开口的

Blind gut:a digestive cavity having only one opening.

盲肠：只有一个开口的消化腔。

The adhesion region between two adjacent teeth on the 3D dental model is first detected by exploiting the minimum principal curvature information. Then, the adhesion region is cut off and the tooth profile opening caused by the removal of the adhesion region is filled with triangular patches adopting a local optimization scheme, it is then refined to form an intermediate restoration surface patch. The final restoration result is obtained by minimizing the surface energy to reflect the bio-characteristics of the single tooth.

根据三维牙颌模型的形态特征，采用基于曲面最小主曲率的方法对粘连区域进行准确的检测提取；对删除齿间粘连区域后生成的齿间开口利用局部最优化权值规则进行剖分并细分优化，生成"中间"恢复曲面；根据牙齿的生理医学特征，以齿间开口的边界信息为约束条件，采用基于最小化曲面能量函数的方法对"中间"恢复曲面进行变形调整，实现单颗牙齿缺失形状的准确恢复。

There are two types of thimbles: the tailor's thimble, which is open at the top, and the dressmaker's thimble, which is closed.

有两种顶针：一种是缝制男装用的，顶针的顶部是开口的；另一种是缝制女装时用的顶针，顶部不开口。

①The shape of the tubular openings has a corelation with both the arrangement of the dentinal tubules and their opening sites on the calcospherites.

①牙本质小管口的形态与牙本质小管的走向及其在钙球上的开口的形态与牙本质小管的走向及其在钙球上的开口部位有相关关系。

Slider seals (46, 56) attached to fixed panel edges that form the horizontal edges of the aperture, make sealable contact with the slider panel (48) when it covers the aperture.

当其覆盖开口时，接附到形成开口的水平边缘的固定的板边缘的滑动器密封件(46、56)可密封地与滑动器板(48)接触。

The number of pulmonary vein and maximal dimension of the PV ostia were determined by each imaging modality. Results 59 patients(83.1%) had typical pattern of pulmonary veins with four separate orifice for bilateral upper and lower pulmonary veins, respectively.

结果 CT共显示290根肺静脉， 59例(83.1%)患者有典型的左上、下肺静脉和右上、下肺静脉4个心房开口。9例(12.9%)有单独心房开口的副肺静脉。3例(4%)为左肺静脉共干。

In a radio wave absorber (10), four hollow tetrahedrons (20) each of which has one open surface are connected such that a surface (20a) opposed to the open surface of the hollow tetrahedron (20) forms a side of a hollow pyramid (22). The radio wave absorber (10) is composed of a radio wave absorbing member shaped like a thin plate.

该电波吸收体(10)呈按照下述方式连接而形成的形状，该连接方式为将4个一面开口的中空四面体(20)以开口面相对的面(20a)作为中空棱锥(22)的侧面的方式形成。

A bread maker including a main body having an oven compartment with a front opening, a door to open and close the front opening of the oven compartment, a pair of kneading drums spaced apart from each other inside the oven compartment and winding a mixing bag filled with ingredients for bread thereon, a drum driver driving the kneading drums to rotate, a heater heating the inside of the oven compartment, and a heater driver driving the heater to operate.

一种制面包机，包括：具有带有前开口的烤箱室的主体；用于打开和关闭烤箱室的前开口的门；在烤箱室内部互相间隔开的一对捏合鼓，并且在捏合鼓上缠绕有装有制面包配料的混合袋；用于驱动捏合鼓旋转的鼓驱动器；用于加热烤箱室内部的加热器；以及用于驱动加热器操作的加热器驱动器。

Item number 产品型号 CP636002 mouth opener 开口器 Features 产品特性 The mouth opener is designed to spiral, it moves in a spiral to avoid injuring patient's teeth and the oral soft tissue, when patient's jaw locked closed at stake or before anesthesia resuscitation.

本开口器为螺旋样设计，避免伤害患者门齿和口腔软组织。在患者昏迷或麻醉、复苏时以螺旋方式旋开患者牙关紧闭的口腔。

Please not that a 250 mm wide die opening will produce a film or sheet with less width since you have a "neck in" effect when you pull out the melted resin from the die before it reaches the surface of the chill roll. the width you can achieve depends on the melt strength of the resin as well as the distance between the die lip opening and the chill roll. but in general, about 80% of the die opening width can be achieved.

注意：250毫米宽开口的模头只能获得小于此宽度的薄膜或片材，因为当熔体树脂被从模头拉至冷辊上时会产生&颈缩&效应，最终获得的实际宽度依赖于树脂的熔体强度以及模唇开口同冷辊之间的距离，但总而言之，可获得模头开口宽度80%的产品宽度。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。