弹簧阀

What usually happens is that the spring corrodes to the stem and valve body and becomes immovable.

通常发生的是弹簧同阀杆和阀体腐蚀在一起，变得无法移动。

The first is a reseating spring-loaded relief valve that, depending on the setting, will relieve pressure at 22 psig,230 psig, or 350 psig.

第一个是可复位弹簧减压阀。

Types of pressure-relief device designs include fusible plugs, rupture disks, rupture disks with fusible metal backing, and spring-loaded relief valves.-?

减压装置的设计类型包括易熔塞、破裂盘、带易熔金属衬里的破碎盘和弹簧减压阀。

When the thrust balance with the pressure regulator spring force when the pressure valve will have a stable output.

当该推力与调压弹簧作用力相平衡时，阀便有稳定的压力输出。

The acting force keeps its balance with reacting force of spring, which decides the relative place of core and seat and controls the back of valve's pressure.

当阀后压力P2增加时。P2作用在顶盘上的作用力也随之增加。此时。顶盘的作用力大于弹簧的反作用力。

He was a thermostat Motorized Valve Actuators controls the electric valve motor, and through institutions and reset spring slowdown the valve closed, or closed, while the realization of ZY Series Electric Actuator cold water or hot water pipes pass or break in through the fan coil and other air-conditioning pipe blast in order to achieve the specified temperature of the automatic adjustment.

他是由温控器控制电动阀电机，并通过减速机构和复位弹簧使阀门关或闭，而实现管道冷水或热水的通或断，在通过风机盘管及其他空调管送风，以实现指定室温的自动调节。

Locked-rotor tune, the lower stroke protruding piece on the rack board closes the valve deadly, pressure

，当听到堵转时调正齿条板上的下行程凸块将阀关死，重新将压紧弹簧合上，同时左旋电位器到&0&

When the hydraulic pressure power supply stops or controls the solenoid valve opens, in driving pliers' pressure oil pressure vanishing, the piston under the precompression brake block spring's function rapidly promotes, affects on the friction liner and presses to is applied the brake the body, simultaneously the driven pliers in the driving pliers and under connecting bolt's function, lead through the glide guide pillar's function rub the liner to press to are applied the brake the sleeve to become the brake.

当液压动力源停止或控制电磁阀打开时，主动钳内的压力油压力消失，活塞在预压的制动弹簧的作用下迅速推出，作用在摩擦衬垫上并压向被制动体，同时从动钳在主动钳和连接螺栓的作用下，通过滑动导柱的作用带动摩擦衬垫压向被制动体完成制动。

Should re-adjust the amount of compression spring or a heavy hammer position; valve flap and valve seat stick.

应重新调整弹簧的压缩量或重锤的位置；阀瓣与阀座粘住。

To examine the seat, continue spring compression until the clapper has moved approximately 1 from the seat.

检查阀座，继续压缩弹簧直到阀瓣丛阀座上移动大约1英寸。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。