弯曲部分

Meanwhile, the process of stress turn over of wide sheet bending forming is described by introducing a thought of dividing the sheet into three layers, so it is more accurate and popular.

同时，借鉴分三层思想，较好地考虑了宽板在弯曲成形过程中部分纤维层应力反号过程，因此具有较好的精确性和较强的普适性。最后，以铝板为例进行分析，发现计算值和实验值吻合较好。

The bending deformation occurs on the body of the columns, however, shearing deformation occurs on the frames.

对65台框架塔的自振周期和振型进行实测，发现基本振型与落地塔不同，塔体呈弯曲变形而框架部分呈剪切变形。

In designing the flexural reinforcement for the major moment for a particular beam for a particular section, the following steps are involved:· Determine the maximum factored moments · Determine the reinforcing steel Determine Factored Moments In the design of flexural reinforcement of moment resisting concrete beams, the factored moments for each load combination at a particular beam section are ob- tained by factoring the corresponding moments for different load cases with the corresponding load factors.

在设计一个特定部分，特别是梁为关键时刻抗弯增强，下面的步骤涉及：·确定时刻的最大因素·确定钢筋确定的因素时刻在目前的抗弯曲钢筋混凝土梁的设计，在特定的梁截面为每个荷载组合的因素是肥胖的时刻，由保理与相应的负载系数不同的负载情况下，不引起相应的时刻。

The one is research of on-way resistance and the other is of local resistance, including bending resistance and coupling resistance.

将水带的压力损失分为沿程阻力和局部阻力两部分进行研究，其中局部阻力损失细化为弯曲损失和接扣损失。

The basic mechanical performance of perforated shale brick masonry is studied by analyzing the experimental results of compression strength of 25 samples of the masonry ,bending tensile strength of 14 samples and shearing strength along straight joint section of 45 samples.

笔者通过对多孔页岩砖砌体25个试件的抗压强度、14个试件的弯曲抗拉强度和45个试件的沿通缝截面抗剪强度的试验结果进行分析，研究了多孔页岩砖砌体的基本力学性能，对其在设计和使用中的部分技术问题进行了探讨。

Hewitt used a rod with action or the bending in the lower or middle part but not as pronounced as in the standard Dry Fly action.

休伊特用行动或弯曲杆的中间部分，而不是作为降低或笔战的标准旱作飞行动。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。