延时的

This character results in increase of packet lost rate and queuing delay of buffer system.

这种特性会导致分组丢失率增大和缓存系统排队延时的增加。

Once you decide to use live data, make sure it's real and not delayed.

当你决定了用即时波动数据，一定要保证是真实的，而不是延时的。

Further, by means of the state equation and observation, a method to compensate the delay is proposed here.

并在此基础上，提出了一种利用系统的状态方程及观测器补偿随机网络延时的方法。

Guaranteed Cost Control Of Linear Uncertain Systems With Time-Varying Delays In State And Input: an LMI Approach.

状态和输入具有时变和延时的线性不确定系统的确定代价控制：一种线性矩阵方法

On the design of algorithms, a novel exact hierarchical delay analysis method for general circuits is proposed; based on the sensitization theorem for sequential circuits, an exact minimizing clocking method is proposed; based on Boolean process, a waveform simulation method considering interconnecting delay for logic circuit and a parallel waveform simulation method are proposed; a new method that transforms bit-level waveform polynomial to word-level polynomial model is proposed; a multiple valued synthesis algorithm based on multiple valued Boolean process and a wire-centered delay synthesis policy are proposed, in which timing planning, floorplanning, wire planning and optimal clock skew in early design are considered; a two-layers channel routing method for minimizing crosstalk under grid mode is proposed; based on the transition numbers theorems for waveform polynomial, a new method for generation of test with noise effects is proposed.

算法设计方面，提出了一种精确的通用电路层次化延时分析方法；基于时序电路的敏化定理提出时序电路最小时钟周期精确确定方法；提出基于Boolean过程论的考虑互连延迟的逻辑电路波形模拟方法，在分析了波形模拟适合并行化基础上，进一步提出一种并行波形模拟算法；提出一种将位级电路波形多项式描述转化成字级多项式描述的新方法；提出一种基于多值Boolean过程的多值电路综合算法以及一种将前期设计定时规划、前期设计的布局规划和线网结构化方法及低偏移的时钟分配等技术相结合的面向互连延时的综合策略；提出一种串绕最小化的网格模式下的双层通道布线方法；从波形多项式描述跳变数的定理出发提出了一种考虑噪声效应的测试生成新方法。

This paper studies on the delay overheads of these methods.

本文对这两个方法对电路延时的影响进行分析。

This algorithm unifies the traditional algorithm and regional setting information of the node,and establishes the node route table.When node decides next step skipping,nearest node would be chosen firstly,thus enhancing the efficiency and ...

算法中结合传统算法和节点所在区域位置的信息，建立了节点路由表，使网络节点在决定下一步跳转时，优先选择距离较近的节点，从而可以达到提高路由效率，减少路由延时的目的。

However, system delays (such as processing time, channel information collection time, etc) are unavoidable so that the base station can only know the delayed channel information at most. These delays make the current subchannel and power allocation scheme not optimal to the current channel condition, which decreases the channel capacity gain of dynamic resource allocation over fixed allocation.

在实际系统中，各种延时（如处理时间，信道信息收集时间等）使得基站只能获知部分或延时的信道信息从而使得在基站端进行的资源分配可能对于当前的信道情况不是最优的，这样，应用了动态资源分配可以达到的系统容量相对于固定资源分配的容量的增益就有所下降。

Considering the acture condition on the battlefield,"cycle delaying method" have been used to reconstruct the sequence .

考虑到战场上的实际情况和整个系统的工作特点，在重构已识别的伪码时采用了循环延时的方法，有效并及时的提供了干扰源。

Some techniques such as the development of casting blast technique in surface mines, the inherent relationship between the stripping bench parameters and casting blast effect, the application of pre-splitting blast and inclined drilling, the function of millisecond delay blast between drill holes and lines are introduced and discussed. The traditional calculation method of combining theoretical analysis with experimental formulas, and the nomograph model method by D' Appolonia for optimal determination of casting blast parameters are also introduced in detail.

对露天矿抛掷爆破技术的发展、倒堆剥离台阶开采参数与抛掷爆破效果的内在联系、预裂爆破及倾斜钻孔的应用、排间延时及孔间延时的作用进行了分析与论述，详细介绍了采用理论结合经验公式的常规计算方法与D' Appolonia&图解法&模型确定抛掷爆破参数的过程及优化方法。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷