弹簧安全阀

Spring-loaded safety valve: The compression spring force to the pressure balance valve and to the seal flap.

弹簧式安全阀：利用压缩弹簧的力来针型阀平衡阀瓣的压力并使之密封。

Spring-loaded safety valve by adjusting the compression spring to adjust the pressure.

弹簧式安全阀靠调节弹簧的压缩量来调整压力。

"Hydraulic safety valve" is widely used in hydraulic power systems and hydraulic equipment of safety devices, pressure devices can be limited, is a special valve, which is different from the conventional valve, the traditional use of mechanical valves metal spring as a driving force, can only be limited to low pressure, encountered more BALANCING VALVES than 10Mpa pressure limit pressure can do to increase the volume of pressurized design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，闸阀只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

Recommended National Standards GB/T12243-2005 "spring load safety valve directly," provides a safety valve back seat pressure Automatic sludge-draining filter should be greater than 85% of the entire set pressure or 80% of the entire set pressure.

推荐性国家标准GB/T12243-2005《弹簧直接载荷式安全阀》规定，安全阀的回座压力应大于85%的整定压力或80%的整定压力。

Recommended National Standards GB/T12243-2005 "spring load safety valve directly," provides a safety valve back seat pressure should be greater than 85% of the entire set pressure or 80% of the entire set pressure.

推荐性国家标准GB/T12243-2005《弹簧直接载荷式安全阀》规定，安全阀的回座压力应大于85%的整定压力或80%的整定压力。

Recommended National Standards GB/T12243-2005 "spring load safety valve directly," provides a safety valve discharge pressure should not exceed 1.1 times the setting pressure or 1.2 times the setting pressure.

推荐性国家标准GB/T12243-2005《弹簧直接载荷式安全阀》规定，安全阀的排放压力应不超过1.1倍的整定压力或1.2倍的整定压力。

Recommended National Standards GB/T12243-2005 "spring load safety valve directly," provides that a safety valve Safety valves opening height shall be not less than one quarter of the valve throat diameter, or one-twentieth of the valve throat diameter.

推荐性国家标准GB/T12243-2005《弹簧直接载荷式安全阀》规定，安全阀的开启高度应不小于四分之一的阀门喉径或二十分之一的阀门喉径。

Recommended National Standards GB/T12243-2005 "spring load safety valve directly," provides a safety valve opening height shall be not less than one quarter of the valve throat diameter, or one-twentieth of the valve throat diameter.

推荐性国家标准GB/T12243-2005《弹簧直接载荷式安全阀》规定，安全阀的开启高度应不小于四分之一的阀门喉径或二十分之一的阀门喉径。

Recommended National Standards GB/T12243-2005 "spring load safety valve directly," provides a safety valve discharge coefficient should meet or exceed the nameplate specified value.

推荐性国家标准GB/T12243-2005《弹簧直接载荷式安全阀》规定，安全阀的排量系数应达到或超过铭牌规定值。

The lever-type safety valve to prevent the heavy hammer to have their own mobile devices and limit leverage Pilot-Operated Safety Relief Valve deviant lead frame, spring-loaded safety valve should be to enhance grip and to prevent casual screw adjustment screw moving device.

杠杆式安全阀要有防止重锤自行移动的装置和限制杠杆越轨的导架，弹簧式安全阀要有提升手把和防止随便拧动调整螺钉的装置。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。