开关装置

Digital simulation is an important step for torpedo turbine engine design. This paper investigates the modeling and simulation of unclosed cycle and partial flow two-stage impulse torpedo turbine in design condition and two non-design conditions. The control modes of turbine in non-design conditions are discussed.

进行鱼雷涡轮动力装置数字仿真是设计涡轮机的重要步骤，为此，该文针对鱼雷涡轮机设计和研制的需求，采用理论分析、经验推导和实验研究相结合的方法建立了鱼雷开式循环部分进气纯冲动式复速级涡轮发动机设计工况及2 种常见变工况的数学模型，着重讨论了变工况过程涡轮机的调节控制方案，提出了简便易行的开关喷嘴控制方法，并对其进行了数字仿真研究。

From the burden increased aspect clarify set upthe necessity of station, then pass to drew up to set up generalizeof transformer substation and line direction to consider, and passto analysis of carry the data, safety, economic and dependableconsider and made sure the 110 kV, 35 kV, 10 kV and station useelectricity of lord connect line, then again through burdencalculation and power supply scope made sure main number, capacityand model number of the transformer set, also in the meantime makesure the station uses capacity and model number of transformer,end, according to biggest keep on work electric current and shortcircuit calculating of calculation result, to the high pressureRong break a machine, insulate a switch, female line, insulate sonand wear a wall set tube, electric voltage with each other feelingmachine, electric current with each other the feeling machinecarried on choose a type, thus completed a 110 kV electricity apart of design.

本文首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。从负荷增长方面阐明了建站的必要性，然后通过对拟建变电站的概括以及出线方向来考虑，并通过对负荷资料的分析，安全，经济及可靠性方面考虑，确定了110kV ，35kV ，10kV 以及站用电的主接线，然后又通过负荷计算及供电范围确定了主变压器台数，容量及型号，同时也确定了站用变压器的容量及型号，最后，根据最大持续工作电流及短路计算的计算结果，对高压熔断器，隔离开关，母线，绝缘子和穿墙套管，电压互感器，电流互感器进行了选型，然后进行配电装置和平面布置的设计以及防雷的设计，从而完成了110kV 电气一次部分的设计。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。