配置不锈钢弹簧，青铜阀瓣，橡胶阀座，符合美国材料试验协会 ASTM A 126级别B 标准的铸铁阀体，或A 48标准的125磅级或150磅级法兰。

By decomposition of the inverse order of 50 loaded packing gland, stem stopper 66, spring washers 49, nut 48 fixed tight with the above-mentioned components.

9按分解的逆顺序依次装上填料压盖50、阀杆限位器66、弹簧垫圈49，用螺母48固紧上述零件。

The thrust compensator consists of a spring loaded stem nut that will absorb any expansion or contraction caused by temperature fluctuations without affecting the position of the closed valve stem.

这个推力补偿器有一个弹簧支撑的阀杆螺母，可以来吸收因为温度波动造成的收缩和膨胀，而不影响阀门的关闭位置。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。