平均时

Early in the third quarter as the yang of light and the commencement of its stock is far below the average cost of its market, prices of these stocks often start early or makes up rises prices often appear in the variety; Second, shares are in record highs, but technical correction is more fully, chips have been big money master, from the urgency showing rapid cost regions, such as the early Wuliangye and the Xin'an shares so high is so.

如去年第三季度初期的阳之光，其启动时的股价远远低于其市场平均成本，这类个股往往是行情启动初期或者补涨行情中经常出现的品种；二是股价正处于历史新高，而且技术上盘整较为充分，筹码已经被大资金掌握，急拉后快速脱离成本区域，如前期的五粮液以及不断走高的新安股份等均是如此。

Compared with classical methods,the main advantage is as follows:raffinose oxidation time may be shortened within 60min;oxidation of hemoglobin can be controlled when the reaction temperature is 20℃;the proportion of MetHb can be controlled less than 5%;the ratio of raffinose to hemoglobin and the final concentration were dependent on the average molecular weight of HBOCs;at the same time,we can obtain HBOCs of different molecular weights.

与经典的方法相比，其主要优点为：高碘酸钠氧化棉籽糖的时间可缩短至60min即可达到完全氧化：在20℃时，便可控制血红蛋白的氧化，可将MetHb含量控制在5%以内；棉籽糖与血红蛋白的比例和血红蛋白的反应终浓度可根据所需要的目的聚合血红蛋白的平均分子量的大小来定；同时调整反应体系可以得到不同分子量大小的HBOCs。

In this paper we analysis nonstationary random signal by a special processing tune-varying autoregressive moving-average model.

本文采用一种经过特殊处理的时变自回归滑动平均模型对非平稳随机信号进行分析。

The problem about high bullets shoot aeroplanes is a very important realitic problem of military affairs .This essay ,using intellectual of probability ,inquires into how to dipose firepower when we use high bullets to shoot aeroplanes ,and gets two major interesting conclusions.First, we should use firepower equally when the percentage of hits of each bullet is the same.

摘要高射炮打飞机的问题是军事上的1个很重要的实际问题，本文作者利用概率统计知识对用高射炮打飞机时如何进行火力部署做1些探讨，并得到了两个主要结果：（1）各们炮的命中率相同时，应平均使用火力。

Firstly, based on the developed vibration testing method, a method for monitoring abrasion fault on main bearing of reciprocating engine using noise measurement is presented.

在比较几种传统方法后，提出了采用高速数字信号处理器DSP电路和插值算法来进行噪声信号的时域同步平均处理。克服了基于锁相环电路采样方法跟踪精度低、速度慢和使用不便的缺点。

The results show that the grain size is refined by the addition of Nd or Dy, especially combined addition is better than single addition.

结果表明：ZK10镁合金中分别加入Nd和Dy均能细化晶粒，且Nd和Dy同时加入的效果优于单一加入的效果，当同时加入质量分数为0.2% Nd和0.6% Dy时，合金的平均晶粒尺寸由原来的150 μm细化至60 μm，使ZK10合金的抗拉强度和屈服强度分别提高至191.0 MPa和69.0 MPa，伸长率达到16.6%，与未加入稀土的ZK10合金相比分别提高89%，43%和232%。

The results show that the grain size is refined by the addition of Nd or Dy, especially combined addition is better than single addition. With the addition of 0.2 % Nd and 0.6% Dy, the grain size is reduced from 150 μm to 60 μm. Combined addition with two rare earths elements makes the tensile strength, yield strength and elongation of ZK10 alloy increase to 191.0 MPa, 69.0 MPa, and 16.6%, increasing by 89%, 43%, 232% respectively, compared with ZK10 alloy without RE element.

结果表明：ZK10镁合金中分别加入Nd和Dy均能细化晶粒，且Nd和Dy同时加入的效果优于单一加入的效果，当同时加入质量分数为0.2% Nd和0.6% Dy时，合金的平均晶粒尺寸由原来的150 μm细化至60 μm，使ZK10合金的抗拉强度和屈服强度分别提高至191.0 MPa和69.0 MPa，伸长率达到16.6%，与未加入稀土的ZK10合金相比分别提高89%，43%和232%。

For the first time, we combined ultrasonic wave and time domain reflectometry to study the relationship between gas hydrate saturation and acoustic parameters in the process of gas hydrate formation and dissociation, and got fine results.

本文首次利用超声和时域反射联合探测技术，研究了沉积物中水合物饱和度与声学特性的关系，并对时间平均方程、伍德及其修正方程、李权重方程和BGTL（Biot-Gassmann Theory by Lee）理论等常用的水合物饱和度估算模型进行了验证。

Finally, analytical hourglass-shape fill patterns are inserted in each fill region. Experimental results show that the proposed algorithm can reduce the delay of net by 15% on average than the traditional algorithm.

实验结果表明，该算法在减少冗余金属填充对关键线网的时延影响方面比传统的填充算法平均减少15%。

The results show that dynamic softening is easy to occur in these ingots and flow stress becomes steady finally; the material constants of hot deformation are procedural parameters that stress-level coefficient α, strain rate sensibility exponent m and deformation activation energy Q are all increased with strain increasing, while stress exponent n is decreased gradually; the values α and m of the alloy homogenized are the biggest and the value n is the smallest, dynamic softening effect of the alloy is the most obvious, which can deform evenly; influence of strain on the value Q of the alloy homogenized is a little and the average value of Q is only 176.5kJ/mol, so the alloy is easy to deform; the alloy matrix shows the regular recrystallization grains when the strain is 50%; dislocation cell structure re-formed in the grains with increase of strain.

结果表明：经不同处理的Al-1Mn-1Mg合金均易发生动态软化并最终呈现稳态流变特征；热变形材料常数是过程量，随应变量的增加，应力水平参数α、应变速率敏感性指数m和热变形激活能 Q 随之增大，而应力指数 n 则逐渐减小；均匀化退火后，铝合金的α和m值最大而n值最小，动态软化效果最明显且变形均匀，在该状态下，铝合金的 Q 值受变形量影响小，平均仅为176.5kJ/mol，易进行热变形；当应变量为0.7时，基体呈现规则的再结晶晶粒组织，随着应变量的增加，晶内重新形成了位错胞结构。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新