帧速率

The paper investigates both block-type pilot linear minimum mean square error algorithm and IEEE802.16 OFDM channel estimation analysis. Simulation results confirm the block-type pilot structure is more suitable for IEEE802.16 system. An optimal pilot setting algorithm, based on space frequency domain, is explored and the pilot chart is presented. The proposed algorithm finds its application in MIMO-OFDM. Simulation results show the algorithm presents a good approximation to the perfect channel state information curve, with about 2dB difference in SNR. The simulation results also demonstrate the algorithm achieves fairly high stability in the environment of fast fading, performance of the proposed algorithm is better that of pilot training channel estimation.3. Taking into account the characteristics of IEEE802.16 OFDM system, OFDM system simulation platform is constructed in Matlab, exploiting simulink as a tool. OFDM modulation and demodulation simulation system are configured on LabVIEW platform. All the system signal processing is simulated, including defining system parameters, designing modulation model, and verifying all the proposed algorithms under different environments, such as white Gaussian noise, multi-path fading, with or without guard interval etc. Bit error performance is evaluated. The research provides valid theoretical basis for practical OFDM system performance evaluation.4. Taking advantage of software radio, the paper designs a hardware platform with both 256-IFFT/FFT and 512-IFFT/FFT OFDM schemes co-existing in one platform. You can predetermine one from the two schemes to carry out almost the same model function with different system performance and parameter setting.5. Referring to IEEE802.16 standard, the paper proposes a design method for generating signals and frames suitable for laboratory investigations implemented in laboratory environment.6. Based on 6701evm digital evaluation card, combined with analogy front-end, the paper designs a DSP software model to deal with baseband signal processing. An overall OFDM scheme, with modulation and demodulation function, is accomplished.

讨论分析了MIMO-OFDM中一种基于空频域的最优导频设置算法，给出了导频图案，通过仿真实验表明，该算法与理想的信道状态信息曲线非常接近，信噪比差距约在2dB左右，并且在快衰落条件下具有较好的稳定性，其性能要优于基于前导训练的信道估计方法。3、根据IEEE802.16OFDM系统特点，论文分别在Matlab中应用Simulink工具构建OFDM系统仿真平台、在LabVIEW平台上实现了OFDM调制解调仿真系统，模拟了整个系统的信号流程，进行了OFDM仿真系统参数的选择和调制模块的仿真设计、论证各算法性能，并根据各种不同的条件：例如高斯噪声、多径衰落、有无保护间隔等，对系统的误码特性进行了评估，为正确评价实际OFDM系统的性能提供了有效的理论依据。4、论文以软件无线电思想作为指导，提出了以256点IFFT／FFT为核心和以512点IFFT／FFT为核心的两种OFDM算法模式并存于同一个硬件平台、且可预选的方案，它们在参数选取和性能指标上有所差异，均实现了相似的模块和功能。5、论文参考IEEE 802.16无线网络标准的参数设置，针对本设计系统的应用环境和系统硬件的性能速率，提出了一种应用于实验室环境的信号结构、帧格式等参数设计。6、论文基于TI公司的6701evm数字评估板卡，结合模拟前端搭建数字中频平台，设计了基带处理的DSP软件模块并进行系统调试，基本实现了一套完整的OFDM调制解调方案。

They were classified into four categories: DCT-to-HT coeffi-cients conversion,fast motion re-estimation and refinement,inter/intra coding mode decision and rate control.

在分析最新的视频编码标准H.264与以前的编码标准差异基础上，针对压缩域的H.264视频转码，系统地研究了其关键技术的进展，并按DCT到HT的系数变换、运动矢量快速重估计、修正和帧内/间编码模式和速率控制等4个方面进行了分类归纳，还对未来本领域值得研究的问题进行了展望和预测。

Rate control on picture layer actually allocates a target rate for current frame to be encoded.

在图像层首先在总体上对每帧图像的编码速率进行预分配，从而确定一个参考量化系数。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。