底部

I took a dowel and wrapped the top with waxed paper so that I had a hollow tube of around 6 making sure that it was sealed at the bottom.

我曾一 桩包裹顶端与waxed文件，使我有一个空心管约6 确定它是密封在底部。

What would be the bottom surface of the block is then skimmed flat, and locating dowel pin holes are drilled.

将具有什么样的底部表面块然后脱脂持平，与定位柱销孔钻。

Default peak meters scale bottom changed to -70dB, alternate scale down to -50dB.

默认山顶米，底部规模变到70分贝，候补规模下降到50分贝。

Use the down arrow to return to the more stable bottom of the wave.

使用向下箭头返回到波更稳定的底部。

The ratio of downcomer to riser cross sectional area, the bottom clearance and the ratio of height to diameter of the reactor are proved to be important of the cell growth behavior.

下降室和上升室的截面积比，底部系数，高径比这些几何参数和表观气速都与细胞的生长紧密相关。

Analyzing and simulating of the deformation law of the ceramic downspout product after overcoming the shortage of powder material models in the software of MSC. MARC. It shows out the important effects of various factors and the shape of mandril during the process. And it is obvious that the shape of the top mandril has more effects on the process than the bottom.(3) Showing out the important effects of model figure on the flowing of powder and the forming of low-density fields from the analysis. After changing the top of the mandril into spherical shape, an improving model is putting out so that the distribution of stress and strain turns to be even and proper and that the flow rule of powder grains is better.(4) Calculating of the dimensional precision and the cutting ratio of the product and analyzing of the effects of such factors as rubber aging, loading process, mandril, friction etc. on the cutting ratio.

MARC存在的粉末材料模型方面的设计缺陷后，对连铸水口粉末成形件的变形规律及影响因素作用进行了模拟分析，指出芯棒形状对成形件的变形有较大影响，并且芯棒顶部形状与芯棒底部形状相比，对粉末变形有更大影响；(3)分析了成形件出现低密度区域的原因，指出模具形状对粉末流动以及粉末成形件低密度区域的形成有重要作用，提出了密度分布优化改进模型：改进模具顶部形状，并将芯棒顶部设计成球面后，粉末成形件顶部区域的应力、应变分布更加均匀、合理，粉体颗粒流动情况明显改善，低密度区域明显缩小；(4)计算了成形件的尺寸精度及切削率，并指出除模具形状的影响外，充填密度、橡胶模具老化、加载工艺等其他因素对总体切削率也有相当的影响。

At this time the bottom of the groove is inclined downwardly at an angle of 3~20 DEG from an initiating point to a terminating point of a line.

同时，该槽的底部以3～20°的角度从线的起点至线的终点向下倾斜。

The shroud has an open sidewall and a closed bottom with an outwardly and downwardly extending skirt that extends to the about the midpoint of the height of the container.

该套筒具有一开口侧壁和一封闭的底部，且具有一向外并向下延伸的裙缘，该裙缘延伸至该容器高度的中点附近。

October 27 released by the CBRC data show that in the third quarter, state-owned, joint-stock, agricultural firms, foreign banks and other types of non-performing loans of commercial banks in both the balance of varying degrees of backlash, which is the trend of banking stocks or to produce a certain drag, and through the effects of weight at the bottom of the formation of the market.

10月27日，银监会公布的数据显示，今年第三季度，国有，股份制，农业企业，外资银行和其他类型的非表现在两个不同程度的反弹，这是平衡度商业银行贷款对银行股的趋势，或产生一定的阻力，并通过在市场形成底部的重量的影响。

Draw a line at the bottom of the page.

在这一页的底部划一条线。

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了，但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场，你等着挨绳子吧！