平均密度

Here now figures of maximum, average and minimal sequential brust speedfor all the discs.They are thus 7200.10 the fastest with 60 to 61.8 M/S average and 74.9 to 76.3 M/S as peak:the 750 Gig diskhas better performance over the 500 Gig one dueto theuses of larger plates offering a greater density (187,5 Gig vs167 Gig).Western follows closely, and then come theMaxtor.

在这里，现在的数字最高，平均及最低限度的顺序brust速度为所有discs.they因而7200.10最快的60个达到6180米/秒，平均和74.9 ，以76.3米/秒，因为高峰： 750 gig的硬盘有更好的表现超过了500 gig的一个因使用较大的板提供了更大的密度（ 187，5 gig的比167 gig的）。

Here now figures of maximum, average and minimal sequential brust speedfor all the discs.They are thus 7200.10 the fastest with 60 to 61.8 M/S average and 74.9 to 76.3 M/S as peak:the 750 Gig diskhas better performance over the 500 Gig one dueto theuses of larger plates offering a greater density (187,5 Gig vs167 Gig).

现在这里的数字，1537平均最低时序brust速度为所有discs.they因而7200.10最快的有60至61.8米/秒，平均74.9至76.3米/秒的峰值为：750gig磁盘有更好的表现超过了500gig之一，由于用途大板，提供了更大的密度(187，5gigvs167gig)。

The effect of phase change temperature, heat fusion and thermal conductivity of the SSPCM on the average heat flux and energy storage ratio of the floor heating modular board was analyzed by simulation.

研究了定形相变材料的相变温度、相变潜热和导热系数变化对地板表面平均热流密度和蓄能比的影响；定形相变材料蓄能式采暖地板可在长时间内保持稳定的热流密度。

The is related to the frequency dependent absorption cross section and the density and spatial distribution of atoms in the lower level of the transition. Position dependent 5P3/2 state densities had been combined with the collisional broadening rate 5P3/2 5S1/2 line due to both helium and cesium perturbers to yield the .The effective radiative rates of the Rb D2 line as a function of the He pressure PHe were obtained . The fluorescence intensity I780 of the 5P3/2 5S1/2 emission was measured simultaneously.

由于辐射陷获存在，有效辐射率是自然辐射率与透射因子（发射的光子在探测区域内没有被吸收的平均概率，它与吸收截面及激发态原子密度和空间分布有关）的乘积。5P3/2原子密度及其空间分布结合5P3/2 5S1/2跃迁线的碰撞增宽计算了透射因子，从而得到了不同He气压下，Rb D2线的有效辐射率。

Compressor power consumption was greatly affected by inlet air relative humidity and wet-bulb temperature.

结果显示：冷凝温度和冷凝压力均随着入口空气湿球温度的升高而升高；入口空气相对湿度对压缩机功耗的影响与湿球温度对压缩机功耗的影响均比较大；对基于同一压缩系统的实验比较表明，在冷凝温度为38℃时，板式蒸发式冷凝器的热流密度比管式蒸发式冷凝器平均大30.5%；且在相同的冷凝温度下，入口空气湿球温度越低，板式蒸发式冷凝器的热流密度比管式蒸发式冷凝器大得越多。

After measurement and analysis of the interfering voltage, potential gradient, the point current density, the weight-loss increases with average current density, and the depth of penetration increases with the interfering voltage.

测量和分析了干扰电压、电位梯度、点电流密度、失重量及腐蚀坑深后，可以看出失重量随平均电流密度而增加，腐蚀坑深随干扰电压而加剧。

MAIN OUTCOME MEASURES: Comparisons of numeric density,surface density and average size of synaptic conjunction.

主要观察指标：各组大鼠突触数密度、面密度、突触连接带的平均面积比较。

Based on the famous -3/2 power rule, the equations were established on the relationship between density of stand and the mean diameter, mean basal area of individual and total basal area of stands in the process of the self-thinning of Pinus taiwanensis natural forest.

应用-3/2法则，建立黄山松天然林自然稀疏过程中林分密度与平均直径、平均木断面积、总断面积的相关关系。

Using quadratic orthogonal rotation design,this paper establisheda mathematical model of density change during self-thinning for Cunninghamia lanceolata plantation,and theinner law of density change during self-thinning for Cunninghamia lanceolata plantation were analyzed.

进一步应用数量化理论I分析杉木人工林自疏过程密度变化与环境因子间的相互关系，确定影响杉木林自疏过程密度变化的主要环境因子为海拔、坡位和林分平均胸径，从而为杉木林自疏机制的定量描述提供了依据。

There are several ways toobtain the DBHF self-energy from the G matrix used before, such as a simple method,where the Dirac structure of the nucleon self-energy is obtained from the momentumdependence of the single-particle energy, and a projection method.

在不同的不对称系数条件下，我们计算出的各密度处的核子平均结合能满足经验的抛物线规律，给出了密度依赖的不对称能。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。