弹性模量

Based on the comparison analyses of the viscosity method, transition pressure method, visco-elesticity analogue and residual resistance factors as well as the application range, a series of technical methods and testing standards to evaluate the gel strength and properties have been set up and also the classification indexes of the gel has been established.

通过对粘度法、转变压力法、粘弹性模量法和残余阻力系数法等优缺点和实用范围的对比分析，建立了一套评价凝胶强度、性能的技术方法和测试标准；确定了凝胶分类指标。

It was found that E and μm increased greatly but DI andor decreased when the dose of neuraminidase and the time of treatment were increased. There was a contrary correlation between them.

发现随着神经氨酸酶处理剂量的增加和处理时间的延长红细胞膜剪切弹性模量和表面粘度明显增大，而红细胞的变形指数DI和取向指数or却减小，呈现明显的反相关关系。

Based on the measurement results, the elastic modulus and the longitudinal wave velocity of diabase and argillaceous limestone are organized and regressed to calculate their correlation.

百色水利枢纽消力池的工程地质条件复杂，在施工详图设计阶段对其进行专门勘察时做了大量的钻孔变形参数测试和声波测试，利用钻孔变形参数测试和声波测试结果，对辉绿岩、泥质灰岩的弹性模量和纵波速度进行整理、回归，求出其相关性。

The critical aspect ratio of the fiber is defined as the crosspoint of the tangent value of the inflexion and the asymptote of the maximum elastic modulus.

将与曲线拐点切线和最大值水平直线交点相对应的长径比值定义为纤维临界长径比，将与此相对应的函数值定义为弹性模量临界值。

Assuming that the elastic modulus was the exponential function of special coordinates and the Possion＇ s ratio was constant, the higher order asymptotic stress fields near the crack tip for the mode Ⅰ crack in the FGM were considered.

假设弹性模量是空间坐标的指数函数，泊松比恒定，对于功能梯度材料中的Ⅰ型裂纹，裂纹尖端应力的高阶渐近场被研究。

The increase of atomic radius leads to the reduction of the elastic modulus of the nanocrystals.

由于原子半径的增加，导致弹性模量的减少。

Objective To research the influence of autoclave sterilization on elastic module and flexural strength of five types of posts.

目的 研究高温高压消毒对不同桩挠曲强度与弹性模量的影响。

The accelerated ageing tests of the parallel bamboo curtain laminated panels of grade Ⅰ,Ⅲ and Ⅳ2 were carried out in accordance to ASTM

利用老化处理前的初始厚度计算力学性质，Ⅰ级、Ⅲ级、Ⅵ2级竹帘层压板的抗弯强度保留率分别为107％、72％和63％（都在50％以上）；抗弯弹性模量的保留率都在100％以上。

The parallel bamboo curtain laminated panels of different grades were manufactured in the laboratory using the mature production technology of bamboo curtain plywood, and the bending and compression properties have been studied respectively.

在不同部位竹材性质测试的基础上，分析了竹材、木材物理力学性质的差异，建立了毛竹的物理力学性质与密度之间关系的拟合方程，并针对将竹壁分成6层等厚竹篾工艺生产的竹篾，根据竹材的抗拉弹性模量分别制定了分4级、3级和2级等3种力学分级方法。

Mechanical properties including the density MOR, MOE, shearing strength of birch and basswood LVL beams made by the bi-frequency hot press were tested by universal strength testing machine. The primary failure modes were discussed when LVL beams suffered the flexural and level shearing load.

在万能力学试验机上测试由高频热压方法制造的桦木和椴木单板层积梁的密度、静曲强度、弹性模量和水平剪切强度等力学性质；讨论LVL梁受弯曲、水平剪切载荷时的主要破坏形式并得出相关结论。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。