干燥法

The correlation between the two different methods of perforator and desiccator to evaluate formaldehyde emission from MDF was studied here.

研究了MDF 甲醛释放量两种评价方法的关系，通过对不同测试条件下用干燥器法对MDF 甲醛释放量进行检测，其结果用穿孔法的检测结果进行对比和检验。

The formaldehyde emission from MDF was tested using the desiccator method under the different testing conditions. The results were compared and verified by the testing results using the perforator method.

研究了MDF甲醛释放量两种评价方法的关系，通过对不同测试条件下用干燥器法对MDF甲醛释放量进行检测，其结果用穿孔法的检测结果进行对比和检验。

The granule was prepared by mixing the water extracts, volatile oil and starch. The content of eucalyptol in the granule was determined with the GC method.ResultsThe optimum extraction condition was as follows: the crude drug was extracted with 10 times amount of water for 5 hours to collect the volatile oil.

方法采用水蒸气蒸馏法提取高良姜药材中的挥发油，设计L9（34）正交实验确定最佳挥发油包合工艺，将水提液浓缩干燥与包合物制成配方颗粒，采用气相色谱法，FID检测器测定配方颗粒中桉油精的含量。

A new analytical method, was presented to calculate the diameter and height of spray dryer in order to improve the tedious process of diagram integral method which must read the nomogram repeatedly and overcome the difficulty of diagram integral method which could not be programmed to calculate.

为了改进图解积分法要反复查列线图的繁琐过程及克服该法不能编程计算的困难，提出了计算喷雾干燥塔直径和高度的一种新方法——解析法。

The advantage and the making method of the vapor rustproof plastic film and its developing tendency were introduced.

而金属制品的防锈工艺方式是多种多样的，包括：涂层防护封存、干燥剂法、除氧封存法、惰性气体保护法、真空防护法、气相防锈技术等[1]。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

Under the optimum conditions, the lactobacillus bulgaricus microcapsule was madeby single agglomerate, and precipitated the wall with located in rapeseed oil with 50%ammonium sulfate solution; The preliminary micro-emulsion filtrated, then drawsome microcapsule from the micro-emulsion and progressing the second emul-sification, injecting a mixture with 3% CAP and 1.5% gelatin into the micro-emulsion,and keep the stirring speed 200r/min for 5 minutes, adjusting pH as 3.0 with aceticacid, then desiccating with the spray drier after 30 minutes. At last, got the prodtictof microcapsule powder.

通过最佳乳化条件制备的乳液，采用单凝聚法制备保加利亚乳酸杆菌微胶囊，用50％硫酸铵溶液，使菜籽油中的壁材CAP析出，形成初步的微胶囊，过滤，取上层微胶囊油液，缓慢注入3％CAP和1.5％明胶混合液中，进行第二次乳化，在200r／min的搅拌速度下乳化5min，用冰醋酸调节乳液的pH值至3.0，固化30min，取乳液置于喷雾干燥机中进行喷雾干燥。

The deficiency in traditional method for calculating heat transfer quantity in the wall of wood drying kiln was pointed out,and the heat transfer quantity in the wall of wood drying kiln was calculated by the shape factor method.

指出了木材干燥窑壳体传热量的传统计算方法中的不足，并利用形状因子法来分析计算木材干燥窑壳体的传热量。

After dryness, silica powder is put into chlorinated furnace in fluid bed and reacts with dried hydrogen chloride gas in the environment of 340℃ to form crude trichlorosilane. The crude trichlorosilane , through hydroscrubber and pipe bundle condenser to extract silicon tetrachloride in distillation column produces trichlorosilane gas out of the d istillation column , which can be made into the finished product of trichlorosilane by condensation .

硅粉经干燥后加入氯化沸腾炉，与通入炉中的干燥氯化氢气体在340o C进行反应，生成的粗三氯氢硅经湿法除尘器、列管冷凝器去蒸馏塔分离匹氯化硅，由蒸馏塔出来的三氯氢硅气体经冷凝，制得三氯氢硅成品。

SiO2 aerogel was prepared by using waterglass as the Si source, formamide as the catalyst and glycol as the drying chemical controlling additive via sol-gel method and ambient pressure drying.

以水玻璃为硅源，甲酰胺为催化剂，乙二醇为干燥控制化学添加剂，采用溶胶－凝胶法常压下干燥制备了硅石气凝胶粉体。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。