弯曲的部分

Comparing with the case of no adit, because of arch tunnel set being broken; the intersection structure is subjected to combination of complicated stresses including transverse stress, but not the axial stress.

与无横通道情况相比，由于拱形支撑作用被切断，结构受力己不再是单一轴向受力，而产生了部分弯曲受力的复杂受力状况。

PART 7 : DETERMINATION OF BENDING LENGTH.

第7部分：弯曲长度的测定。

4DRG was co-culture with sciatic nerve segment in 10鸖 DMEM;the axons were longer and surround the sciatic nerve segment which was regard as anew evidence for chemotropism.

结果：(1)在无血清条件下单独培养的DRG，背根神经节的轴突数目众多，外形纤细弯曲，不成束，并且施万细胞和成纤维细胞稀少，所以可以排除两者对轴突生长的影响，为观察来源于变性坐骨神经段的可溶性因子对轴突生长的作用提供了有利条件；(2)在无血清条件下DRG和变性坐骨神经段联合培养，①先单独培养DRG，4天后待神经元轴突长出，再与坐骨神经段联合培养，观察到神经元的轴突数目减少，外形挺直，部分轴突之间相互粘附成束；②变性坐骨神经段和DRG同时联合培养，神经元的轴突数目明显减少，外形粗壮，轴突之间相互粘附成束；(3)有血清条件下单独培养DRG，轴突数目较多，外形挺直，长短不一，部分神经元的轴突之间相互粘附，施万细胞和成纤维细胞数目众多，观察到的轴突生长情况受到施万细胞和成纤维细胞的直接或者间接的影响。

Metal structure, the head is make by aluminum alloy material, the clockface is made by aluminum dial, the middle chain is made by stainless steel. You can bend it whatever as you want!

采用全金属结构，头部为铝合金材料，钟面采用铝制刻度面，中间部分是不锈钢制的链条，可以任意弯曲改变造型，N次创意，摆你所想！

The results show that the medial surface wrinkling and the lateral surface unstability are the main failure form of the thin-wall stainless steel tubes in cold bending forming.

结果表明，薄壁不锈钢管件弯曲冷成形的主要失效形式是内侧部分的起皱和外侧部分的失稳。

Only a small portion of my brain do I employ; only a paltry amount of my muscles do I flex.

至今我只使用了我大脑的一小部分；我只弯曲了我肌肉的一小部分。

In order to optimize the technology of press and lower the production cost,a two-stage floating elastic pressing structure at the anvil swage of the second punching die was adopted.

为优化冲压工艺，降低生产成本，第2副冲模采用了下模部分二级浮动弹压的结构，成功实现局部胀拉和翻边工艺以及压凸、弯曲、整形多道工序一次成形。

During the upstroke, the elbows and wrist flex so the wing partially folds, and the leading edge tilts upwards.

在upstroke ，肘部和手腕弯曲，使机翼部分倍，领先的优势，倾斜向上。

Models are built according to the emersed part and floating part of the ice sheet, respectively. Bending moment distribution in the ice sheet is analyzed to determine where a bending failure may occur. The analytic solution of breaking length for ice sheet is obtained.

文中将冰排分为在斜面附近脱离水面部分和较远处漂浮于水面部分两个区域，建立了冰排因弯曲而发生破断的数学模型，根据弯矩分布分析了冰排可能的破断位置，从而得到冰排与斜面结构相互作用时的破断长度解析表达式。

Lateral crus presented diamond-shaped or long strip,(16.21 ± 2.71) mm in length,(8.45 ± 1.72) mm in width,(1.09 ± 0.18) mm in thickness. Cephalic rim intersected lower edge of lateral nasal cartilage, and slightly covered the lower edge of the lateral nasal cartilage, so that the two were overlapped, but also only the intersection without overlapping. Lateral crus constituted the base of nasal wings. Narrow medial crus formed nasal tip and the frame of front nasal columella, showing posteroinferior curve or S shape,(13.06 ± 2.16) mm in length,(3.79 ± 0.58) mm in width,(1.02 ± 0.18) mm in thickness. The left and right medial crus in the middle were connected by connective tissue, and in the same way connected to the anterior margin of the lateral nasal cartilage.

外侧脚呈菱形或长条形，长(16.21±2.71) mm，宽(8.45±1.72 ) mm，厚(1.09±0.18) mm，头缘与侧鼻软骨下缘相交，并略覆盖侧鼻软骨下缘使二者部分重叠，也可仅相交而无重叠；外侧脚构成鼻翼大部的基础；内侧脚狭细，构成鼻尖和鼻小柱前部的支架，呈向后下的弧形弯曲或S形弯曲，长(13.06±2.16) mm，宽(3.79±0.58) mm，厚(1.02±0.18) mm；左、右内侧脚在正中线借结缔组织相连，并以相同方式连于侧鼻软骨的前下缘。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。