平均速度

The detonation velocity measured by the continuous velocity probe method is in accord with the detonation velocity measured by the traditional electrometric method, and the continuous velocity probe method can even give the true course of detonation development for industrial explosive.

显然，平均爆速测试结果与连续爆速的测试结果吻合很好，且连续速度探针法能满足准确测量工业炸药在装药结构中爆速连续变化的要求。

The values obtained in thepresent study for the electron energy distribution function,drift velocity,ionizationcoefficient and attachment coefficient,etc.,are calculated and compared with theexperimental results reported in the literature,and the comparison is also carried outwith the values obtained from the two different types of fields.

应用Monte Carlo模拟法研究了氧气放电的电子参数，得到了在均匀电场中的电子能量分布、平均能量、漂移速度、电离系数、附着系数、迁移率及扩散系数随时间、电场强度的变化关系，并与文献上的实验结果进行了比较。

Theresults show that the electron mean drift velocity is affected by the cathode radius, theimpedance of the load diode, the inner radius of vanes and the input voltage.

结果表明电子平均漂移速度决定于阴极杆半径、负载二极管阻抗、阳极慢波叶片内径和输入电压。

The experimental result demonstrates that the methods are much faster and more accurate than the traditional methods, and the mean error of reading value is only 0.016%.

实验结果表明该方法比传统方法速度快、精度高，系统读数平均误差仅为0.016%。

Through detailed analyzing some influencing factiors of sand liquefaction, seven parameters were selected as assessment indexes. They are earthquake magnitude, peak ground surface acceleration, standard penetration value, specific penetration resistance, relative compaction, average particle diameter, and water table. The extension assessment model has been established that was applied to assessment of sand liquefaction potential. The model had been trained by the historical data and has been assessed in virtue of sand liquefaction from the historical data by simulating, and got a excellent result. After introduction of the support vector machine theory, this paper established the assessment model of sand liquefaction based on the support vector machine, and assessed in sand liquefaction from virtue data of some fields in home and overseas with the tool Libsvm, which was programmed based on the support vector machine theory. And got a good coherency between the assessement results and the actual liquefaction.

在详细分析影响砂土液化因素的基础上，选取了震级M、地面最大加速度g_、标准贯入击数N_(63.5)、比贯入阻力P_s、相对密实度D_r、平均粒径D_(50)、地下水位d_w等7个参数作为评价指标，建立了砂土液化势的可拓评价模型，并对历史数据进行仿真评价，取得了较好的应用效果；在对支持向量机的理论进行介绍后，本文建立了基于支持向量机的砂土液化势评价模型，并利用在基于支持向量机理论的Libsvm软件，对若干国内外场地的现场实测数据进行了评价，评价结果与现场表现基本上一致。

In China, its expansion has been fast-paced with a monthly average growth of 15,000 members.

在中国，它以平均每月增加15，000名会员的速度迅猛发展。

It uses them to gnaw at the sides and bottom of its channel,gradually loosening more earth.

这种不断的移地填海，正在使美国海拔以上的平均高度，以每9，000年减少1英尺的速度下降。

The authors proposed using Pythagorean hodograph spirals in approach ing and corner turning for high speed milling to reduce jerks in motion and so that the tool life is lengthened,and the effective machining speed and machining accuracy are improved.

提出用Pythagorean速端螺旋线作为高速切削加工导入和角部的平稳转向过渡曲线，可以减小加工过程中传动机构及刀具受到的冲击，提高了加工精度和平均进给速度。

Firstly, two covering hypersphere algorithms were proposed, referred to as minimum volume covering hypersphere algorithm and moving medium centers covering hypersphere algorithm, to heuristically and rapidly select the promising hidden center vectors from all the training samples. Then the particle swarm optimization algorithm combined with recursive orthogonal least square algorithm was used to further prune the initial hidden centers and optimize the control parameters.

为在实际应用中加速优化速度，降低优化计算复杂度，首先提出了最小体积覆盖超球和移动平均中心覆盖超球两种算法，用于启发式的从训练样本中快速的初选出径向基概率神经网络的隐中心矢量，然后将粒子群优化算法和 ROLSA 结合进一步优选隐中心矢量，同时优化核函数控制参数，实现径向基概率神经网络的全结构优化。

And finally, the manufacturer's IBO speed is likely to reflect their "best" test, rather than their average test.

最后，制造商的国际文凭组织的速度很可能反映他们的"最好"的测试，而不是他们的平均测试。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。