左分配的

In the process of moving from single-sustenance to double- sustenance, the angel of body tends to enlarge; in the process of moving from double-sustenance to single-sustenance, the angle of body tends to decrease; when the right leg is kicking on the ice, the center of gravity is just moved to the upper point of fulcrum, which means the center of gravity is vertical to fulcrum, while the left leg starts to kick on the ice when center of gravity completely surpass fulcrum; right knife touches the front ice of the supporting foot, the left knife touches the interior and front ice; small momentum variation coefficient and good effect of momentum move show the rationality of action and abundance of

单支撑阶段向双支撑阶段过渡过程中，躯干角度有增大趋势；右双支撑阶段向单支撑阶段过渡过程中，躯干角度有下降趋势；右腿蹬冰时重心刚好前移至支点的正上方，即重心与支点相垂直，而左腿则是在重心完全超越支点后一段时间才开始的蹬冰；右刀着冰向支撑脚前方下刀，左刀着冰向内侧前方跨出；动量变异系数小，动量转移效果好，反映了动作结构的合理性和能量利用的充分性；目前世界优秀运动员各环节的动量分配比例较以前均有较大幅度的提高；环节动量变异系数遵循着大环节动量变异系数小、小环节动量变异系数大的原则是较合理的。

The attentional and executive function were tested under the non-forced condition and the two attentional condition. Experiment 2 used tachistoscopic half visual field task under two dimensions of complex levels and three conditions (left or right visual field, or simultaneously in both visual hemifields) in order to test the function of an half hemisphere or interhemispheric coO p e r ation.

实验一：用两耳分听技术，分别测验大脑两半球在非注意条件时和注意条件时的注意分配与执行功能；实验二：用半视野速示术，分别测验在简单任务和复杂任务条件下，左、右视野单侧呈现和两视野同时呈现时，一侧半球加工和两半球同时加工的能力。

MATERIALS AND METHODS: Left and right bones of 8 pairs of human cadaveric tibiae were randomly assigned to either a group with conventional locked or a group with angular stable locked intramedullary nails.

材料与方法：8具人类尸体的左右侧胫骨被随机分配到常规治疗组和角稳定锁定髓内针组。

I was very pleased with that arrangement but once I got through allocating money, there was nothing left.

我对那个安排是非常喜悦的，但，一旦我通过分配金钱得到了，没什么左。

MAX1999EEI Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

MAX1999EEI引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S配对样本的支持下，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/遥测分比率为背景的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口的软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

TDA4864 Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

TDA4864引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S样本对支持，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/分比率背景遥测的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

The commutative theorem characterized by an associative ring, presented in document 1 noted by Guo Huaguang is extended to the formation of the left near ring with partition law.

把郭华光在文献［1］中关于结合环的交换性定理推广到分配生成左拟环上。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐