弹性模数

The results show that the hardness and elastic modulus increase as the sputter power increases.

经实验结果显示其硬度与弹性模数皆会随著溅镀功的增加而增加。

Compared with steel, aluminum has a third its modulus of elasticity, weighs a third as much, and costs about three times as much.

与钢相比，铝的弹性模数是钢的1/3，重量也是钢的1/3，而价格则是钢的三倍左右。

Hence, the modulus of rigidity, G, of glulam was measured by vibration test method in order to realize the shear deflection effect. The E/G values of Japanese cedar, Taiwania, Douglas-fir, and southern pine glulam were ranged form 13.2 to 14.5, 14.6 to 16.6, 12.1 to 16.6 and 16.0 to 19.1, respectively. The pure MOE was also obtained. The Ep and MOR values of glulam were ranged from 10.6 to 13.4 GPa and 48.3 to 61.9 MPa for Japanese cedar, ranged from 12.1 to 15.0 GPa and 41.8 to 58.8 MPa for Taiwania, ranged from 10.5 to 16.4 GPa and 37.2 to 65.6 MPa for Douglas-fir, ranged from 14.5 to 20.6 GPa and 70.2 to 78.48 MPa for Southern pine, respectively.

而消除剪力挠曲影响，即可得集成材之抗弯弹性模数真实值与抗弯强度，依本研究配置所得之柳杉集成材之Ep值与MOR值分别为10.6-13.4 GPa与48.3-61.9 MPa；台湾杉集成材之Ep值与MOR值分别为12.1-15.0 GPa与41.8-58.8 MPa；花旗松集成材之Ep值与MOR值分别为10.5-16.4 GPa与37.2-65.6 MPa；南方松集成材之Ep值与MOR值分别为14.5-20.6 GPa与70.2-78.4 MPa。

With the higher modulus of elasticity of calendering, than steel roller soft 500 times, when the elastic rollers to trace

具有较高弹性模数的压光辊，一般要比钢辊柔软500-50倍，当弹性辊以一定的线

The thesis discusses three eigenvalues individually and explains the pressure wave propagation of three modes, includes wave speed, wave decay and energy distribution. Since the elastic potential energy occupies more than 98% of mechanical energy in the arteries, which is larger than 2% of kinetic energy of flowing blood. Else join elastic wall and wall of managing having a viscid condition to analysis .

本文将个别讨论此三组特徵值，来说明三组压力波的传递模态，其中包括波速，以及波的衰减；由於在动脉的能量分布中，由管壁振动的弹性位能占了98%，远超过血液本身流动的2%，再加上管的弹性模数和管壁的黏滞性再来讨论此三组模态，个别在弹性管的能量分布。

Physiological indexes of drought-resistance, namely the four water parameters of osmotic potential at the turgor loss pointπ(subscript p, water potential at the water saturation point (π0), bulk modulus of elasticity, and the rate of bound water in cells V(subscript p/V0, for the three fire resistant trees, Schima superba, Cyclobalanopsis glauca, and Elaeocarpus glabripetalus, were studied using the pressure-volume technique.

应用压力－容积分析技术测定了木荷Schima superba，秃瓣杜英Elaeocarpus galbripetalus和青冈Cyclobalanopsis glauca等3个防火树种春季、夏季和秋季的水分特征参数，即初始质壁分离点渗透势π，饱和含水量时的最大渗透势π0，细胞弹性模数ξ，细胞质壁分离时的共质体水体积量与饱和时共质体水体积量之比V/V0。

The results show that for high lead solder, underfill with low CTE and high modulus is preferred.

对高铅焊锡凸块而言，选择低热膨胀系数和高弯曲弹性模数之底部填胶可以有效提高其可靠度。

The digital simulation of thedynamic processes under step load input and supply oil pressure fluctuation were carried on by MATLAB. Analysis of the dynamic characteristics was done with the changes of the supply pressure, load, structural parameters of spherical hydrostatic bearing and the effective bulk modulus of oil. The conclusions show that structural parameters of the spherical bearing and the effect bulk modulus of oil have significant influence to dynamic characteristics, but the elasticity deformation of interior supporting collet has very small influences on the output response characteristics of the suspension system. The collets deformation can be neglected on the project.

在此基础上，建立了考虑内支撑筒的弹性变形与否时悬浮系统的数学模型，同时，建立了线性化的仿真模型，利用MATLAB对阶跃负载输入和油源压力脉动输入下的系统进行动态过程的数值仿真，结果表明球面副的结构参数，油液的有效体积弹性模数对系统的响应特性有明显的影响，而内支撑筒的弹性变形对悬浮系统的响应特性的影响很小，在工程上可以忽略其弹性变形。

The stiffness is k=EI/L where E is the modulus of elasticity, I is the crosssectional moment of inertia, and L is the length of the flexure.

刚性的计算k=EI/L，其中 E是弹性模数，I物体横截面的转动惯量，L是扭曲的长度。

In this study, we used poly L-latcide, poly DL-latcide-co-glycolide 75:25 (PLGA7525) and poly DL-latcide-co-glycolide 50:50 (PLGA5050) during citric acid inducing ammonium bicarbonate gas forming process to form porous polymer film, and rolled the porous polymer film to make nerve conduits with pores and multi-layered. Electron Spectroscopy for Chemical Analyzer and Attenuated Total Reflectance – Fourier-Transform Infrared Spectrometer were employed for determining elements' functionabilities and chemical compounds. Charge Coupled Device camera and Scanning Electron Microscope were employed for macroscopic and microscopic morphologies and structural observation. Differential Scanning Calorimetry was employed for measuring glass-transition temperature. Nano-indentation system was employed for measuring elastic modulus and hardness. Biodegradation and water absorption ratios were measured to analyze their chemical properties and SEM was employed for microscopic morphology of the tested nerve conduit.

本研究将以聚乳酸、聚乳酸-聚甘醇酸共聚合物（75：25）、聚乳酸-聚甘醇酸共聚合物（50：50）做为研究材料，以柠檬酸诱发碳酸氢铵发泡之气泡成型法制作具有相连通孔隙之高分子薄膜，再将高分子薄膜卷制成特殊多层的导管，制作具有多层孔隙之新型神经再生导管，以电子能谱化学分析及减弱式全反射-傅立叶转换红外线光谱分析进行成份分析及化学元素测定；以电荷耦合元件摄影机、扫瞄式电子显微镜进行多层孔隙型神经导管巨观及微观形态结构观察；以示差扫瞄热量量测分析玻璃转换温度、奈米三维量测弹性模数及硬度；以及进行降解性质测定，并以扫瞄式电子显微镜进行降解后之导管微观结构形态观察。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。