应变

Allow the hoof to expand as it is meant to, and the strain to extensor tendons and lateral cartilage will be relieved.

让蹄扩大，因为它就是要和应变，以伸肌腱和外侧软骨会松一口气。

The dynamic response of the grain's stress and strain with different grain's inner hole diameter and the ratio of external diameter to inside diameter was analyzed.

计算结果表明，药柱的应力、应变最大值出现在内孔边缘处，且随内孔直径及外径与内径比值的增大而增大。

Research on the stress and strain of grain was carried out by change of grain's inner hole diameter and the ratio of external diameter to inside diameter during the reliability tests of solid propellant grains.

研究了固体推进剂可靠性分析测试中药柱的应力、应变随其内孔直径及内外径比值的变化规律。

It can externalize the market technological ability into the competitive advantage and also reflect the market's sensitivity, adjustability and operative ability.

它可以将企业的技术优势外化为市场竞争优势，反映出企业对市场变化的敏感度、应变能力、控制操作能力等。

Owing to the effect of stress hardening and Bauchinger, the mechanical properties at the intrados and extrados of the elbow are obvious different.

但由于应变硬化和鲍辛格效应的影响，使该弯头外弧和内弧力学性能存在明显差异。

In addition, the distortion ability of AZ31 alloy has an extreme value with the strain rate increasing.

此外随应变率的增加，该合金变形能力有一极值。

The object of the study was investigated the nanostructured precipitates and superparamagnetic properties of the γ-austenite face centered cubic Fe-9A1-30Mn-1C-0.5Si alloys, for which two kinds of specimens were solution-treated quenching in oil, and the S. T. quenching in oil then cold-forged 20%~50% strain, respectively.

本研究计画之目的，系探讨沃斯田铁面心立方结构之铁－9铝－30锰－1碳－0.5矽合金，两种试样时效热处理后内部微析出物显微结构与超顺磁性质之关系，两种试样分别为闯溶油冷与因溶油冷锻应变20%-50%，再同时於823K持温140天时效处理。

Finite element model of fault block's azimuth response has contingency with measured response, which supports this hypothesis.

有限元断层地块模型应变方位响应与台站实测方位响应的一致，支持了这一观点。

The finite element model of metal structure of FEH escalator was built with ANSYS software. Characteristics, load calculation and load combinations of the escalator were discussed. The software can show the biggest stress and distortion, which the engineer can compare with the standard requirement. It provided a theoretical basis for escalator metal structure design and material choosing.

利用ANSYS软件建立FEH公共交通型自动扶梯金属结构有限元分析模型，针对自动扶梯的特点对载荷进行分析，将载荷和约束施加于自动扶梯模型之上，通过软件计算出最大应力和最大应变值，以此判定是否满足标准要求，为FEH公共交通型金属结构的设计提供理论基础，也为降低成本提供参考依据。

There are differences between the strain and displacement predicted by FEM and those of experiment.

但有限元预测的位移应变和实测值在数值上有一定的差别。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新