带状线

The methods of disturbance, spiral cylindrical cavity and stripline resonator were used respectively for measuring the permittivities for microwave dielectric substrates. The substrates are made from PTFE based fine ceramics, and errors of measurement have been analyzed.

采用微扰法、螺旋圆柱谐振法和带状线谐振法分别对聚四氟树脂复合精细电子陶瓷微波复合介质的复介电常数进行了测量与误差分析。

Firstly, it discusses the determination of the type of filter. Secondly,it introduces the development and design of stripline interdigital filter in details. Finallyit deals with the structure of the components and the switch corresponded.

首先是滤波器类型的选择，其次重点介绍了带状线终端短路交指型滤波的设计，最后完成组件开关设计以及与之配套的腔体的设计。

The asymmetric stripline is widely used in LTCC microwave integrated circuit system. Different kinds of discontinuity are often encountered in the circuit design, such as open circuits, steps, right-angle bends, T-junctions and so on. This paper successfully transplantes the equivalent circuit model of microstrip line discontinuity to the asymmetric stripline so as to deal with T-junction discontinuity and the branch-line coupler constructed by parts with various discontinuity. Compared with numerical results, the average error of S parameters is less than 2%.

偏心带状线广泛应用于LTCC微波集成电路系统中，其电路设计过程中也经常会遇到诸如开路端、阶梯、直角拐角及T型接头等各种不连续性问题；该文成功地将原有的微带线不连续性等效电路模型移植到偏心带状线上，从而分析了其T型接头不连续性和由其不连续性部分组成的电路组件分支线耦合器；与数值计算结果相比，其S参量的平均误差小于2%。

Disclosed is a leaky-wave dual polarized slot type antenna, including: first and second feeding circuit sections comprised of N-first strip lines and N-second strip lines with a loop every first period along the X-axis on the first dielectric layer and a second period along the Y-axis, in which the N-first strip lines and the N-second strip lines are parallel to each other being alternate, and each length of Ls1 and Ls2 for the first period satisfies the equation of , first and second multi-channel dividers formed at once and the other sides of the first dielectric layer, to connect the N-first strip lines and the N-second strip lines parallel with each other; and first and second central ports formed in the opposite direction of the cavity, each of the feeding circuit sections being connected to the first and second multi-channel dividers; and first and second slot sections being formed by patterning the second shielding layer, in which M-first and M-second slots are arrayed along the direction of the X-axis and each of the first and second slots forms N-row first and N-row second slot arrays, respectively, which cross the first and second strip lines for each, the first slot and the second slot being orthogonal to each other.

公开了一种漏泄波双偏振槽型天线，包括：第一和第二馈电回路部分，其具有沿着X轴在第一介电层每第一周期以及沿着Y轴的第二周期形成具有环路的N第一带状线和N第二带状线，其中N第一带状线和N第二带状线彼此平行并交替，并且对第一周期的各Ls1和Ls2的长度满足等式，第一和第二多通道分配器寻形成在第一介电层的一侧和另外一侧上，以连接彼此平行的N第一带状线和N第二带状线；以及形成在腔的相对方向中的第一和第二中心端口，每个馈电回路部分连接到第一和第二多通道分配器；以及第一和第二槽部分，所述第一和第二槽部分通过对第二屏蔽层形成模式而形成，其中M第一和M第二槽沿着X轴的方向安置，各第一和第二槽分别形成N行第一和N行第二槽阵列，其对每个横过第一和第二带状线，第一槽和第二槽彼此正交。

In the development of filter, adopting interdigital structure of stripline ,it is providewith higher rejection and has no autoeciousness band in very wide frequency.structureof debugging is added to reduce the affection of manufacture error improving the indexsignificantly.

滤波器设计中，采用带状线交指结构，带外抑制度高，并且在很宽的带内没有寄生通带；根据滤波器自身的结构特点加入了调试装置，用来补偿加工带来的误差，极大的改善了测试指标。

A multiplayer chip LC resonator was fabricated using planar inductor and parallel plate capacitor. Because lumped inductor has small Q value and there is stray parameter effect in high permittivity substrate, the Q value of chip LC resonator is not high. Resonators based on λ/4 stripline with end short circuited were designed and fabricated. Input and output pads, coupled to the stripline using gap-coupling capacitor, are in the same layer with the center conductive strip. This new structure is very convenient for manufacturing in comparison with the conventional structure.

采用间隙电容耦合结构实现的谐振频率为1.8GHz四分之一波长终端短路带状线单端口谐振器的Q值最大值为225，谐振频率为1GHz双端口谐振器的Q值为83，谐振频率和Q值与耦合间隙、带状线的厚度和耦合引线长度有关；二分之一波长带状线谐振器的Q值和四分之一波长相比较尺寸较大，由于导电带较长，造成金属的损耗增加，从而导致谐振器的Q值较低；带状线结构的谐振器频率调节困难，本文提出了改变接地端的宽度实现谐振频率的微调方法，可实现频率调节量约1.5%。

The main work and achievements are as following: 1 Proposed the approach to design the false high-passed broad band filter.

主要工作和成果如下：1、赝高通宽带带状线滤波器的设计。

The method includes dividing a digital image, formed from M rows and N columns of pixels, into a plurality of band-shaped areas by partitioning at each of a prescribed number of rows; averaging, for each column, the gradation values of pixels in said band-shaped areas for each of said plurality of band-shaped areas; computing an approximation line which approximates, in each of said plurality of band-shaped areas, a distribution of said average of gradation values; and judging whether there exists a succession of d columns at which the difference between said gradation value derived from said approximation line and said average of gradation values for each column exceeds a prescribed threshold.

该方法包括：通过以规定行数为单位进行分割，将由M行N列个像素形成的数字图像划分为多个带状区域；对于所述多个带状区域的每一个，针对各列来对所述带状区域中的像素的浓淡值求平均；计算近似线，该近似线在所述多个带状区域的每一个中近似于所述浓淡值的平均值的分布；并且判断是否存在如下连续的d个列，在所述连续的d个列中，从所述近似线得到的所述浓淡值与针对各列的所述浓淡值的平均值之间的差值超出一指定阈值。

The disclosed stripline resonator comprises two parallel metal ground plates 4, an inner conductor 5 between two plates 4, a metal short-circuit board 6 connected to with two ends of plate 4, and two coupling loops 7 on proper position of connected part of plate 4 and conductor 5 for input/output of microwave signal.

一种带状线谐振器及微波薄膜材料电磁参数测试装置，属于微波测试技术领域。带状线谐振器包括金属接地板4、内导体5、金属短路板6和耦合环7等四个部分，所述两块相互平行的金属接地板4的两端分别与金属断路板6连接，内导体5处于两块金属接地板4的中间，其中一块金属接地板4与内导体5相连的上下方的适当位置具有两个耦合环7，以实现微波信号的输入和输出。

The coil we use is ribbon wire, wound edgewise on a bobbin with heat-resistant adhesive.

我们使用的线圈是带状线，伤口上与耐热胶粘剂筒管曲方。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失