工作值

It will not only contribute to the understanding of the working principle of monostable ...

这有利于对单稳态触发器工作原理在本质上的理解，同时为无稳态触发器、多值单稳态触发器等的研究提供了理论依据。

The sensitivity,specificity,false positive rate,false negative rate and receiver operator characteristic area were e...

以培养结果作为金标准，应用受试者工作特征曲线确定iQ200和UF100各项参数的最佳临床判断界值，评价各项参数的灵敏度、特异度、假阳性率、假阴性率和ROC曲线下面积。

Von Neumann proposed that a problem be broken into discrete logical steps, much like the steps in a long division problem, and that intermediate values in the task be stored temporarily in the computer in such a way that those values could be considered input for the next portion of the problem.

冯诺依曼建议，将问题分解为分立的合乎逻辑的阶段，很像一个长期分离的问题，把工作中的中间值临时储存在计算机中，这样一来，那些数值可以被看成是为下一部分问题输入的数据。

Using the changing rate of maximum feed-rate as a threshold,the surface of the part is divided into different areas according to the values of normal curvature radius.Then the feed-rate is adjusted by constant velocities of cutter contact,thus the adaptive variation of feed-rate can be reached.An example is given to prove the ra...

以最大工作进给速度的变化比率为阈值，把零件表面的法曲率半径划分为不同的区域；在不同的曲率区域内，分别以恒定的刀触点速度对进给速度进行修正，修正后的进给速度随着零件表面曲率的变化而自适应变化；实例表明该方法具有合理性和有效性。

The P-V indicating diagram of compressor is a truthful record of working condition in the cylinder. According to the technique, the pressure signals collected from cylinder are normalized and treated as characteristic vector. And the vectors are inputted into a multi-class classifier composed of many support vector machines to identify fault modes.

压缩机P-V指示图是压缩机气缸部分工作状况的真实记录，该技术将采集的气缸压力信号经归一化处理后作为特征向量，输入到由多个支持向量机构造的多值分类器中进行故障模式分类。

Through above-mentioned work, experiment measures and skills of a series of parameters about the determination and nuclide migration are mastered.

通过以上实验工作，掌握了测定与核素迁移有关的一系列参数值的实验方法和技巧。

The results show that the mass density of disc galaxies increases an order of magnitude from the early-type disc galaxies to the later one, oblateness decreases to minimum at Sd,m, and then increases Having excepted SO and IrII, these parameters vary with the type of disc galaxies monotonicly.

早先得出早型盘星系的质量密度要比晚型高一个量级Ⅲ。这是因为所用的质量值是光度质量，早年得到的早型星系的质光比大于晚型星系一个量级。然而后来的工作发现盘星系的质光比大约为同一值嘲。后来有

Results show that the field amplitude and S parameter decrease with the oblique misalignment angle increase.

结果表明：随着倾斜偏心度的逐渐增大，倾斜偏心同轴波导的S21参数和电场的幅值减小，但减小的幅度不是很明显，不会影响同轴波导的正常工作。

According to the observation experiment at the Jiufeng station where there is smaller environment noise, the conclusions are drawn as follows.In the normal atmosphere, the observed value is about 500×10-5ms-2, which is greater than theoretical value about 30×10-5ms-2, and if in the low vacuum, the observational error about 2.3×10-5ms-2 is generated. The vacuum maintaining system in falling room can not work normally, which will yield 0.1~4.1×10-5ms-2 error to the gravimetric observation. In the case of that the measurement is in the stable geological conditions and the smaller environment noise, the action of vibration isolating spring is not obvious, but it yields greater effects on measurement accuracy.

通过在环境干扰较小的九峰站观测实验，得到如下结论：在正常大气压状态下所观测到的空气阻力影响约500×10-5ms-2，比理论估算值大近30×10-5ms-2，若在低真空状态测量空气阻力也将产生2.3×10-5ms-2观测误差；落体室真空度维持系统工作不正常，空气阻力也将对重力观测造成0.1~4.1×10-5ms-2的观测误差；在地质条件比较稳定，环境震动干扰较小的基墩上测量，隔震弹簧的作用对观测结果影响不明显，但对测量精度影响较大。

SY100EL11VZC Pinout: The output capacitor must meet the requirements for mini- mum capacitance and also maintain the appropriate ESR value of the full operating ambient temperature range to assure stability.

SY100EL11VZC引脚说明：输出电容必须满足小妈妈电容的要求，也是保持整个工作环境温度适当的ESR值范围内，以确保稳定。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。